色饱和

The aliquot was determined and confirmed by gas chromatography-negative chemical ionization mass spectrometry using external standard method.

样品中三唑醇残留物由正己烷饱和的乙腈(含1%冰醋酸)提取，加入无水硫酸镁与无水醋酸钠振荡促使提取液分层后进行固相分散萃取净化，用气相色谱-负化学离子源质谱法进行测定与确证，外标法定量。

Based on GC and GC-MS analyses, the geochemical characteristics of these typical deep viscous oils are listed as follows:(1) strong preference of even n-alkanes over odd n-alkanes;(2) strong preference of phytane over pristane, i. e. Pr/Ph ratio＜＜1;(3) high abundance of gammacerane relative to C〓hopanes;(4) much more amounts of C〓 pentakishomohopanes than C〓 tetrakishomohopanes and even C〓 trishomohopanes.

罗家—垦西地区稠油饱和烃色谱、色谱-质谱分析结果展示：(1)正构烷烃具有明显的偶奇优势；(2)类异戊二烯烷烃具有较强的植烷优势，姥姣烷/植烷比值远小于1；(3)伽玛蜡烷相对含量(相对于C30藿烷)普遍很高；(4)C35升藿烷明显高于C34、甚至C33升藿烷；表现出膏盐湖相生物标志物的组成特征。

Low-frequency covibration experiments of four kinds of fluid-saturated feldspar sandstones which have different viscosity coefficients respectively were conducted so as to know how fluid viscosity coefficient influences attenuation, modulus and velocity dispersion in fluid-saturated sandstone.

为了探讨孔隙流体的黏滞系数对饱和砂岩的衰减、模量和速度色散的影响，本文进行了四种不同黏滞系数的饱和长石砂岩的低频共振实验，结果发现在0.01～10Hz频带范围内，无论是衰减温度话还是衰减频率谱，都显示出衰减随黏滞系数的增大成良好的线性增长关系，黏滞系数越大楼量越大；同时还具有明显的模量与速度色激，而且随着黏滞系数的增大，模量与速度色权有增强的趋势。

It was suggested that only if the protein is just eluted with a isocratic model.

提出了在等浓度条件下洗脱条件蛋白能够在色谱柱保留时的饱和吸附量为其有效吸附量，在这种条件下的流动相的组成，才是研究溶质饱和吸附量的合适组成。

Through a variety of resin filter, adsorption and elution conditions for the optimization, as well as decolorization, crystallization methods of research, this article eventually determine the strong acid cation resin HZ-001 which is at pH 3, 3BV / h, having the largest adsorption to the tryptophan; the fermentation broth were centrifuged to remove sediment,then treated with activated carbon to be decolored and then treated with strong acid cation resin HZ-001. After that,2mol/l amino acid were passed through the HZ-001 ion exchanging column,kept almost constants when the flow rate stayed 6 BV / h. At 60℃,it was condensed into the saturated state and then added Ethanol until its percentage reaching 30%. At 4 ℃ under 100rpm placed in the shaker 20h, the collection of L-tryptophan was dried up in vacuo.

本文通过对种树脂的筛选、吸附和洗脱条件的优化，以及对脱色、结晶方法的研究与摸索，最终确定强酸型阳离子树脂HZ-001在pH=3，3倍床体积流速，温度室温，对色氨酸有最大的吸附作用；将发酵液离心去沉淀并用活性炭脱色后通过HZ-001强酸型阳离子交换树脂柱，再用2mol/L的氨水6倍床体积流速在室温下进行洗脱，收集洗脱液，60℃浓缩为过饱和状态后加入30%无水乙醇，4℃下100rpm摇起晶20h，过滤搜集结晶并真空干燥得白色粉片状L-色氨酸晶体。

Saturation occurs then pixels in bright areas are overexposed causing them to turn completely white.

发生色饱和后，像素在明亮区域感光过度使其出现完全一片白色。

In order to analyze the thermal cracking products of fuels, we set up a GC analytical system. The gas products, which comprise methane, ethane, ethylene, propane, propylene and other gases, were collected and analyzed by gas chromatography provided with a flame ionization detector . We calculate the theoretical heat sink of n-heptane at the temperature of 600℃ and 800℃. The theoretical heat sink calculation of iso-octane at 700℃ is also related.

建立了用于分析裂解产物的气相色谱分析系统，解决了本研究中对气态裂解产物的分析要求，特别是气态小分子饱和烃和不饱和烃的有效分离；并根据裂解产物的组成及其生成热数据，对正庚烷在600℃和800℃，异辛烷在700℃时裂解的热沉进行了理论计算。

The analysis on fatty acid,alcohol and ketone of oil with GC-MS method indicates that the alkyl acids,especially those with linear and saturated alkyl acids,are dominant in the newly generated acids.

采用气相色谱-质谱方法，对油样提取物中微生物产生的酸、醇、酮等物质进行了分析研究，两株菌产酸以饱和烷基酸为主，尤其以直链饱和烷基酸居多，同时也生成一定量的环烷、烯基酸和少量的芳基酸。

The fatty acids composition in the Pine seed oil were determined by means of gas chromatography and gas chromatography -mass spectrometry. The unsaturated fatty acids amounted to 90% of total fatty acids, in which 62% is essential to human health.

用气相色谱及气相色谱-质谱连用技术分析了红松仁油的脂肪酸组成，结果表明：不饱和脂肪酸的相对含量为90％，其中人体必需脂肪酸占62％左右。

You will be able to work with saturated steam when printing reactive dyes and acids, superheated steam when printing with disperse and to fix by hot air the pigments.

活性染料和酸性染料印花时可以采用饱和蒸汽汽蒸固色，分散染料印花可以采用过热蒸汽固色，涂料印花时进行热风固色。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。