胶粘物

The optimal condition of zymosis and degradation determined by viscosity change was achieved: liquid seed inoculate 2%, carrageen terminal concentration was 0.1% in the solid leavening, and degrading temperature of 50℃, pH 5, the enzyme quantity was 0.5:1.

通过降解产物粘度的变化来确定适宜的发酵条件及降解条件。结果表明发酵物中的液体种子接种量为2%，卡拉胶的终浓度为0.1%，降解温度为50℃，pH=5，加酶量为0.5：1时，此酶的降解效果最好。

Aiming at the characteristics of the thermo melted adhesive for aluminum plastic composite pipe, we determined the grafter of α alkene acid grafting polyethylene as the adhesive used for the pipe.

针对铝塑复合管用热熔胶粘剂的特点，确定了以α-烯酸接枝聚乙烯的接枝物作为铝塑复合管粘接用胶。

This vinyl acrylic copolymer was designed to bond synthetic films, such as polyvinyl chloride, Mylar and cellophane.

这种乙烯基的丙烯酸共聚物是专为粘接合成胶膜而设计的，例如聚氯乙烯、聚酯薄膜和玻璃纸等。

Producted RF and CRF aerogels by process of sol-gel technics, dynamic-exchange, CO2 supercritical drying, and procedural increase in temperature carbonization methods, which have eximious capability and nanometer network structure; Systemic analysis various factors which effect gel course, such as ratio of reactants and the dosage of catalyst, and probed into the better experiments conditions(the concentration of resorcinol and formaldehyde is more than 2% and the value of R/C is between 50 and 300); During gel course , primary investigated the viscosity curve and particle size distribution of sol-solution, and analyzed the reason of catalyst dosage effects particle size of gel, and confirmed that the up-growth of gel follows the theory of " polymerize increase ".The experiment results indicated that ultrasonic with unvarying temperature disposal shortened gel time and optimized quality of gels, and the factors of ultrasonic effect gel reaction velocity were analyzed; Prepared organic aerogels using compounds of resorcin and hydroquinone substitute resorcinol reacts with formaldehyde the first time, and also optimized the proportion of resorcinol and hydroquinone (the proportion of hydroquinone in 10%～40%).

采用溶胶-凝胶工艺结合动态溶剂交换、CO2超临界流体干燥与程序升温碳化方法制备出性能优良、具有纳米网络结构的RF与CRF气凝胶；深入研究了反应物配比催化剂用量等条件对凝胶过程的影响，得到了较佳的RF凝胶制备条件(RF浓度应大于2%，R/C值取50～300)；初步研究了凝胶过程中的粘度、粒径变化情况，分析了催化剂用量影响凝胶中粒子尺度的原因，在实验上印证了凝胶生长遵循"聚增长"的理论；通过引入超声波改进了RF气凝胶的制备工艺，缩短了凝胶反应时间，提高了凝胶品质，并探讨了超声波促进RF凝胶反应作用的原因；首次用对苯二酚与间苯二酚复配制备了混合有机气凝胶，优化出复配比(对苯二酚含量为10%～40%)。2。

Ones this guar gum is a kind of purely natural vegetable gule,has stronger gluey function.Hydroxyl third base guar gum is got through modifying in chenistry by the guar gum powder,has a lot of excellent characteristics,water insoluble matter and residue is also less than the former pomer,applied in a extensive ronge.

瓜尔胶是一种纯天然植物胶，具有较强的增粘作用，羟丙基瓜尔胶是有瓜尔胶粉经化学改性后得到的，忽悠许多优异特性，水不溶物及残渣均较瓜尔胶原粉有较大幅度的降低，应用范围广泛。

Of the three binding modes, the intercalative binding is thought to be the strongest binding because it is a type of binding caused by the intercalative molecule plane sandwiched between the aromatic heterocyclic and base group pairs of DNA.

本论文的主要目的是在研究鬼臼金属配合物和铁/锰原子簇化合物与DNA相互作用的基础上，采用紫外光谱、荧光光谱、凝胶电泳和粘度测量等多种研究手段研究了其与DNA的相互作用。

Of the three binding modes, the intercalative binding is thought to be the strongest binding because it is a type of binding caused by the intercalative molecule plane sandwiched between the aromatic heterocyclic and base group pairs of DNA.

