脱层

Skin nursing shell the way for take off to throw away the periostracum strong line through an outside dint, lose the skin of periostracum protection, the immunity dint will descend, the germ easily gains an advantage but goes into, the skin that is at this time easy occurrence hair bag burning, or the face appear erythema and pimple.

皮肤护理时通过外力剥脱的办法将角质层强行去掉，失去角质层保护的皮肤，免疫力会下降，细菌容易乘虚而入，这时的皮肤就容易发生毛囊炎，或是面部出现红斑和痘痘。

A novel nano-composite, biurea intercalated montmorillonte, was prepared by the novel intercalation-decomposition process of azodicarbonamide at the presence of mixed dispersant DMSO/H_2O.

以二甲亚砜/水为复合分散剂，通过偶氮二甲酰胺的插层-分解过程，制备出亚肼基二甲酰胺插层蒙脱土新型复合材料。

Taking U71Mn steel as an example, the effect of heating time, protective coating and rolling deformation rate on decarburization and oxidation of the heavy rail slab has been studied by observing the changes in the slab's decarburized layer in the course of heating and rolling.

以U71Mn钢为例，通过观察在加热和轧制过程中的钢坯脱碳层的变化，研究加热时间、保护涂料和轧制形变率对重轨钢坯脱碳和氧化的影响。

Taking U71Mn steel as an example, the effect of heating time, protective material and rolling deformation rate on decarburization and oxidation of the slab has been studied by observing the changes of the slab's decarburized layer during the course of heating and rolling.

本文结合武钢大型厂U71Mn重轨钢，通过观察在加热和轧制过程中的钢坯脱碳层的变化，研究了加热时间、保护涂料和轧制变形率对重轨钢坯脱碳和氧化的影响。

The suitable conditions of quartz sand filtration using for purifying the NHD decarburizing/desulfurizing solution were studied,and sand-bed backwashing method and its intensity were determined.

实验结果表明：在室温，石英砂粒径范围0.60～0.80 mm、床层高度600 mm、操作压力为0.03 MPa以及滤速为8.1 m/h的条件下，NHD脱碳液经石英砂过滤净化处理后，固体杂质去除率可达89.8%以上，且处理后的NHD脱碳液的吸收性能未变。

The suitable conditions of quartz sand filtration using for purifying the NHD decarburizing/desulfurizing solution were studied,and sand-bed backwashing method and its intensity were deter...

实验结果表明：在室温，石英砂粒径范围0.60～0.80 mm、床层高度600 mm、操作压力为0.03 MPa以及滤速为8.1 m/h的条件下，NHD脱碳液经石英砂过滤净化处理后，固体杂质去除率可达89.8%以上，且处理后的NHD脱碳液的吸收性能未变。

At early stage bedding fault activated, then transected strata to control formation of anticlines miniature, from late Permian to Jurassic growth faults controlled growth anticline, finally joined end to end, and merged to a common slip surface.

断裂早期以顺层滑脱为主，晚期切穿地层控制了纵弯背斜和断展背斜的雏形，二叠纪晚期-侏罗纪时期生长断裂控制了生长背斜的发育，且各断裂在深部归结为统一滑脱面，首尾相接使得背斜发育具明显的顺序性。

It is found that TiO2/pillared MMT (TiO2/MMT) composite catalyst exhibits the best degradation activity to methylene blue and methyl orange compared with other semicondutors/MMT, such as SnO2/MMT, Fe2O3/MMT and Cu2O/MMT with different energy gaps that is closely correlated with the formation of stable pillar stucture and appropriate energy gap in the TiO2/MMT.

在对具有不同能带宽度的TiO2、SnO2、Fe2O3和Cu2O四种半导体/蒙脱土复合催化剂的研究中，发现TiO2柱撑蒙脱土(TiO2/MMT)对亚甲基蓝和甲基橙有最好的光催化降解活性，这是与其形成稳定的层柱结构和TiO2具有合适的能带宽度密切相关的。

Usage 1. Metal surface paint remove method: Brush objects in need of the paint remover on the surface, in a few minutes the old Membrane will be soften, wrinkling, blistering and then fell off, then use water wash off the impurities; for special thick coating, can spray once more before washing, or clear the residue with a piece of sandpaper or a shovel knife.

使用方法金属表面脱漆方法：将本品刷涂于需脱漆层表面，数分钟内旧膜即可软化、起皱、起泡进而脱落，再用水将脱落杂质清洗干净，待其干燥；对于特别厚的涂层，可重复使用一次，再用水冲洗干净，或配以砂纸和铲刀清除局部残留即可。

X-ray diffraction. The microstructure and cross section microhardness of nitrided layers were observed and analyzed by optical microscope and microhardness tester.

在一定的工件表面温度下，粒子表面物理吸附的氮原子发生脱附，脱附下来的活性氮原子渗入基体的内部，形成渗氮层。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