能面

Such as: chicken broth, shrimp, seeds, eggs, vegetables, carp, monosodium glutamate XieHuang egg, fine fine delicate, more than ten varieties of these varieties are distinctive, Different varieties of different flavor, taste delicious, easy to digest the food, the elderly and infirm, can appetitive, enhanced physique, both young and nutrition food.

鸡汤面、虾籽面、鸡蛋面、鲫鱼面、果蔬面、蟹黄面、味精挂面、蛋清挂面等十多个精致品种，这些品种各具特色；不同品种风味各异，味道鲜美，易于消化，年老体弱者食之，能促进食欲，增强体质，是老少皆宜的营养食品。

The results show that the most close-packed surface (111) orientation of FCC metals which have the lowest surface energies will grow preferentially, the surface energies for the all lattice surfaces increase linearly with increasing including angle between the surfaces and (111), which are consistent with the experimental and the linear muffin-tin-orbital-atomic-sphere-approximation results.

结果表明，FCC金属的密排面（111）的表面能最小，则该晶粒取向优先生长，与实验结果和第一原理的LMTO－ASA计算结果一致；各个晶面的表面能均随着其它晶面与（111）晶面的夹角的增长而呈线性增长关系，因此利用（111）面可推导出其他各面的表面能量。

With reading a mass of the documents about the rolling resistance and wet anti-grapping, there are 11 types semisteel belt tyres formularies designed in this paper by changing carbon black and SBR1502/SBR1712/BR9000 blending ratio, which answer for the actual demands of the tyre industry and have a certain extent engineering practicability.The DMA curves of 11 types tread rubber materials used in tires with the changes of temperature have been obtained by using Dynamic Mechanics Analysis technique on NETZSCH DMA242 instrument.

本文采用动态力学分析法，使用NEZSCH公司生产的DMA242型实验仪，获得了11种胎面胶的DMA温度曲线，从炭黑和生胶配比变化两方面，分组对不同系列的胎面胶的储能模量—温度曲线和损耗因子—温度曲线进行了分析比较，并参照1#胶料，对11种胎面胶—10℃～10℃和50℃～80℃的tanδ进行比较，讨论了炭黑及SBR1502/SBR1712/BR9000并用比的改变对胎面胶滚动阻力、湿抓着力的影响；在动态力学分析实验的基础上，还获得了11种胎面胶的生热率曲线，并分组进行了比较，研究了配方与生热率的关系。

We also developed several experiential formula based on structural unit model for high-index surfaces, which can give an estimate of the energies of the high-index surfaces if the value of surface energy of (001),(110) or (111) are known.

作为各条曲线表面结构单元的两个低密勒指数面[001]晶带的(100)面和(110)面，[-110]晶带的(110)面和(111)面或(112)面其表面能值分别是对应曲线上的一个极小值点。

The results showed that the TiN andN films are polycrystalline phase. The properties and structure of TiN films are mainly determined by the N2 mass flow rate, and as the N2 mass flow rate increases, the structure of the TiN films transforms to f.c.c. type leading to better the properties of films. The presence of negative bias voltage can optimize the grain of TiN films, lower the defect proportion and denser the films, which improves the hardness of films. The TiN films conform to the free carrier absorption mechanism and there are many of free electrons with lower N content in TiN films. With the increase of N content, the quantity of free electrons and reflectivity of films decrease, and the plasma frequence shifts to the lower energy, which leads to the regular change of colors of films from silver, yellowy, golden to yellow-red, meanwhile the lightness of films decreases. The goldenN film consists of TiN and ZrN phase, but belongs to a sigle f.c.c. structure with (111) preferred orientation. The Zr-doping dosen't change the position of the valance band, conduction band and forbidden band ofN film, but leads to the presence of new energy levels, which is the reason thatN film remains golden. The transparent hard films with good corrosion resistance and high hardness have been prepared and the further reseachs showed that the grain size of those films is by far smaller than the wave length and the width of forbidden band of those films is very broad, is the reasons that those films are transparent.

研究表明：氮化钛和N 薄膜为多晶态，氮流量决定了氮化钛薄膜的结构和性能，增加氮流量能使氮化钛薄膜的结构向面心立方结构转变，从而得到性能良好的氮化钛薄膜；施加负偏压能优化氮化钛晶粒和减少薄膜中的缺陷，使膜层变得更致密，从而提高薄膜硬度；氮化钛主要遵循自由载流子光吸收，氮含量较少时薄膜中的自由电子数目较多，随着氮含量的增加，薄膜中的自由电子数目不断减少，反射率逐渐降低，等离子体频率向低能端移动，从而使薄膜颜色出现规律变化，由金属色银白色到淡黄、金黄再到红黄，并且薄膜亮度呈下降趋势；金黄色的N 薄膜中存在TiN 和ZrN 的分离相，但其为单一的面心立方结构并具有(111)面择优取向；相对于TiN 薄膜，Zr 掺杂后，并没有使薄膜的导带、价带和禁带发生变化，只是在TiN 禁带内增加了新能级，这也正是掺杂Zr 后，薄膜仍

