膜层

Results : After intervention of MRS, the treated group;the structure of free villi was clear, intra-axial capillary was not congistid, vascular wall was intact, villi area and intervillous space area compared with control group, the difference was significant(p.01).interspace area was smaller than blank group, but without significance.

结果：经黄芪丹参复方成分干预后，治疗组游离绒毛结构清晰，中轴内毛细血管未见充血，管壁较完整，绒毛面积及绒毛间隙面积与模型组相比，差异显著(P.01)，间隙面积比空白组略小，但无统计学意义；底蜕膜层结构清晰，血管数目较多。

The amount of CdS compounded in TiO 2, number of films and heating treatment system effect on methylic orange photocatalytic decompositionare studied by spectrophotometer and TP 77 laser elliptical polarization meter.

利用紫外可见光分光光度计、激光椭圆偏振光测厚仪等仪器研究了CdS复合量、涂膜层数以及热处理温度对甲基橙光催化降解的影响。

This research is of important significance on analyzing film growth microscopically.

此研究对于从微观分析膜层生长有重要意义。

Estrogen was reported to upregulate Cx43 expression in rat uterine myometrium; however, the mechanism remains unclear.

有报导指出雌激素可增加子宫肌膜层的Cx43表现，但作用机制仍不明确。

A computer-aided local transient flow property measuring system was developed using a high speed CCD camera coupled with optical fibers in order to study the Gas-liquid-solid three-phase jet loop reactors. SnO2 crystal films were orientally deposited on the alkoxysilane molecule-coated hydroxyl glass substrates so as to prepare surface-marked particles as the tracers. An image analysis system was established to identify different phases. Stroboscopic photography was utilized to extend the measure range. The developed measuring and analysis system was capable of determining accurately the local transient flow property in a G-L-S jet loop reactor. Based on the above system, local transient flow properties of gas, liquid, and solid phase were measured and studied the influences of fluid property, operation and configuration parameters on the reactor.

中文摘要：以气液固三相喷射环流反应器为研究对象，将高速CCD和光纤束耦合制成局部瞬态流动特性微机数据采集及图象处理系统，利用MPS硅烷分子在带有羟基的玻璃基底上的自组装引导SnO2晶态膜层在功能化表面上进行沉积，以获得表面标记的示踪粒子，解决图象处理技术与相的识别的问题，利用频闪技术拓展了测量上限，得到可以准确测定气液固三相喷射环流反应器中局部瞬态流动特性的测试系统；采用上述测试技术进行喷射环流反应器中局部气相、液相与固相瞬态流动特性的实验研究，并考察物性参数、操作参数与结构参数的影响规律。

The area of expression was in basal layer of scar epidermis, perivascular and skin appendages, and the intensity of expression in hypertrophic scar was higher than in keloid.

表达区域在瘢痕表皮的基底膜层、血管和皮肤附件的周围。与凋亡相关基因的表达几乎一致。

In this paper, a new generation polymer of guide-3,4-poly ethylene dioxythio phene was introduced. Preparation processing of PEDT films was studied. Most of principle was recommended. The influence of different process factors on PEDT films properties had been discussed, observing the surface situation ,and studying the relationship between conductivity、surface situation and mensuration of degree of polymerization .

本文介绍了新一代导电聚合物材料PEDT(3，4—聚乙烯二氧噻吩)的主要特点，相关原理，及合成方法，研究发现影响薄膜电导率和致密度的影响因素如：聚合温度，单体和氧化剂配比等，研究了PEDT材料的热稳定性，对PEDT的膜层表面形貌以及分子量的测定方法进行了研究。

Due to the solidness of coating , it is especially suitable for use in home electric appliance and automobiles , where good anticorrosion performance and adhesive force are required

由于膜层坚实，尤其适用于家电汽车等要求耐蚀性高附着力强的产品使用。

ATR-IR can analyze the structure information of the polymer surface and untransparent material and hydrous material.

界面的结构与性能以及粘结强度等因素直接关系到膜层/金属材料的性

This paper aims to standardize UV varnishing workflow and build a sort of estimate system about UV varnishing quality.

本论文是对印刷品UV上光工艺规范化和膜层质量评价体系的研究。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。