膜的

On the basis of molecular design, urushiol and tyrosine, with unique chemical structure, were selected as units to fabricate five kinds of stable and functional multilayer films via layer-by-layer self-assembly method.

本论文在对自组装膜的发展历史、自组装技术进行综述的基础上，从分子设计的思想出发，选用具有独特结构和性能的功能分子——漆酚和酪氨酸作为组装基元，以层层自组装技术制备了五种新型的，具有高稳定性的功能多层膜。

Liquid oils or finish in the finishing process, between about viscosimetry, 0.03－0.07pa.s, liquid varnish coating in the packaging business card printing and membership card making products surface, at the start of the wet-membrane "" viscosimetry is very low, and to become a good mechanical properties "" dry film, that is, when the oil or oil "" all dry stage, at least to achieve here 10Mpa.s viscosimetry.

液体底油或上光油在整饰加工中，粘度约在0.03－0.07pa.s之间，因此，液体光油涂布在包装制卡和会员卡制作制品表面后，开始时的"湿膜"的粘度是很低的，而要成为具有一定机械性能的"干膜"时，即常说的底油或面油的"全干"阶段时，这里粘度至少要达到10Mpa.s以上。

The findings demonstrated that tTG is present in PVR epiretinal membranes and cultured human RPE cells. Its amount is stimulated to increase by the PVR vitreous humor. tTG takes part in the process of PVR. It may play an important role in the formation of PVR membranes.

PVR视网膜前膜和培养的人RPE细胞tTG表达阳性，在PVR患者的玻璃体液作用下，RPE细胞的tTG表达水平升高，表明tTG参与了PVR的发病过程，在PVR视网膜前膜的形成过程中可能有重要作用。

The experimental results indicated that with the addition of 3% oleic acid, the tensile strength as well as the elongation rate of zein film are respectively improved by 30% and 20 times, and the film changes with a reduced water absorption of 2 times, an improved flexibility, and a surface structure with more excellent glossiness and integrity.

本实验中添加3％的油酸，可使膜的抗拉强度提高30％、断裂伸长率提高20％、吸水率下降到10％以下，膜的性能优良，光滑平整，具备了生物可降解材料应有的特性，有着良好的应用前景。

The results show that the hydrophilicity of PLA film is improved by introduction amido: the contact angle decreases from 78° to 56° and the free energy increases from 42.7mJ/m^2 to 51.4mJ/m^2. Compared with the control, osteoblast spread out more filopodia after 3 d incubation on amidation surface, and it entered cell division phase more quickly, which indicated that the surface amidation could promote the cell's adhesion and proliferation on the PLA film.

结果表明，酰胺基的引入改善了PLA膜的表面亲水性，其表面水接触角由78°减少到56°，自由能由42.7mJ/平方公尺增大到51.4mJ/平方公尺；与对照组相比，成骨细胞在改性表面培养3d后有大量的丝状伪足伸出，并且较快地进入了细胞分裂期，表明PLA膜表面的酰胺化能够促进细胞的黏附和增殖。

The introduction of amido groups can efficiently increase the water swellability of polyvinyl alcohol film and simultaneously enhance the adsorbability of the film to heavy metal ions.

胺基的引入有效的增强了聚乙烯醇膜的水溶胀性，同时使得膜对重金属离子的吸附能力有很大的提高。

For D-fructose functionalized BOPP, three parameters including irradiation time, cerous concentration and hydrogen ion concentration all have positive effect on monosaccharide immobilization.

水接触角数据也揭示了酮糖和醛糖在改性效果方面的差异，酮糖改性的BOPP膜的表面水接触角在47°左右，而醛糖改性的BOPP膜的表面水接触角为60°。

Sand or artificial pearl nuclear in a Pinctada martensl, a shellfish, with overlapping accumulation of the excretive protein film from cells in the inner shell theca and the conjunctiva layer of calcium carbonate.

南珠的形成：南珠是珍珠贝科动物中马氏珍珠贝受刺激物刺激后，外套膜的部分细胞所分泌的壳角蛋白膜和碳酸钙的结薄层交互重叠，围绕着刺激物沉积而成的圆形或其他形状的物体。

The tests of physical properties revealed that plasticizers could make great effects on chitosan/glutin composite films.

结果表明：增塑剂的加入对膜的物理性能产生了显著的影响，三种增塑剂都使膜的拉伸强度和吸水性降低、断裂伸长率和透水气率增大，但不同的增塑剂对断裂伸长率的影响表现出较大不同。

The contact angles of water and hexadecane on the resulting ultra thin film were measured so as to investigate the hydrophobic hydrophilic properties of the film.

结果表明：所制备的自组装膜的表面自由能很低，具有很好的疏水-疏油性，其对水的接触角高达 1 1 0°；二甲基-γ-全氟辛酰氧丙基硅烷组装膜可以降低基片的摩擦系数，而且在较低负荷下具有很好的耐磨性

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。