Based on the relevant movement between hard shaper cutter and grinding wheel, the movements of grinding wheel are studied. The shaping grinding point and the shaping grinding edge are made up with. In order to easily compare when shaping errors and cutting edge"s angles are the most excellent, uniform expressions for convex curved rake face of hard shaping cutter and spatial cutting edge curve are separately developed. The distributions of new profiling cutter"s shaping errors and cutting edges angles are analyzed. The relevant grinding wheel and cam are designed. Due to this paper, a new profiling hard shaping cutter has been manufactured successfully. At last experiments are made to test the performance of hard shaping cutter and all kinds of precision of hard gear.

本文直接从插齿刀与砂轮之间的相对运动关系出发，单独研究砂轮的运动，提出砂轮成形磨削点和砂轮成形磨削刃的概念；分别建立圆柱砂轮和圆锥砂轮磨削后硬齿面插齿刀的波形前刀面方程及空间切削刃方程；为便于比较何种情况下插齿刀的构形误差和切削角度能同时达到最优，分别对磨削五种不同硬齿面插齿刀所用的砂轮进行了廓形设计，并分析了插齿刀的构形误差和侧切削刃切削角度的分布规律；为插齿刀波形前刀面的磨削加工设计了相应的凸轮，用所设计的凸轮和近似的砂轮成功地制造出新构形法硬齿面插齿刀；最后进行插齿加工试验，检验新构形法硬齿面插齿刀的抗崩刃能力、耐磨性及被加工硬齿面齿轮的各项精度。

The adhesive for honeycomb paper board has complete varieties covering the whole industry, such as cold-press adhesive for agglutination and hot-press adhesive for agglutination, flexible adhesive film and rigid adhesive film, low-speed adhesive and high-speed adhesive, slow-drying adhesive, quick-drying adhesive and instant-drying adhesive, so it can meet various demands of producing honeycomb paper board..

我公司蜂窝纸板专用胶品种齐全，覆盖整个蜂窝纸板行业，完全能满足各种纸蜂窝设备生产蜂窝纸板及蜂窝纸板制品，既有冷压粘合用胶，又有热压粘合用胶；既有弹性胶膜胶，又有刚性胶膜胶；既有低速胶，又有高速胶（复面胶能满足每分钟开机速度为4—30米复面制版的要求，芯条胶能满足开机速度为10—200米/分钟的制芯要求；既有慢干胶，又有块干、速干和瞬干胶，能满足不同干燥要求的需要。

The existing stone cutting tool, the tool bit is constituted by the sole grade's grinding material, when cutting the rough stone, the cutting speed is quick, the cutting efficiency is high, but the cutting surface fluctuates in a big way, becomes rough, after the cutting, grind and polishing take long time to do, if use the fine grinding compound, the cutting face is smooth, but the cutting speed is slow, the cutting efficiency is low, therefore the existing stone material cutting tool cannot have the high efficiency to cut the stone which have the smooth cutting surface, in view of this, how to keep the high working efficiency and get smooth cutting surface?

现有石材切具刀头由单一粒级的磨料构成，使用粗料时，切割速度快，切割效率高，但切割面起伏大，变得粗糙，切割后研磨抛光耗费时间长，使用细磨料，切割面较平整，但切割速度慢，切割效率低，因此现有石材切具不能高效率地切割出平整的石材，针对这一现状，如何既能高效率切割，又能使切割面保持平整呢？

A wider face area offers greater forgiveness and playability while full-length scorelines provide more consistent spin from longer grass or wet conditions. the tour-preferred titleist pear shaped profile with a perfectly square face angle deliver the looks and confidence better players demand. because we believe, as they do, that every club is a scoring club.

更大的杆面区域提供了绝佳的容错度与易打性，无论在长草或潮湿的状态下，完整长度的杆面刻线能产生更一致的spin，titleist梨状造型搭配近乎完美的方正杆面角度，无论在外型与信心上皆能满足球友们的需求，因为我们深信，如同这些设计所达成的，每支球杆都是得分杆。

Firstly, the diffusion of oxygen atom from the SFCC to SHCP on Zr(0001) surface is calculated. The active energy for the diffusion is 0.77eV. Secondly, the diffusion of oxygen atom from the SFCC to Octa(2,3) via Octa(1,2) is calculated too. There are 2 energy barriers for oxygen atom to overcome, the active energies are 2.14eV and 2.57eV.

我们首先计算了氧原子从稳定的表面面心立方位置向表面六角密排位置的扩散，其扩散激活能为0.77eV；然后计算了氧原子从稳定的SFCC位置扩散到表面下第1层与第2层之间的八面体间隙Octa(1，2)位置，然后继续向表面下第2层与第3层之间的八面体间隙Octa(2，3)位置扩散，在此过程中氧原子需克服2个能垒，其激活能分别为2.14eV和2.57eV。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新