胶性

During the fracturing for low pressure and low permeability gas reservoirs, there are some main problems in conventional hydroxypropylguar - organic boron cross-linking system: Firstly, the water-lock damage to low pressure and low permeability gas formations by filter liquor; Secondly, the reason for alkali-sensitive damage in alkali-sensitive reservoirs is that conventional hydroxypropylguar - organic boron cross-linking fracturing fluids were cross-linked under alkaline environment, while the permeability of reservoirs is reduced greatly; Thirdly, the formation pressure is low, and the energy of flow back is not enough, at present, the main measure in oil fields is "injecting with liquid nitrogen", but this technique increased the cost of fracturing, making great troubles in operating, and leaving the liquid nitrogen also is a big problem.

在低压低渗透气藏的压裂改造过程中，常规羟丙基胍胶-有机硼交联压裂液体系存在的主要问题，一是压裂液滤液对低压低渗透气层造成的水锁损害；二是常规羟丙基胍胶-有机硼压裂液是在碱性条件下交联的，对碱敏性储层造成碱敏损害，降低储层渗流能力；三是地层压力低，压裂液返排能量不足，当前各油田采取的措施主要是&液氮伴注&技术，但是&液氮伴注&技术增加了压裂的费用，而且液氮存放也存在较大问题。

Water type glue: Coating the water-soluble glue to the inside material evenly, and then laminate with the fabrics.

水性上胶：采用水溶性胶均匀地涂到里料上，然后与面料进行复合。

Several physical and chemical properties, such as pH, refractive index,heavy metal content, infrared spectrum, heat stability and residual acrylamide, were determined for medical-use polyacrylamide hydrogel samples.

医用聚丙烯酰胺是以丙烯酰胺为原料合成的，具有广泛用途的水溶性高分子，PAM水凝胶主要用于人体软组织填充[1，2 ] ，也可用于医药软膏、药膜和药物载体。医用PAM水凝胶的主要理化性能包括外观、pH值、折射率、重金属含量、红外光谱、化学热稳定性和丙烯酰胺单体残留量。

At the same time the sizing agents that cannot be easily hydrolysed sizing is made possible by the rapid speed.

同时该施胶剂不易水解，施胶迅速，速现性强。

The diffusion and cross—linking of polymer chains for blend latex particles were investigated by measurement of gel content,swell ratio and FTIR.The influences of different core／shell structure of blend latexes on mechanical properties of the films were described.

通过胶膜的凝胶率和膨胀率的测定和红外光谱分析对反应性复合乳液中乳胶粒子的扩散及交联反应进行了研究，并探讨了不同核壳结构复合乳液对涂膜机械性能的影响。

Because the direct roof of the No.92 ore-body is the backfilling of the No.91orebody which is the cementing materials or non-cementing materials, and there are no-filled mined-areas in someplace. So there are large-scale hidden troubles on the top of the No.92 slowly inclined large and thick ore-body, then we must find a new mining technology which aims at the complex mining condition of the No.92 ore-body. The cutting nature of the No.92 ore-body is very poor, so choosing the rational drilling and blasting parameters and enhancing the overall technological economic benefits are also the urgent problems waiting to be solved in the exploitation of the No.92 ore-body. The No.92 ore-body, thin lodes and the exploitation process of the No.91orebody influence each other, the geo-pressure phenomena aggravates obviously in case of the mined-areas increase constantly, and the geo-pressure problem will be more and more serious when the No.92 ore-body be exploited on a large scale in the next step.

由于它的直接顶板就是开采91号矿体时的胶结或者非胶结的空区充填体，部分地段甚至是未充填的采空区，使92号缓倾斜厚大矿体的上部形成大范围的隐患区，因此，必须针对92号矿体复杂的开采技术条件，寻找新的采矿技术与工艺。92号矿体的可凿性极差，选择合理的凿岩爆破参数，提高凿岩爆破工作的总体技术经济效益，也是92号矿体开采急待解决的问题。92号矿体与细脉带、91号矿体开采相互影响，目前在采空区不断增大的情况下地压显现有明显加剧的趋势，在下一步92号矿体大规模开采时，地压问题将越来越严重。

After treated in 4% paraformaldehyde,we applied Hematoxylin-Eosin and Nissl staining to exhibit the structure of the retinae and ganglion cells respectively,and also we used immunohistochemical ABC method to display the distribution of GFAP-immunoreactive cells that were specifically classified as the astrocytes.

E 染色以显示视网膜结构，Nissl染色显示神经节细胞，免疫组织化学ABC法染色以显示星形胶质细胞特征性标志物胶质纤维酸性蛋白的阳性反应细胞的分布。

For example, the organization of collagen .brils is largely responsible for transparency and refraction of cornea, lens and vitreous body, and collagens present in the sclera are largely responsible for the structural strength of the eye.

眼亮度主要归因于角膜、晶体、玻璃体的透光度和屈光度。胶原主要存在于巩膜，它是眼睛强度最高的组织。在种系发育中，不同物种中其大部分胶原具有高度保守性。

The softening point of = 209.151.250.170 700℃ of hotmelts, binding on resin coated products offers a new heat resistance.

软化点≥170℃的胶订热熔胶，对覆膜产品的抗热性提出了新要求。

EVA hotmelts is a solvent, watercut 100% solids can be self-fluxing ploymer, a solid at room temperature, heating melt enough to be able to flow in, and have a viscous liquid, that is, the adhesive.

EVA热熔胶是一种不需溶剂、不含水100%固体的可熔性聚合物，在常温下为固体，加热熔融到一定程度成为能流动的、且具有一定粘性的液体，即胶黏体。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失