胶的
- 与 胶的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Key components installed ink, adjust the blade support shaft section of copper Cap nut, the blade front-end on either side of half-round slot is placed in the kuyto specialadhesive Groove at the antileakage gum, tighten the screws, the installation is complete with rubber extrusion antileakage blade, the two-blade antileakage glue between the slot from semicrcular extpuded, producing gum in the column so that you can more effectively prevent ink seepage.
在安设不朱键组件时,调动不朱刀支架轴段的铜螺帽,不兵不朱刀前端两侧的半圆槽安插在托不活胶槽处的防漏胶上,拧不松变动螺丝,安设达成后用不朱刀挤压防漏胶,不兵两不朱刀之间的防漏胶从半圆槽洋挤出,爆发胶柱,这样不离可以更灵验不天避免油不朱渗漏。
-
According to the analysis of the deposit from the pressurized screen before the wire section in Nanping Paper Mill, polyvinyl acetate, polyacrylate and the wood lipophilic extractives were taken as the representatives of the deposit, but their content in the deposit was only about 5%.
本文通过对造纸厂胶粘物的分析,确定了胶粘物的根本来源,分别选取了合适的模型物研究胶粘物沉积的各种因素以及胶粘物各组分之间的相互作用,根据所研究的胶粘物的沉积机理,提出胶粘物控制的方法。
-
So, by the Diels-Alder reaction of tetraphenylcyclopentadienone, acenaphthenecyclone and benzophenanthrenecyclone with the vinyl groups in C gum, three kinds of polymethylvinylsilicone oil with condensed aromatics are synthesized respectively: polymethylvinylsilicone oil with tetraphenylphenyl groups (called C_1 gum for short), polymethylvinylsilicone oil with acenaphthenyl groups (C_2 gum) and polymethylvinylsilicone oil with benzophenanthrene groups (C3 gum).
根据此原则,利用四苯基环戊二烯酮、苊式环戊二烯酮和菲式环戊二烯酮与C胶上的乙烯基进行Diels—Alder反应,分别合成了三种含稠环基团的乙烯基硅油:四苯基苯基乙烯基硅油(C_1胶),苊式多苯基苯基乙烯基硅油(C_2胶)和菲式多苯基苯基乙烯基硅油(C_3胶),并根据~1HNMR谱图上不同氢原子的积分面积计算了三种胶中稠环基团和乙烯基的含量。
-
Want the skin to still can produce new collagen only, cuticular collagen is enzymatic build in responsible compose crudely collagen while also adjust of skin collagen form; Cut generation collagen is enzymatic.
只要皮肤还能产生新的胶原质,表皮胶原酶就在负责构建未成熟的胶原质的同时也调节皮肤胶原质的形成;伤口产生胶原酶。
-
Ones this guar gum is a kind of purely natural vegetable gule,has stronger gluey function.Hydroxyl third base guar gum is got through modifying in chenistry by the guar gum powder,has a lot of excellent characteristics,water insoluble matter and residue is also less than the former pomer,applied in a extensive ronge.
瓜尔胶是一种纯天然植物胶,具有较强的增粘作用,羟丙基瓜尔胶是有瓜尔胶粉经化学改性后得到的,忽悠许多优异特性,水不溶物及残渣均较瓜尔胶原粉有较大幅度的降低,应用范围广泛。
-
The effect of the SDT/S on the properties of NR compound was investigated The results showed that SDT/S plays the advanced role in NR compound,in order to keep the vulcanizate properties level as before may decrease some accerlator;the physical properties of overcured vulcanizate,the adhesion strength of optimum cure or overcured valcanizate between rubber and cord were improved by adding 2 phr of SDT/S to NR compound.
