胶粘的
- 与 胶粘的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Transmission Electron Microscope and other properties testing results show that the complex emulsifier system is the crucial influence factor of the polymerization process and the properties of products. It may influence the coagulum content and reaction rate of the polymerization process, the performance, particle diameter,viscosity, electrolyte stability and storage stability of the emulsion products and the contact angle of the film.The initiator mainly influences the coagulum content and reaction rate.The acrylic monomers mainly influence the solid content, Minimum Film Formation Temperature of the emulsion and the Glass Transition Temperature of the film.The organic silicone monomer mainly influences the water absorption of the film.The reaction temperature mainly influences the reaction rate and conversion.The stirring intensity mainly influences the coagulum content of the polymerization process.
透射电镜等性能测试结果显示:复合乳化剂体系是硅丙共聚乳液的聚合过程及产品性能的主要影响因素,它可以对聚合过程的凝胶率、反应速率以及乳液的外观、粒径、粘度、耐电解质稳定性及贮存稳定性,还有乳液涂膜的接触角等造成不同程度的影响;引发剂主要影响反应速率和凝胶率;丙烯酸酯单体主要影响到乳液的固含量、最低成膜温度以及涂膜的玻璃化转变温度,有机硅单体主要影响涂膜的吸水率等;聚合反应温度主要影响乳液的反应速率和转化率等;搅拌强度主要是影响到聚合过程的凝胶率。
-
The macroscopic rheological parameters and microstructure parameters were closely related, it is helpful to explain the essence of multiple rheological properties through the analysis of which the wax evolution process and microstructure of the crude oil which is waxy and high viscosity; the yield time of gelled waxy crude oil monotone increases along with the decreasing of rate of shear (the time of stress effect prolonged), there was power function relationship between them, it can be expressed with ; when adding diesel oil to Sudan crude oil, dilute proportion bigger the eccentricity degree of paraffin particles were bigger too, that was to say the symmetry of wax crystal was better, the wax crystal form fabric more hardly when the intermolecular interaction was smaller; in the light of macroscopica, the fall extent of the abnormity temperature, solidifying point and viscosity could be larger along with the accretion of dilute proportion, as a result, it's rheological properties could be improved.
SD原油析蜡点为94℃,析蜡高峰为50~30℃,异常点为40℃;其蜡晶颗粒细小、对称性差,所以具有较大的比表面能,容易形成联生、联锁结构;损耗角曲线与储能模量曲线或损耗模量曲线的交点所对应的温度与原油凝点或倾点温度非常接近,大约在39℃左右;也就是说,含蜡原油粘弹特性曲线的交点可以表征其流动性;原油宏观流变参数与微观结构参数密切相关,原油析蜡过程及蜡晶微观结构分析有助于诠释易凝高粘原油多重流变特性的本质;胶凝含蜡原油的屈服时间随剪切速率的降低而单调增加,二者显然存在幂函数关系,可用关系式描述;当SD原油加柴油稀释处理时,稀释比越高,蜡晶颗粒的偏心度也越大,亦即蜡晶对称性越好,分子间作用力越小,蜡晶颗粒越不易形成结构,宏观表现为异常点、凝点及表观粘度等流变参数下降的幅度越大,流动性越好。
-
Sweet potato contains mucin, is a mixture of polysaccharides and proteins belonging to collagen and mucopolysaccharide.
甘薯含有粘蛋白,是一种多糖和蛋白质,属于胶原和粘多糖的混合物。
-
The viscoelasticity and strength of gel were determined by AR1000 Rheometer and TA Texture Analyzer.
采用流变仪和质构仪测定了脂肪替代品凝胶的粘弹性和凝胶强度。
-
The knot can be stiffened and strengthend by dabbing just a smidgeon of white paper glue on your fingers and squeezing the knot with them.
用手指粘上少量的白皮胶并挤压在结上,这些结就粘得很牢。
-
Yogurt manufacturers are often faced with fracture of the gel, low-viscosity and wheying-off. Using polymer producing strains of lactic acid bacteria can reduce considerably the syneresis of yogurt.
酸奶中常出现凝胶易断裂、粘稠度低、乳清易于析出等质量问题,使用产粘乳酸菌可以大大降低酸奶的凝胶脱水收缩。
-
Adherence, repairing property, anisotropically electra conductivity and rapid adhering at low temperature are given to FPC by anisotropically electro conductive hot melt adhesives who are key component of FPC. There is no report on successfully manufacturing AECHMA in our country at present, so it is very significant to make a research on AECHMA.
异向导电热熔胶是柔性印刷电路的关键组分,它赋予柔性印刷电路粘接性、可修复性、异向导电性和低温快速粘合性,国内尚无成功开发异向导电热熔胶的报道,因而对异向导电胶进行研究开发具有非常重要的意义。
-
Uniformity of the photoresist film, adhesiveness between underlay and glue film, exposal and develop condition of high thickness difference are all solved in the thesis.
在厚胶光刻工艺中重点解决了胶膜厚度的均匀性、胶膜与衬底的粘附性、大厚度差胶层的曝光、显影条件等的优化问题。
-
Much coagulation coul d be found to be adhered to the wall of reaction vessel and mixer when this cros slinker was used for conventional emulsion polymerization whereas coagulation co uld be greatly reduced and no obvious bulking of particle size of the product wo uld occur when this crosslinker was used for microemulsion polymerization and do sage and proportion of emulsifier wer.
将此交联剂用于乳液聚合中,若采用常规乳液聚合方法,反应器壁及搅拌上会粘附有大量凝胶;采用微乳聚合的方法并调整乳化剂用量及比例,可大大减少凝胶量,同时使产品粒径无明显粗大化现象。
-
The results suggest that MCMBs' characteristics had much influence on slurry and milling was more propitious to achieve higher solid loading slurry than just stirrering.
粘度为40mPa.s。对凝胶反应过程进行了动力学研究,并分别讨论了引发剂、催化剂、单体/交联剂比例和单体浓度对凝胶反应过程和凝胶体强度的影响。
- 推荐网络例句
-
It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.
从鲍尔点的形成原理出发,分析对称连杆曲线上鲍尔点的产生条件,提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。
-
The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.
集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品,年生产总值3000万美元,产品价廉物美、选料上乘、质量保证,深受国内外客户的青睐
-
The eˉtiology of hemospermia is complicate,but almost of hemospermia are benign.
血精的原因很,以良性病变为主。