胶度

The results indicated that hydrogen bond and covalence bond were formed between PVA and TEOS through the sol-gel reaction.

结果表明PVA与无机相发生溶胶-凝胶反应生成氢键和共价键Si-O-Si，形成交联有机聚合物／无机杂化体系，使杂化膜的结晶度减少，控制了膜的溶胀，提高膜的溶解选择性能，但膜的溶胀减少会使通量有所下降。

With the feature that derma collagen extends, recombines and reproduces when the temperature reaches to 60℃-70℃, the skin gets tightened and wrinkles get removed.

利用真皮层胶原质在摄氏六十至七十度的温度时会产生收缩、重组和再生的特性，达到紧致肌肤、改善皱纹的效果。

The properties and structures have been investigated as well by X-ray diffraction, infrared absorption spectrum and differential thermal analysis. The solvent dilatability and gelation ability, viscidity and organic content have been tested.

以十六烷基季铵盐为有机化改性剂，用微波辐射加热的方法制备出了性能优良的有机膨润土，利用XRD、FT-IR、DTA等方法分别对合成的钠基膨润土和有机膨润土的结构进行了研究和表征；并初步测试了有机膨润土的溶胀性、凝胶性能、粘度和有机物含量。

The rheological characteristics of sol solution have been studied. It turns out that the relation of viscosity with temperature can be expressed by the relation μ=μ〓exp , and that the solution's rheological characteristics during the sol—gel transiton are as follows: at first the dilatant fluid changes to Newton fluid, then to pseudoplastic, and finally to gel.

本文对溶胶溶液流变特性进行了研究，结果表明：温度对粘度的影响可用Arrhenius方程来表示；随放置时间的增加，溶液由膨胀型流体向牛顿型流体转变，再向假塑性流体转变，最后成为凝胶。

A important conclusion is that fluvial-lacustrine, karst, diluvial, colluvial, glacial and outwash deposits, which formed between early Pleistocene and early middle-Pleistocene, have high cement degree, low permeability, high intensity, low deformation, and good engineering properties, but modern riverbed phase deposits, which formed in between late middle-Pleistocene and Holocene, are loose, highly permeable, weak, highly deformable and have bad engineer characteristics, so they are susceptive to differential settlement, piping, drafting, liquefaction problems.

得出早更新世—中更新世早期河湖相沉积、岩溶沉积、洪积、崩坡积、冰碛和冰水沉积密实度高，胶结较好，透水性差，强度高，变形小，工程性质较好，而中更新世晚期—全新世现代河床沉积较松散，渗透性高，强度较低，变形较大，易发生差异沉降、管涌、流土、地震液化等工程地质问题的重要结论。

Our primary work in this thesis is that, in view of the general holographic principle between gauge theories and gravity from string theory, we calculate the mass spectra of several typical QCD$_4$ glueballs in term of AdS$_6$ AdS-Schwarzschild black hole metric of Einstein gravity theory.

这篇毕业论文里，我们主要的工作是以弦理论中的规范理论和引力理论之间的广义全息原理为基础，根据爱因斯坦引力理论的AdS$_6$ AdS-施瓦茨黑洞度规计算了几个系列的QCD$_4$胶球质量谱。

During the course of electro form process, we got ideal electro form process condition that can get windings with uniform granule and high compactness, including current waveform, frequency, duty ratio and voltage to the windings ect. Affect of underlay's flatness to the electroform process are also analysed in detail. Compatibility between photoresist and electroforming solution is also solved.

在电铸工艺中，摸索出获得颗粒均匀、致密度高的金属绕组线圈的电铸工艺条件，给出了电铸电流的波形、频率、占空比及电极电压，并对衬底表面不平整度对电铸效果的影响进行了详细分析，解决了电铸过程中光刻胶与电铸液兼容性的问题。

During the course of electro form process, we got ideal electro form process condition that can get windings with uniform granule and high compactness, including current waveform, frequency, duty ratio and voltage to the windings ect. Affect of underlays flatness to the electroform process are also analysed in detail. Compatibility between photoresist and electroforming solution is also solved.

在电铸工艺中，摸索出获得颗粒均匀、致密度高的金属绕组线圈的电铸工艺条件，给出了电铸电流的波形、频率、占空比及电极电压，并对衬底表面不平整度对电铸效果的影响进行了详细分析，解决了电铸过程中光刻胶与电铸液兼容性的问题。

Film or paper surface dirty, and wrapped it into the dust or clear plastic mulch films after the crease or relaxation phenomena, film hemming switched to a new membrane drying temperature is too high, adhesive surface crust adjust oven temperature, clear crusts partⅱ thermotolerance cohesion and not enough use better glue wrinkle of polymer-coated film transfer after the roll is not the proper balance of films at both ends are inconsistent or wave; adjustment layer of polymer-coated machine too thick, solvent evaporation incomplete, viscosity, pressure drum extrusion, paper (Business card printing and membership card making products) and films between slide to adjust the film covering technology electrothermic roll and rubber roller ends is not plain, pressure is inconsistent, ranging from the adjustment of the linear speed of the machine after the temperature inside the plastic mulch film covering the subject in yellow glue resin particularly resin or additives not resistant to ageing, in the light, heat, under the influence of ultraviolet radiation, chemical change, build the pigments should be switched to a new glue

薄膜或纸张表面不干净，裹入灰尘或杂质清除后再行覆膜薄膜有折皱或松驰现象，薄膜卷边换用新膜干燥温度过高，粘合剂表面结皮调整烘道温度，清除结皮胶的粘接力和耐热性不够换用更好的胶水覆膜后起皱薄膜传送辊是否不平衡；薄膜两端松紧不一致或波浪边；调整覆膜机器胶层过厚，溶剂蒸发不彻底，影响了粘度，受压力滚筒挤压，纸张与薄膜之间产生滑动调整覆膜工艺电热辊与橡胶辊两端不平、压力不一致、线速度不等调整覆膜机器覆膜后易变黄胶水中的主体树脂特别是一些增粘树脂或助剂不耐老化，在光、热、紫外线的影响下，发生化学变化，生成有色物质应换用新胶水

The present work shows that the hydrothermal method is superior to the sol–gel method since it may facilely obtain high purity, better crystallinity and uniform morphology lithium niobate powders.

目前的工作表明，水热法优于溶胶-凝胶法，因为它可能facilely获得高纯度，更好的结晶度和均匀形态铌酸锂粉末。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失