膨胀室

Oil in the oil chamber can be regulated by expansion or contraction of capsule of air chamber.

油室中的油量可由构成气室的胶囊的膨胀或收缩来调节。

Based on the item of national high technology development project, the thesis studies the reasonable construction pattern of the tunnel portal, incidence of the micro-pressure wave and the the effect of bell-mouthed hood, lacunaris hood and expansile hood on alleviating the micro-pressure wave in the situations of single line and double line, obtains the relationship between the max micro-pressure wave and the velocity of the train as well as the relationship between the max micro-pressure wave and distance of measuring point at the velocity of 100km/h-550km/h, compares the different alleviative effect of the three different hood to max micro-pressure wave and finally proposes the reasonable construction pattern of the tunnel portal.

本文针对国家高技术研究发展计划(863计划)课题"磁浮交通沪杭线越黄浦江隧道的工程技术问题研究"，在单洞单线和单洞双线两种工况下，对隧道洞口的合理结构形式和影响范围，以及洞口喇叭形入口缓冲段、多孔壁入口缓冲段以及隧道出口膨胀室对减缓微压波的作用进行了研究，得到了磁浮列车速度在100km/h～550km/h时隧道出口微压波最大值与速度的关系以及微压波最大值与测点距离的关系，比较了三种不同形式缓冲结构对微压波最大值的减缓效果，提出了隧道洞口的合理结构形式。

It also allows you to benefit from the expansive energy within the room.

你还可以从能量的膨胀室。

The experimental results show that the mean particle size of griseofulvin precipitated by RESS is smaller than 1, 0μm, narrow distribution and 95％ fine particles is smaller than 1. 0μm. Increase of the pre-expansion pressure, the extraction temperature, the expansion chamber temperature, the spraying distance, the concentration of cosolvent and decrease of the nozzle diameter resulted in decrease of the particle size under the operating condition studied. Enhancement of the pre-expansion temperature resulted in increase of the particles size. The SEM of GF shows that the shape of original is atactic and a wide size distribution, but the microparticles obtained by RESS is reverse. Similar melting points and XRD patterns were observed for the original material and the precipitates obtained by RESS.

实验结果表明，用含夹带剂的RESS法制备的灰黄霉素微粒的平均直径在1μm左右，且分布均匀，95％微粒在1μm以下，仅用CO〓作为超临界流体制备的微粒与上述方法制备的微粒的平均直径和分布相似，只是产量太低，而用机械法制备的微粒平均直径在3μm左右且分布较宽；不同的过程参数对沉析微粒尺寸有不同的影响，预膨胀压力、膨胀室温度、溶解温度以及夹带剂浓度的提高或增大，均可使沉析微粒的直径变小；预膨胀温度提高，所得微粒的直径变大；喷射距离的增加，沉析微粒的直径变小；喷嘴直径越小，由此制得的微粒的直径就越小；根据实验结果还可知道，通过理论计算的马赫盘处微粒的直径可以较好地估计出膨胀室中收集到的微粒的直径。

Leaf anatomy:non-Kranz; microhairs slender (apical cell short and inflated in Hygroryza ); fusoid cells present or absent.

叶解剖学：非克兰兹； microhairs纤细的(顶端的室短和在Hygroryza里膨胀)； fusoid室宿存或无。

Manufactured from platinum and rhodium embedded in a stainless steel honeycomb, the catalyser is situated in the silencer's first expansion chamber, while the oxygen sensor is located between the EXUP valve and silencer.

制造铂和铑的嵌入式在一个不锈钢蜂窝， catalyser是坐落在该消声器的第一膨胀室，而氧传感器是位于之间的exup阀和消声器。

Expansion chamber is 3 x's the port size for tremendous water removal efficiency.

膨胀室为3 x的了巨大的去水效率的港口规模。

Designed with an oversized expansion chamber, the UDL Series offers one of the best water removal efficiencies for drip legs on the market today.

一个超大膨胀室设计，在UDL系列提供最佳的水市场上的吊脚去除率之一。

The article introduces structure and design characteristics of Water Chamber Shell and expansion joint for 300MW and 600MW High Pressure Heater,and the way of drawing for the three-dimensional bottom shell of water chamber.

某公司设计制造的300MW、600MW机组高压加热器的水室包壳及膨胀节的结构、设计特点，及水室下部包壳的三维画法。

An exhaust passage (54) passes through the coolant chamber and communicates with an exhaust expansion chamber (67) formed by an extension case (4) to be positioned below the mounting case.

排气通道(54)穿过冷却剂室，并与由延伸壳体(4)形成的排气膨胀室(67)连通，该延伸壳体位于支撑壳体下面。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。