节气门

Secondly, the flow characteristic of the intake system of pre-mixed spark ignition gas engine was studied on the vacuum pump. The discharge coefficient models of the air valve, the gas valve and the subsystem of the mixer and throttle were modeled. Their working flow characteristics were analyzed. And the dynamic model of the intake system was identified.

其次，在真空泵流量实验台上完成了预混点燃式气体燃料发动机进气系统的流量特性研究，建立了空气阀、燃气阀及"混合器+节气门"子系统的流量系数模型并分析了其工作流量特性；建立了发动机外围进气系统的动态模型。

Our company is a modern one whose specially is to fabricate series products for automobile, such as ROCKER ARM, ROCKER SHAFT, CLUTCH LEVER, CLUTCH FORK, KING PIN KIT and etc.

我公司专业制造汽车发动机气门摇臂、摇臂轴、离合器分离杆、离合器拨叉、转向节主销等系列产品的现代化企业。

Production companies piston pin, rocker arm valve shaft, insert, Valve Ting-chu, to the main section, and other top-five selling products, nearly 300 various types of aircraft.

公司生产活塞销、气门摇臂轴、镶块、气门挺柱、转向节主销等五大类产品，近300多种机型。

First of all, the principle of the traditional throttle pedal is driven by cable-driven throttle to control engine power output, the current most advanced vehicles have been imported electronic throttle, its principle is based on servo motor control section of valve switching point of view, but the two operators who encounter the accelerator pedal stuck failure, life-saving methods should be the same, unless the electronic throttle with automatic reset power design, special or adapted vehicles is another matter.

首先，传统油门的原理是藉由脚踏板拉动钢索驱动节气门，藉以控制引擎动力输出，目前的高级车种大多已导入电子式节气门，其原理是以伺服马达控制节汽门开关角度，但两者如遭遇油门踏板卡死失效，救命的方法应该是一样的，除非电子式节气门有断电自动复位设计，特殊或改装车种则另当别论。

Then take a gas valve, one end of the umbrella, uniform marking with 1151 integrative Valve Manifolds chalk diagram, plug it back in gas valve seat, and gently turn the throttle.

然后取一支气阀门，在伞面一端，用粉笔图匀记号，插回气阀门的位子，并轻轻转动节气门。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。