苯乙烯

Waterborne antirust paint wasprepared using hulyl-aerylate/styrene/acrylonitrile(coded as BA/St/AN) latex ropolymer. The effects of the variety and amount of the antinist pigments and dispersant on the performance of the paint ana its coaling were investigated.

基于自制的丙烯酸丁酯/苯乙烯/丙烯腈共聚乳液，制备了一种性能优异的水性防锈涂料，研究了防锈颜料和润湿分散剂的种类、用量对涂料及其漆膜性能的影响。

The process of the invention mainly comprises disintegrating substrate material of waste printing wiring board into particle material whose particle size is 0.5-3.5 micron, the mixing with double bond reactant, adding with phenyl ethene, conducting reaction under gamma ray irradiation condition, modifying substrate material particles, then commixing material which is treated with acrylonitrile-butadiene-styrene, wherein the adding quantity of substrate material particle is 35%-35%, conducting extrusion pelleting for commixing material on a plastic extruder, wherein extruding temperature is 200-250 DEG C, and finally obtaining plasticity plastic particles with excellent property.

本发明方法主要是：先将废旧印刷线路板基板材料粉碎成为粒径为0.5～3.5微米的颗粒料，然后与具有双键的反应物混合，再加入苯乙烯，并在γ射线的辐照条件下进行反应，将基板材料颗粒进行改性处理。

The FT-IR results reveal that soybean oil and styrene were copolymerized.

主要工作如下： 1、本研究将豆油与苯乙烯进行自由基悬浮聚合。

FTIR spectroscopy confirmed that soybean oil and styrene had been copolymerized.

采用悬浮聚合法将豆油与苯乙烯进行自由基共聚，制备支化和部分交联的聚合材料。

Acrylamio-2-methyl propane sulfonic acid is applied in the production of water-based latex,which copolymerizes with acrylic acid,styrene or vinyl acetate to turn out latex resin.

2-丙烯酰胺基-2-甲基丙磺酸应用于水基性胶乳的生产过程中，与丙烯酸、苯乙烯或醋酸乙烯发生异分子聚合而生成胶乳树脂。

Strong alkaline PS resin is first turned to the form of Cu-CL complex ions, and then free and complex cyanides in effluent could be removed effectively through ion exchanger and co- mplexation, with a result of CN~- content in effluent.5mg/L and Cu~(2+)mg/L, which conform to the requirements of discharge regulations.

将通常的苯乙烯强碱树脂先转变成铜氯络离子形态，利用离子交换和络合反应可有效地去除废水中游离的和络合的氰化物，使处理后的废水中氰离子含量小于O.5mg/L，铜离子含量小于1mg/L，达到了排放要求。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

C for 2-3 hours;(2) fiber-grafted polymer preparation, mixing activated fiber material, phenylethene, acroleic acid, acrylic nitrile, acrylamide, potassium peroxodisulfate and water evenly, proceeding reaction at normal pressure and 50-60 Deg.

II。纤维素接枝聚合物材料的制备，将步骤I制备的活化纤维材料、苯乙烯、丙烯酸、丙烯腈、丙烯酰胺、过硫酸钾和水混合均匀，在常压、50～60℃聚合反应2～4小时，所得反应产物进行干燥。

Our company mainly styrene, acrylic acid series, acid, base, weak acid, weak base, catalysis, chelation, inert ion exchange resin, the key products used in softened water, desalination water exchange resins; Condensate Polishing resin; food fermentation industry, bleaching, adsorption resin, petroleum, chemical, medical, chelate resin series resin and catalyst as well as supporting a series of packing and other water brands, there are four series, more than 20 varieties of ion exchange resin.

我公司主要有苯乙烯系、丙烯酸系列，强酸、强碱、弱酸、弱碱、催化、螯合、惰性离子交换树脂，目前主要产品应用于软化水、除盐水处理交换树脂；凝结水精处理树脂；食品、发酵行业脱色、吸附专用树脂、石油、化工、医学、鳌合系列树脂和催化剂专用树脂以及配套水处理的系列填料等多种牌号，目前有四大系列、二十余个品种离子交换树脂产品。

Shanghai exchange resin resin plant special enterprises in China are domestic professional research and development, application, management services, OEM resin enterprise as a whole.major enterprises in China have Styrene, acrylic acid series, strong acid, strong base, weak acid, weak base, chelating , inert ion exchange resins, special enterprises in China for many years with several well-known enterprises to explore the application of ion exchange resins, the key products used in softened water, desalination water treatment-exchange resins; condensate treatment resin; food, fermentation industry Decoloration, dedicated Absorption resin, petroleum, chemical, medical, chelate resin and catalyst series dedicated resin as well as ancillary treatment, such as a series of packing products, such as a variety of grades.

上海汇脂树脂厂特华企业是国内专业研究开发、应用、管理服务、OEM为一体树脂企业。特华企业主要有苯乙烯系、丙烯酸系列，强酸、强碱、弱酸、弱碱、螯合、惰性离子交换树脂，特华企业多年来与多家著名企业探讨离子交换树脂应用，目前主要产品应用于软化水、除盐水处理交换树脂；凝结水精处理树脂；食品、发酵行业脱色、吸附专用树脂、石油、化工、医学、鳌合系列树脂和催化剂专用树脂以及配套水处理的系列填料等多种牌号等系列产品。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。