膜层

Face on the first glass prism element. The interference filter is formed by depositingtwo prism elements are joined together.

这个滤光片是在两个棱镜连接前由第二棱镜一面镀SiO2/TiO2复合层膜构成。

We present the idea of using a buffer layer of deviation from stoichiometry for materials growth on large lattice mismatch substrates. This idea was realized in nitrides growth in this thesis.

首次提出了采用偏离化学计量比的缓冲层在大晶格失配的衬底上生长单晶膜的思想，并在GaN外延生长上得以实现。

Multilayer dielectric thin film reflector for spectrum reshaping of chirped pulse la ser in Nd :glass chirped pulse amplification system.

用于钕玻璃啁啾脉冲放大系统光谱整形的多层介质膜反射镜。

By low temperature (145K) deposition method, we prepared such flat Pb films on the Si (111) substrate over a wide thickness range (from 10ML to 32ML). The unique growth behaviors were investigated by RHEED, STM and ARPES. A critical thickness of 10ML is established, at which the atomically flat Pb films become stable at room temperature. Between 10ML and 20ML, the growth exhibits a quasi bi-layer growth mode. Above 21ML, a layer-by-layer growth mode was observed.

采用低温生长的方法（衬底温度145K），通过对生长条件的优化，我们在Si（111）衬底上制备出了具有原子级平整度的Pb 薄膜，用STM 和ARPES确定了其特殊的生长模式：室温下成膜的临界厚度是10ML，随后是一种双层生长模式，覆盖度高于21ML 时，薄膜生长基本上是层状生长的模式。

The key part of this method is to directly spray well-mixed suspension of metal oxides instead of pre-synthesized ceramic powders on the anode substrate in order to make the membrane dense and form the pure ceramic phase at the same time.

通过直接将金属氧化物混合然后沉积到阳极基底表面，利用金属氧化物在高温烧结时发生反应，使质子陶瓷膜电解质层的成相与致密在一步烧结过程中完成。

Results:Compared with the normal controls, manifestations of severe right heart failure,well-elevated pulmonary arterial pressure and serious right heart hypertrophywere observed in the pulmonary hypertensive rats 28 days after left lungresection and MCT injection.

结果：与对照组相比，MCT 注射后28 天大鼠出现重度右心衰竭征象，平均肺动脉压、右室肥厚度均明显升高；镜下可见明显肺血管重构，表现为右肺纤维化、肺小动脉内皮和中膜平滑肌层增生、血管密度降低；肺组织中HGF、eNOS 表达明显减少、TGF-β和ET-1 显著升高(P0.05)，这些细胞因子表达量的改变与肺血管重构存在着明显的相关性。

A conventional two-circle diffraction system is set up. The work includes the design of light route, the establishment of control system for step motor and data collection, and the adjustment of the facility. A number of multilayers are measured using the diffractometer and a lot of useful experimental data are obtained.

作者在一台12KW转靶X光机的基础上，从光路设计到步进马达、数据采集等一套控制系统的建立，搭置了一台二圆衍射系统，并利用它做了大量的多层膜样品测量工作，并取得了一批有用的实验数据。

The results show that the film growth conditions strongly affect the mechanical properties of the Ti-O layers on top of the TiN-covered Ti substrates.For example,the TiN/Ti-O composite films display excelle...

结果表明，在钛合金表面制备TiN薄膜后，逐渐降低N2流量至0 sccm，沉积一层Ti膜，再用逐渐通入O2制备Ti-O薄膜的工艺制备的TiN/Ti-N/Ti/Ti-O薄膜具有较好的力学性能。

In control group,Ⅰ tail current density of Epi myocytes was 49.1% bigger than that of Mid myocytes, in operation group, which is 77.6%.Ⅰ tail current density had no significant difference among three layers in two groups.

对照组外膜细胞的Ⅰ(下标 Ks尾电流密度较中层细胞大49.1%，而手术组为77.6%；两组三层细胞之间Ⅰ(下标 Kr尾电流密度均无差别。

Business card printing and membership card making products go through after the surface light cover a layer mask.

制卡和会员卡制作品经过上光后在表面罩上一层亮膜。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。