脱层

The decarburization depth and weight loss during oxidation obtained from isothermal and equi-time heating treatment were used to characterize decarburization sensitivity.

采用等温处理和等时处理研究了含硼中碳弹簧钢和作为对比的60Si2Mn钢的脱碳层深度和氧化失重量的变化情况。

In addition, there is delamination removal at weak interface due to decarburization.

普通涂层的磨损机制为微切削；纳米涂层在轻载(10 N)下，以塑性变形为主要磨损机制，随载荷增加至30 N，纳米WC粒子不能起到阻抗陶瓷球对磨副的磨削作用，而是随粘结相一起被去除，同时由于纳米涂层脱碳导致的层间结合薄弱，在滑动磨损中易发生成片剥落，耐磨性大幅下降。

The main contents of precursors reaction in Si23H24- Zircon 4 surface of the atomic layer deposition dechlorination reaction mechanism.

研究的主要内容有前体反应物ZrCl4在Si23H24-4 表面的原子层淀积的反应过程中脱氯机理。

The serious degasification in low pressure formation of Tuba Oilfield, which changes component of the fluid, makes the logging data interpretation to be difficult.

吐哈油田的低压层脱气现象严重，流体成份发生变化，给资料解释带来了困难。

The serious degasification in low pressure formation of Tuha Oilfield,which changes component of the fluid,makes the logging data interpretation to be difficult.

吐哈油田的低压层脱气现象严重，流体成份发生变化，给资料解释带来了困难。

The dynamic characteristics is studied in a fixed bed reactor of inner diameter 1. 56cm, resin packing height 96cm. The effect of mass ratio of methanol to deodorizer distillates, temperature, residence time, and flow rate to conversion of free fatty acids has been studied.

在内径为1.56cm，高度为96cm的树脂床层中考察了固定床连续酯化反应的动态特性，研究了甲醇与脱臭馏出物的配比、反应温度、接触时间和物料流量等因素对脂肪酸转化率的影响。

Results revealed that the large side insulation of the stator bar in slot is available for ultrasonic pulse-echo testing; Coupling transducer on the surface of a practical stator bar could minimize the influence on the measurements of velocity, contributing no destructivity of the ultrasonic testing for stator insulation; The simultaneity of same velocity and higher attenuation can be used to detect insulation delamination from conductors; Compared with the wide sides of the bars in slot, the short sides of the bars near the exit from slot and the end bars had a same velocity and a higher attenuation; The velocity might be exactly measured on the shot sides of the bars near the exit from slot and the end bars, while the attenuation might not, which were examined though filed tests; V min decreased greatly and V av decreased slightly with the service time of the bars.

在实验室对线棒多种结构处的主绝缘和不同运行年数(未老化、16、18 和23年)线棒的主绝缘进行了低频超声反射法检测试验，并进行了现场试验，发现(参见 Hao et al， IEEE DEI， to be published)，槽部线棒的宽面绝缘不受换位绝缘的影响，比窄面绝缘更适合超声测量；线棒表面平滑的半导体层减小了耦合剂对超声测量的影响，实现了无损性；波速不变而声衰减减小可以检测线棒出现绝缘与导体脱壳缺陷；出槽口和端部线棒的窄面绝缘与槽部线棒的宽面绝缘相比，声衰减大而波速一致；现场试验验证了波速不受绝缘结构和现场测试条件的影响，而声衰减受以上因素影响很大(参见 Hao et al，中国电机工程学报， Vol.23 No.4)； V min 随运行年数明显减小， V av 随运行年数慢慢越小。

TG-DSC results revealed that the decomposition of magnetic CoAl HTLcs proceeded in two stages. The first large endothermic effect below 220℃involves the loss of physically absorbed and interlayer water and the second endothermal effect, between 220℃and 402℃, corresponds to the decomposition of the hydroxide layers and the removal of anions in the brucite-like layers. The S_ and pore diameter information of magnetic CoAl HTLcs were tested by N_2 adsorption-desorption analysis.

TG-DSC结果表明磁性CoAl水滑石有两个过程，在220℃以下的第一个失重过程是由于物理吸附水的移除造成的，在220℃至402℃之间的主要失重过程是由于材料脱除结构水，碳酸根离子和部分羟基造成，并伴随着层板结构的塌陷。N_2 adsorption-desorption测试分析了磁性钴铝水滑石的比表面积、孔径等信息。

Phenol derived from two stage water gas gasification is produced in upward, and in downward, after tar, suspension and sediment removed, phenol, which has been filtrated, pressurized and atomized, is sprayed into regenerative chamber where phenol and high temperature lattice bricks exchange heat each other and phenol get into superheated vapor, then phenol come into gasifier with making up steam and in fire layer phenol is decomposed into H 2O and CO 2 which will go on reacting with blazing carbon and fo...

两段炉水煤气气化工艺在上吹制气阶段产生含酚冷却水，下吹制气阶段，将脱除焦油、悬浮物、沉淀物并进一步过滤后的酚水加压、雾化、喷入燃烧蓄热室内与高温格子砖进行热交换，使之汽化并过热，然后与补充过热下吹蒸汽一起进入气化炉火层，酚在高温作用下分解成H2O和CO2，并进一步与炽热的炭发生反应，形成H2和CO。

The results show that MMT lamellas exfoliate from PAM matrix.

结果表明，蒙脱土以片层结构分布在聚合物基体中。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