胶

The GFAP is a specific marker of astrocyte, its expression is more higher in the activity astrocyte, and finally the GFAP become the main composition of scar formations. The S -100 is a kind of acidity, dissolubilites, low molecular quantity and calcium hydronium conjugated protein, and it is mainly existed in neuroglial cell and schwann cell. It can promote the growth of axon, glial hyper-plasia and nerve divide and calcium's stability inside of cell, thus regulatin g the shape and metabolism of astrocyte . The quantity of S -100 protein and the degree of ischemia have direct proportion .

胶质纤维酸性蛋白是星形胶质细胞的特异性标记物，在活性星形胶质细胞中GFAP的表达相对更高，且最后GFAP成为胶质疤痕的主要成份。S-100蛋白是一种酸性、可溶性、低分子量的钙离子结合蛋白，主要存在于胶质细胞和雪旺细胞中，它可促进轴突生长、胶质增生、神经分化和细胞内钙的稳定，从而调节星形胶质细胞的形态和代谢。S-100蛋白与缺血的程度是成正比的。

The second part is for the calculation of the mass spectrum for two-gluon glueballs by using Bethe-Salpeter equation. Our results are in good agreement with those given by lattice simulation and confirm that the lightest glueball is scalar with mass about 1. 7GeV, the mass of tensor glueball is about 2. 4GeV, the masses of pseudoscalar glueball and 2〓 not less than 2. 0GeV.

二是利用Bethe-Salpeter方程计算了双胶子胶球的质量谱，结果与最近的格点规范计算符合得很好，进一步肯定了标量胶球是最轻的胶球，质量约为1.7GeV；张量胶球的质量约为2.4GeV；而赝标胶球和胶球2〓的质量不小于2.0GeV。

With reading a mass of the documents about the rolling resistance and wet anti-grapping, there are 11 types semisteel belt tyres formularies designed in this paper by changing carbon black and SBR1502/SBR1712/BR9000 blending ratio, which answer for the actual demands of the tyre industry and have a certain extent engineering practicability.The DMA curves of 11 types tread rubber materials used in tires with the changes of temperature have been obtained by using Dynamic Mechanics Analysis technique on NETZSCH DMA242 instrument.

本文采用动态力学分析法，使用NEZSCH公司生产的DMA242型实验仪，获得了11种胎面胶的DMA温度曲线，从炭黑和生胶配比变化两方面，分组对不同系列的胎面胶的储能模量—温度曲线和损耗因子—温度曲线进行了分析比较，并参照1#胶料，对11种胎面胶—10℃～10℃和50℃～80℃的tanδ进行比较，讨论了炭黑及SBR1502/SBR1712/BR9000并用比的改变对胎面胶滚动阻力、湿抓着力的影响；在动态力学分析实验的基础上，还获得了11种胎面胶的生热率曲线，并分组进行了比较，研究了配方与生热率的关系。

Plastic should lower 3 steps, because plastic is a step to add meltresin material to cyclinder , Higher stick of resin material ,higher screwback pressure. Screw speed differs depending on decomposing temperatureof resin material ,Higher screw speed ,Higher trim force of resin,higher cyclinder temperature. Some resin material may decomposes so it setscrew speed in mid-speed such as 45-75%, In plastic step setting screwback pressure is very important, Higher screw back pressure ,higherquality of product screw back pressure make resin structure order, Moldingproduct is beautiful and volume stable. But ,it maybe flow if screw

再复杂的熔胶旋转过程最多不会超过三段，因为熔胶本身就是存在于把胶熔进料筒的过程，如果原料粘度大，熔胶压力则大，但速度则应取决于原料的分解温度，熔胶速度越快，原料中的剪切力则会越大，料管温度则越高，局部原料产生分解的可能性则会越大，故一般熔胶会采用中速为宜，如45%-75%，熔胶同时会碰到一个比较重要的环节，那就是背压的使用，产品精度要求越大，背压的使用则更大，背压可使原料分子间结构更紧密，成型出的产品则尺寸更稳定，外观越好。

Carrageenan stability is very good, even if the long-term place will not reduce its gel strength and viscosity, in neutral and alkaline solution even if the heating or hydrolysis, carrageenan and konjac gum, locust bean gum, yellow The original plastic, such as colloidal shared use, can play a significant synergies can significantly change the characteristics of gel, gel flexible and retention.

