脱水

The pulp is transferred to the dehydrator for drying, and this product will be used in supplements such as multi-fibre tablets.

浆状原料随后放入脱水器内进行脱水，完成后将用於如多种纤维片等补充品。

5Have a dehydration test on the internal phase of super high water cut oil system by means of automatic electric dehydrator. Discuss the effects of the electric intensity and emulsion breaker on dehydration of the internal phase of super high water cut oil system.

5采用自动试油器对特高含水原油体系的油相进行了脱水测试；探讨了电场强度和破乳剂对特高含水原油体系油相脱水的影响。

The custom-designed dehydrator at Lakeview carefully removes the water from raw plants by exposing organic material to lower temperatures over a longer period instead of high temperatures for short periods.

湖景镇内的脱水器是为除去植物原料中的水分而特别设计，将有机植物原料置於较长时间的低温状态，有别於其他的快速高温脱水方法。

The results shows that the dehydration currents increase with falling in dehydration temperature, increasing in intensity of electric dehydration field, raising the content of water or iron in the crude oil. Lights striking or/and discharging would appear when those parameters get certain amount. Some serious situation, the electrical equipment of the experiment apparatus of electric dehydrator stops the supply of electricity.

实验结果表明：在直流电场下，极板间电压越高、脱水温度越低、油样中的水含量和铁含量的增加，均使脱水电流增大，达到一定值时会产生打火放电现象，严重时导致实验仪器跳闸，即所谓的"垮电场"。

The optimal dehydration temperature is 140℃, dehydration time is 4 hours, dehydration amount reach 94%, depolymerization temperature is 240℃, depolymerization time is 2 hours and finish at 270℃.

脱水温度，140℃；脱水时间，4小时，使脱水量达到94％左右；解聚温度，240℃；解聚时间，2小时；终止温度，270℃。

The effects of dehydration temperature, ratio of dehydration, catalyst dosage, polymerization and depolymerization temperature on the yield of D, L-lactide were studied.

考察了制备过程中脱水温度、脱水率、催化剂量、聚合温度和解聚温度对丙交酯产率的影响。

This paper analyzes various technical and economic characteristics and technologic calculations for gas transmission pipeline,and takes Luojiazai Depurative Gas Transmission Pipeline as an example,introduces the technical and economic comparison of desiccation project s in detail and proposes a feasible dehydration and desiccation technical project .

分析了各种天然气管道干燥方法的技术经济特点及工艺计算方法，以罗家寨净化气外输管道为例，介绍了其脱水干燥方案的技术经济比选，提出了切实可行的脱水干燥技术方案。

System measurements and studies on the nature of those coals and the electrokinetics of coal-water slurries had been done.

探索了一条适合于超细粒物料深度脱水的新途径；真空过滤-电渗脱水工艺。

The hydrothermal behavior of various types of alumina was investigated by means of XRD,which were derived from calcination of gibbsite,bayerite and nordstrandite at temperatures below 1000℃ and normal pressures or in vacuo.

用XRD方法研究了α－三水铝石在常压及真空中1000℃以下的脱水产物和湃铝石／诺水铝石在常压1000℃以下的脱水产物，经170℃水热处理和自身压力条件下的晶相变化。

It is found that the concentration of sulfuric acid in liquid and the reaction temperature are the most sensitive factors for this process. Increasing the ratio of solid to liquid is disadvantageous for growth of crystals even though it does not effect obviously for the rate of dehydration of FGD gypsum. On the other hand,the more closed to the neutral range of pH value the liquid is adjusted,the better stability of the α-form calcium sulfate hemihydrate appear,the more favorable for modification of crystal habit the process is made.

研究中发现pH值和盐溶液浓度是影响FGD石膏脱水速度最敏感的因素，固液比虽然对脱水速度影响不大，但固液比增大对晶体生长和习性改良不利。pH值愈接近中性范围，愈能增强α半水石膏结晶在液相中的稳定性，有利于结晶习性改良。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。