脱氧剂
- 与 脱氧剂 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The main investigation contents include:(1) the effect of slag deoxidizers on reduction velocity of slag and contents of C, Si, Al in steel;(2) the effect of steel deoxidizers on desulphurization;(3) the effect of adding BaO into slag on desulphurization;(4) the effect of magnesium-based desulphurizer on desulphurization ...
主要的研究内容包括:(1)不同炉渣还原剂对炉渣还原速度及对钢液增碳、增硅、增铝的影响;(2)不同脱氧剂对钢液脱硫的影响;(3)顶渣中BaO的配入量对钢液脱硫的影响;(4)镁基脱硫剂钢液脱硫效果及对钢中夹杂物的影响。
-
This alloy can be used as a compound dexidant,desulphurizer and alloying addition in steel making,and can also be used as areductant in mediumlow carbon manganse iron productio or in metal manganese production by electruisilicon heating.
在炼钢中可作复合脱氧剂、脱硫剂、和合金添加剂,也可以作为生产中低碳锰铁和电硅热法生产金属锰的还原剂。
-
The results indicated that ultra-low nitrogen (0.001 0%-0.008 0%, w/%) in low alloy steel could be determined accurately under such optimized analytical conditions as follow: the addition of deoxidizing agent was less than 0.35%, multi-head milling cutter should be chosen and the milling depth was 1.4 mm while sampling, the mass percentage of argon was no less than 99.999 5%, the washing time was set as 8 s, the precombustion time was set as 3. 3 s and energetic precombustion energetic measure optical source mode is adopted.
结果表明,取样时控制脱氧剂加入量不超过0.35%且选用多刀头铣刀盘,铣样深度为1.4 mm;在氩气的质量分数不小于99.999 5%,冲洗时间为8 s,预燃时间为3.3 s,采用高能预燃高能测量光源方式等优化的分析条件下,可有效测定低合金成品钢中质量分数为0.001 0%~0.008 0%的超低氮。
-
The vacuum package and adding deoxidant model 100 package with material of low venting quality can constrain the accelerating speed of peroxide values,TBA values and carbonyl group values,and delay rancidification obviously.
结果表明:采用低透气性的包装材料添加100型铁系脱氧剂抽真空包装,可明显抑制过氧化值、TBA值和羰基价的增加,延缓酸败。
-
Raw Materials, Accessory Materials, Casting Apparatus, Sand Preparation, Casting Tectorial Membranes, Casting Coatings, Resin, Solidified Agent, Aluminum, Zinc, Copper Alloy, Alloy Spindle, Compound Deoxidizers, Cleansing Agent, Agglutinant, Ferroalloy, Thermal Insulation Material and other Casting Material, etc.
各种原材料、辅助材料、铸造用焦及铸造用品、型砂、铸造用覆膜沙、铸钢丸涂料、树脂、固化剂、膨润土焦炭、铝、锌、铜合金、合金锭、孕育剂、球化剂、蠕化剂、复合脱氧剂、偶联剂、脱模剂、清洗剂、胶合剂、修补剂、铁合金、耐火材料等其它铸造材料
-
Such alloys are best solvent degreased and given a light etch in Deoxidiser 7/17 before the Alocrom treatment.
在ALOCROM 处理前,这些合金在脱氧剂Deoxidiser 7/17中最好的被溶剂脱脂并造成轻度蚀刻。
-
Coordination polymers of dimethyl sulfide: Using P2S5 as deoxygenating agents, three coordination polymers containing dimethyl sulfide, [4(CH3SCH3)3]n (34) and n X = Cl(35, Br(36) have been successfully synthesized.
硫醚类化合物本文首次利用P2S5作为有机物的脱氧剂,在溶剂热条件下,成功地合成3种亚铜甲硫醚配位聚合物[4(CH3SCH3)3]n (34)和n X = Cl(35, Br(36)。
-
Deoxidation behavior of magnesium alloy in 16MnR steel was investigated in a vacuum induction furnace with MgO crucible.
用镁合金脱氧剂在内衬为MgO质坩锅的真空感应炉中对16MnR钢液的脱氧行为进行研究;选取FeAl、AlMg、SiCa和SiCaMg合金,对比考察脱氧后钢水的总氧和硫含量以及脱氧后夹杂物的变化。
-
If the work it to be painted, rinse finally in deionised water, or alternatively mainswater containing Deoxylyte (see the relevant Product Data Sheet for details). Tohelp dry the work this rinse can be heated to 50-70°C.
如果工件要做进一步的喷涂,最后要在去离子水中清洗,或在含有脱氧剂Deoxylyte的水中(参照有关的产品使用说明),为帮助工件弄干,冲洗可以加热到50-70°C。
-
Fresh Alocrom 1200 coatings may be removed without seriously etching the aluminium by immersing in 50% nitric acid or in the Deoxidiser bath.
刚做的ALCOCROM 1200镀层可以浸没在50%的硝酸里或者脱氧剂Deoxidiser浴缸里去除镀层,而不会明显地腐蚀铝材。
- 推荐网络例句
-
For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether
年美国个人破产法的一个改动使得破产登记急速下降,而后引起了信用卡大规模的亏损。
-
Eph. 4:23 And that you be renewed in the spirit of your mind
弗四23 而在你们心思的灵里得以更新
-
Lao Qiu is the Chairman of China Qiuyang Translation Group and the head master of the Confucius School. He has committed himself to the research and promotion of the classics of China.
老秋先生为中国秋阳翻译集团的董事长和孔子商学院的院长,致力于国学的研究和推广。