卡拉胶的稳定性非常好，即使长期放置也不会降低其凝胶强度和粘度，在中性和碱性溶液中即使加热也不水解，卡拉胶与魔芋胶、刺槐豆胶、黄原胶等胶体共用使用，可发挥显著的协同增效作用能明显改变其凝胶特性、使凝胶富有弹性和保水性。

The PAM and the Sesbania Gum were applied as gelling agent in the gel system of water-gel explosive and the effects of amount of gelling agent, amount of crosslinking agent, reaction-temperature and reaction time on the crosslinking time and thermal stability were researched.

并分别将产物聚丙烯胺和天然植物胶田菁胶作为胶凝剂，应用于水胶炸药凝胶体系中。研究了胶凝剂用量、交联剂用量、反应温度和反应时间对水胶炸药成胶时间和热稳定性的影响。

The PAM and the Sesbania Gum were applied as gelling agent in the gel system of water-gel explosive and the effects of amount of gelling agent, amount of crosslinking agent, reaction-temperature and reaction time on the crosslinking time and thermal stability were researched.

并分别将产物聚丙烯酰胺和天然植物胶田菁胶作为胶凝剂，应用于水胶炸药凝胶体系中。研究了胶凝剂用量、交联剂用量、反应温度和反应时间对水胶炸药成胶时间和热稳定性的影响。

The results showed that,when environment-friendly oil KT20 was used in NR and NR/BR compound,the properties of mix,physical properties and wet skid resistance of vulcanizate were similar to those by using the comparison samples;by using environment-friendly oil KT20,the rolling resistance of vulcanizate changed slightly compared with using 3527MES and TADE.

结果表明，在NR和NR/BR胶料中，填充环保油KT20与对比油的混炼胶性能、硫化胶的物理性能和抗湿滑性能相当；填充环保油KT20，3527MES和TDAE硫化胶的滚动阻力相差不大。在NR胶料中填充环保油KT20，硫化胶的耐磨性能优于对比油硫化胶。

Data indicate that wetting property of self-bonding fiberboard is better than MDF, that wetting property of sanded surface of self-bonding fiberboard made with Method I is inferior to that of unsanded fiberboard, but opposite results to the comparison between sanded surface of self-bonding fiberboard made with Method II and unsanded surface, and that self-bonding fiberboard without waterproof agent has better wetting property than that with waterproof agent.

结果表明：(1)无胶木材纤维纤维板的润湿性比中密度纤维板好；(2)利用无胶纤维板工艺1制作的无胶板砂磨表面的润湿性比未砂磨表面润湿性差，但用无胶纤维板工艺2制作的无胶纤维板的砂磨表面润湿性比朱砂表面润湿性好；(3)未加防水剂的无胶纤维板的表面润湿性比加防水剂的无胶纤维板的润湿性好。

I mainly have the following products: a calcium oxide, calcium phosphate, DCP, polydextrose, thorn Indus gum, locust bean gum, plastic-looking son, flaxseed gum, guar gum, xanthan gum, Carrageenan, konjac gum, CMC, casein, citric acid, sorbitol, VC sodium, salt and sodium phosphate, and other pharmaceutical intermediates!

我公司主要经营产品：过氧化钙、磷酸三钙、磷酸氢钙、聚葡萄糖、刺梧桐胶、刺槐豆胶、罗望子胶、亚麻籽胶、瓜尔豆胶、黄原胶、卡拉胶、魔芋胶、CMC、干酪素、柠檬酸、山梨醇、VC钠，磷酸钠盐及医药中间体等！

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了