本论文的主要目的是在研究鬼臼酰肼金属配合物和铁/锰原子簇化合物与DNA相互作用的基础上，采用紫外光谱、荧光光谱、凝胶电泳和粘度测量等多种研究手段研究了其与DNA的相互作用。

The result indicated that, gathers in advance the emulsion water resistance and mechanics performance which in the body preparation method the one-stage process obtains is good, but two steps obtain the emulsion stability is good; The neutralizaing agent triethylamine amount used should enable to achieve neutral between x-y, to gathers in advance the body disperser and the emulsion stability only then is advantageous; The water affinity chain extendor DMPA content to the emulsion viscosity, stable and the emulsion cellophane water resistance has the remarkable influence, its amount used general control between x-y; Hard section isocyanogen diethylene glycol dinitrate primary control paint film degree of hardness, module, anti-avulsion, wear-resisting and so on performance, the soft section low-molecular polymer polyols primary control paint film elasticity, hydrolisis performance and so on bears the low temperature and bears

结果表明，预聚体制备方法中一步法得到的乳液的耐水性和力学性能较好，而两步法得到的乳液的稳定性好；中和剂三乙胺的用量应使中和度达到x-y之间，对预聚体的分散和乳液的稳定性才有利；亲水扩链剂DMPA的含量对乳液的粘度、稳定性及乳液胶膜的耐水性有着显著的影响，其用量一般控制在x-y之间；硬段异氰酸酯主要控制涂膜的硬度、模量、抗撕裂、耐磨等性能，软段低聚物多元醇主要控制涂膜的弹性、耐低温和耐水解等性能

The findings of the newly identified goose paramyxovirus strain GPMV/HBexperimental infection were as follows: The challenge caused high morbidity and highmortality.The clinical signs included severe depression, decreased appetite or anorexia,white,yellow and green diarrhea, with neural symptoms;pathological changes showed thathaemorrhage and ulceration of intestine mucosa, necrosis of spleen and pancreas,andedema of liver and kidney, uratic deposition in kidney.Eosinophilic inclusion bodies werefound in the cytoplasm of pancreas and a large quantities of fiber protein were found inintestine. Lots of hemosidefin was found in some area of liver and kidney. A number ofT、B lymphocytes reduced sharply in spleen,lymph nodes in dead geese. Transmissionalelectron microscope showed that some cells had the morphological characteristics ofmitochondria swelling, morphological changes were condensation of nuclear chromatininto dense masses,followed by its marginating against the nuclear envelope, andespecially concentration of cytoplasm association with lots of lipid droplet.

人工感染雏鹅实验中，雏鹅临床表现为高发病率和高死亡率，食欲和饮水减少，拉白色、黄绿色稀粪，伴有神经症状；常规组织学观察，脾脏和胰腺肿大，有白色坏死斑点，肠道出血和坏死，肝脏肿大变性，肾脏肿大变性有尿酸盐沉着等；用特殊染色和组织化学方法首次对人工感染鹅副粘病毒的雏鹅的重要脏器进行研究，结果表明：胰腺中发现病毒包涵体，肠道中大量纤维素以及胶原纤维增生，肾脏、肺脏大量含铁血黄素沉着，免疫器官如脾脏和淋巴结中T、B淋巴细胞大量减少；电镜下多种细胞呈现线粒体水肿，多种实质细胞的染色质固缩，染色质边集，特别是细胞内容物如脂肪滴增多的病理变化特征。

The fast setting adhesive(HT-88)for GFRP was compounded from the prepolymer,low molecular polyamide,phenol aldehyde epoxy resin,bisphenol F type epoxy resin,liquid carboxylated butadieneacrylonitrile rubber,promotor,diluent and fillers.Its pot life,gelling time (at 60 ℃),glass transition temperature and shearing strength for bonding the unsaturated polyester GF...

该预聚物与低分子聚酰胺、酚醛环氧树脂、双酚F环氧树脂、液体羧基丁腈橡胶、促进剂、稀释剂、填料等复配的快固玻璃钢胶粘剂(HT - 88)，在室温下的适用期为 30～ 4 0min ，6 0℃的凝胶时间为 10min ，玻璃化温度 16 0℃，粘接不饱和聚酯玻璃钢的剪切强度为 5～ 7MPa。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。