研究了SDT/S对天然胶胶料配方各项性能的影响。结果表明:在配方中使用SDT/S,对天然胶胶料起硫化促进作用,为保持原水平的硫化特性,可以适当减少促进剂的用量;可有效提高胶料过硫化条件下的300%定伸应力、扯断强度、邵氏硬度、撕裂性能、磨耗性能,可有效提高正硫化或过硫化条件下的胶料与帘线间的附着力。
-
Compared with G1 synthesized from 1,2,4,5-benzene tetracarboxylic acid and 4hydroxy pyridine at molar ratio of 1:2,G2 gelled water at higher minimum gelator concentration and gave the gel with lower gel-to-sol dissociation temperature at the same concentration.
相对于在摩尔比1:2条件下,由均苯四甲酸和对羟基吡啶合成的凝胶因子G1,在相同浓度下,G2在更高的最低凝胶因子浓度使水凝胶,并且得到的凝胶具有更低的凝胶-溶胶破坏温度。
-
The hydrophobic monomers such as glycidyl octyl dimethylammonium chloride, glycidyl dodecyl dimethylammonium chloride, glycidyl tetradecyl dimethylammonium chloride was applied to the hydrophobic modification of two kinds of sodium cellulose sulfate in isopropyl alcohol under 65℃.The success of synthesis of a kind of novel amphoteric surfactant by FT-IR and NMR. 3. By the measuring surface tension of all kinds of amphoteric polymeric surfactants based on cellulose, the critic micelle concentration was obtained such as 0.4wt%、0.3wt%、0.25wt% and corresponding surface tension was about 30mN/m
通过动态接触角测量仪确定了各种纤维素表面活性剂的表面张力和临界胶束浓度,结果表明该类表面活性剂可与小分子表面活性剂的降低表面张力的能力相媲美,最低可达28.41 mN/m,随着疏水基中碳链的增长,降低表面张力的能力下降,而临界胶束浓度从0.4wt%相应降低0.25wt%;应用环境扫描电镜确定其不同浓度胶束形态,结果表明在较低浓度下形成棒状单分子胶束,随着浓度的升高,单分子胶束逐渐聚集成树枝状胶束,进一步提高浓度,则聚集成网状结构;此外,采用了高级流变仪对其溶液的流变性质进行了研究,结果表明其溶液属于剪切变稀流体,是高分子溶液特有的性质。
-
Successive steps include adding a concentrated heat reversible gel solution (5) to the flask to cover the critical pattern surfaces (13), and cooling the gel solution to form an elastic solid gel mold (7). The gel mold (7) has critical gel mold surfaces inverse to the critical pattern surfaces.
接下来的步骤包括向烧瓶中加入一个高浓度热可逆凝胶溶液(5)覆盖型面(13),和将凝胶溶液冷却形成一个弹性的固体凝胶铸型(7),凝胶铸型(7)具有与模样型面相反的凝胶铸型型面。
-
The morphological structure of cured vinyl-ester resin and the formation of two-phase structures in vinyl-ester resin has been studied by using SEM and differential scanning calorimetry.The results demonstrated the existence of clusters of gel-particles with a size of about 20 μ m,each cluster of gel-particles containing many gel-particles with coral-like structures.The formation of gel-particles resulted in two-phase structure characterized by the two peaks in the rescanned DSC thermographs of the resin. The cure conditions (temperatures,post-cure) affected microstructure in the cured resins.
采用SEM、DSC研究了乙烯基酯树脂固化过程中凝胶粒子的形成过程及两相结构对固化放热的影响,结果表明,凝胶粒子在固化树脂中呈群状分布,每群凝胶粒子的最大尺寸为20μ m左右,每群凝胶粒子由许多独立凝胶粒子组成;凝胶粒子的形成使树脂产生了两相结构,使树脂的恒温DSC残余放热呈双峰分布;树脂的固化条件影响其微观结构。
- 推荐网络例句
-
I didn't watch TV last night, because it .
昨晚我没有看电视,因为电视机坏了。
-
Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.
今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。
-
I'm running my simile to an extreme.
我比喻得过头了。