腔的

Analyses of spectral structure and surface tension of solutions suggest that the hydrophobic hardrocarbon chain of surfactants was partly included in the apolar cavity of β-CD and the part with the polar head group of hydrocarbon chain located outside the cavity coiled over the top of β-CD, providing an effective protection for RTP.

组成测定表明溶液中形成了稳定的1：1：1/1-BrN：β-CD：AS三元包合物。光谱和溶液表面张力分析显示阴离子表面活性剂的疏水性烷基链有一部分被包合在β-CD空腔内，未被包合部分则绕曲在β-CD腔口处从而为空腔内1-BrN分子的磷光提供了有效保护。

The stable region＇s boundary curve expression is obtained with the off-focus amount as a design parameter.

分析结果表明，对于子腔预先给定的参量，只要另一子腔满足适当的失调量，整个谐振腔就是稳定的。

The numerical results show that, after the hot intrusion reaches the cold wall, some accumulates in the cold top corner, since the cold boundary layer flow cannot entrain all of the hot intrusion.

结果表明：当热入侵流抵达腔体冷壁后，由于冷壁无法卷入所有的热入侵流，热入侵流在冷上角堆积并产生一个反向流动，在冷壁边界层附近形成一个顺时针涡，该涡在浮力效应驱动下可返回热壁，并在腔体的冷热壁之间形成了腔体尺度的流体振荡，即内重力波。

Aseptic loosening of prosthesis has become the main reason for failure. From the prospect of prosthesis design,increasing the prosthesis and bone adaptation to reduce the initial micromotion and increase long term bone ingrowth is the only way to achieve long term fixation.

而这一密合程度由髓腔形态与假体外形共同决定，因此股骨髓腔形态必须纳入假体设计的考量的中，而研究各种影响髓腔形态的因素就极具价值和意义。

Plate and λ/2 plate were placed inside the Nd∶YVO4KTP green laser cavity with angle 90°between their fast axis.The composite plate composed of HWP,QWP and KTP has the function of QWP.The composite plate with Nd∶YVO4 can effectively suppress the coupling of polarized modes,and multi-longitudinal-mode lownoise green laser was obtained.Since the composite plate counteracted the phase shift induced by temperature sensitivity of quartz plate,the green laser operated with lownoise reliability in different output power and different operation temperature.The threelongitudinalmode, the noise of less than 0.5% and output power stability of less then 1% for 12 hour are obtained in the green laser.

介绍了一种LD泵浦腔内倍频全固体Nd∶YVO4KTP多纵模、低噪音、高功率稳定绿激光器在Nd∶YVO4KTP绿激光器组成的谐振腔内放置厚度约相等的石英晶体λ2波片和λ4波片，使两波片快轴夹角互呈90°，HWP、QWP与KTP构成复合波片，其作用相当于QWP，此复合波法与各相异性Nd∶YVO4共同作用有效抑制了腔内偏振模耦合，获得多纵模低噪音绿光输出此复合波片相互作用由于抵消了石英晶体波片温度敏感引起的相位延迟量漂移，所以此激光器在不同功率、不同工作温度下，均能稳定可靠地运转于低噪音状态实验结果为，绿光输出纵模数为3个，噪音小于0.5%，12 h功率稳定性优小于1

The gas transmission cell is designed in such a way that, with the test specimen in-serted, it is divided into a dry chamber and a controlled-humidity chamber.

气体渗透腔是按这种方式设计的，当插入测试试样时它就会被分成一个干腔和一个湿度可控的湿腔。

Micro-engine is composed of premixing- chamber and combustion-chamber. Flow and diffusion in micro-chamber are important influence factors of premixed catalytic combustion in the micro-engine.

微型发动机由预混腔和燃烧腔组成，而微型预混腔内流体的流动和传质是影响微型发动机预混催化重整燃烧的重要因素。

Taking water-jacket of 226B diesel engine as the practical objective, the calculation in void fraction and the velocity filed of the water jacket were made.

最后以226B 型发动机水腔为工程应用对象，计算出了水腔内的空泡份额分布和水腔内的流度分布情况。

The optimal chamber height is found , and PZT diaphragm actuating ways in series-wound and parallel-connectioned pumps are proved.

通过实验确定了双腔压电泵的最佳腔体高度及双腔串联、并联压电泵压电片的最佳驱动方式。

There are bearing pedestal and blowing case on the main machine base. There is grinding case on the blowing case, whose middle part has multilayer dial equipping on the main bearing. On each dial, there are numbers of roller, and there are corresponding ring for each dial.

主机机座上装有轴承座及进风壳体，进风壳体上装有磨腔壳体，套装在主轴上的多层转盘位于磨腔壳体中部，在每层转盘圆周上均布有数个环辊，磨腔壳体内圆周有滚道的磨环。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。