致密的

E and TUNEL Besides,early apoptotic cells which were densely green yellowstained or displaying green yellow fragments,late apoptotic cells which were densely cardinal redstained or displaying cardinal red fragments, and cardinal red swollen necrotic cells could be found in the AO/EB doubly stained cells.

AO/EB双染色法还能够显示呈致密浓染的黄绿色染色或出现黄绿色碎片的早期凋亡细胞，呈致密浓染的鲜红色染色或出现鲜红色碎片的晚期凋亡细胞，以及呈鲜红色膨大状的坏死细胞。

By the use of the component sandstone electric conductivity model, the effect of the pore structure characteristic parameter to cementation exponent m and saturation exponent n in the Archie formula were studied. It can be found the cementation exponent m mainly reflects the pore space size and its sizes distribution. The m is bigger, the pore space is bigger, the throat is simpler, and the reservoir is better.

通过致密砂岩电导模型分析研究致密砂岩孔隙结构特征参数对Archie公式中的胶结指数m和饱和度指数n的影响，发现岩石胶结指数m主要是岩石孔隙空间大小及其大小分布的表征，m值越大的岩石其孔隙储集空间越大，孔喉越简单，储集性能越好；反之，m值越小，岩石储集性能越差。

Mitochondria was relatively little in size. Round primary lysosome with high electron-densed granules and secondary lysosome with high or low electron-densed granules were seen frequently. DCs contained many rough endoplasmic reticulum, the Golgi apparatus and ribosomes. The vacuoles with flocculent electron-densed granules were rare. Some special granules in cytoplasm were seen, whose surface like earphone were covered with a membrane. High electron-densed contents in the granules were near one side and the other side was bright. The nucleus became markedly small in volume, nephroid or hoofed in shape. The nucleus had little euchromatin and lots of heterochromatin under nuclear membrane.

子宫内膜癌组织DC超微结构特征如下：细胞形态不规则，与正常子宫内膜组织DC相比，胞膜较光滑，胞膜表面树突状胞浆突起显著减少，部分突起呈粗短状；胞质中线粒体相对少，圆形而电子密度高的初级溶酶体和不规则形且电子密度高低不一的次级溶酶体多见；高尔基体、粗面内质网、核糖体丰富；含微量絮状电子致密物的胞饮小泡显著减少；胞质中可见形态特殊的颗粒，该颗粒外周膜包裹，略呈圆形，中间部位稍弯曲，如耳机状，颗粒中由高电子致密物居于一侧，而另一侧则呈透亮状；胞核显著减小，居于胞质一侧，常呈肾形或马蹄形，核内常染色质较少，异染色质多边集于核膜下。

Firstly, it is difficult to densify CeO2 based solid electrolyte materials and a sintering temperature above 1600℃is required to prepare dense CeO2 based solid electrolyte materials by the conventional solid-state reaction method;Secondly, doped ceria are brittle materials and have weak mechanical strength, which would be susceptible to fracture due to thermal stresses and mechanical stresses during cell fabrication and operation; Thirdly, electronic conduction will be introduced because of the reduction of Ce4+ under low oxygen partial pressure, which would reduce the output voltage and output power of the cells.

其一，CeO_2基电解质材料难以致密化，用常规的固态反应法制备的CeO_2基电解质粉体需要在1600℃以上烧结才能达到致密化；其二，CeO_2基电解质为脆性材料，机械强度低，使其容易在电池的制造及运行过程中由于热应力及机械应力而破裂；其三，CeO_2基电解质在燃料极一侧由于Ce4+还原为Ce3+出现电子导电，降低电池的输出电压和输出功率，影响电池的性能。

You see real ascension requires the unification of light and dark, and the transmutation of density within one's own field; and not pressing the density on to another and believing it somehow has disappeared and because this is so, one is transmuting one's own darkness.

你们可以看到，真正的提升是需要统一光明与黑暗并将自身能量场中的致密转化的，而不是将这些致密推到别人身上，认为它在某种程度上已经消失并因为这样，认为你正改变自己的黑暗。

You see real ascension requires the unification of light and dark, and the transmutation of density within one's own field; and not pressing the density on to another and believing it somehow has disappeared and because this is so, one is transmuting one's own darkness.

你们可以看到，真正的提升是需要统一光明与黑暗并将自身能量场中的致密转化的，而不是将这些致密推到别人身上，认为它在某种程度上已经消失，而且因为这样而认为你正在改变自己的黑暗。

The results show that high energy ball milling refines and homogenizes the mixed powders, accelerates the sintering process, and with the increase of milling time, the grain is finer and the alloy is denser. HIP and forging is beneficial to decrease or remove the pole formed during the sinter course, and as the last process, forging breaks the junctions between TiC particles, the microstructure and mechanical properties of alloy are improved.

研究结果表明：高能球磨使粉末细化和成分均匀化，促进烧结进程，随球磨时间的延长，合金组织细化且致密；热等静压和锻造工艺可进一步减小和消除合金中烧结后残留的孔洞等缺陷；锻造作为最后工艺，可使TiC颗粒之间的连接破碎，促使硬质相颗粒弥散分布，从而改善烧结组织，提高合金的致密性及力学性能。

As a result, some ideas about the fabrication are put forward.The EPMA experiment results show that the main element such as W, Mo, Ti, Ni, Cu, Fe element are changed gradually in W-Mo and W-Mo-Ti FGM. In the layer rich in W, the grain are intervained and are mixed mechanismly. The same is to the layer rich in Mo and W-Mo. These grain felt up by some sinter. In Mo-Ti layer rich in Mo, the grains are also mixed mechanismly. Ni, Cu, Fe element assembled at interface. Ni melt by Cu plays an vital role in sinter effect. The microstructure characteristics result show that the compactness of W-Mo and W-Mo-Ti FGM is good.

电子探针实验结果表明W-Mo系、W-Mo-Ti系梯度功能材料中主要元素W、Mo、Ti、Ni、Fe、Cu分布整体上具有梯度变化规律，发现富W区、富Mo区、W-Mo混合区中颗粒交错分布，基本上以机械混合的形式存在，颗粒之间主要靠烧结剂的粘结作用实现致密化；以Mo为主要组分的Mo-Ti混合区，也是以机械混合的形式存在；Cu溶解于Ni形成固溶体更好地起到活化烧结能力，Ni、Cu、Fe在宏观层间界面富集，有利于烧结致密化。

Water locking damage happens widely in tight sand gas reservoirs with low permeability, and is one of the main damage types for tight sand gas reservoirs with low permeability, which influences the results of oil/gas reservoir exploration and exploitation severely.

水锁损害广泛存在于低渗透致密砂岩油气藏，是低渗透致密砂岩油气藏的主要损害类型之一，这严重地影响着油气藏的勘探开发效果。

At 300~500 ℃ the oxidation weight gain increased 0.32%~0.34%,at 1100 ℃ the oxidation weight gain increased 15%.By SEM observation,surfaces of pure titanium after oxidating have different morphologies.

用JSM-6360LV型扫描电子显微镜观察试样表面形貌，300~500℃氧化钛膜很薄较致密；700℃试样表面有较多的蜂窝氧化膜，表面不致密；900℃形成片状和长条状TiO2；1100℃氧化层为厚大板片状和多棱柱状的TiO2。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。