背侧的

The MBOA content on the irradiated side of the coleoptile was 1.5 fold more than that on the shaded side.

在单侧蓝光作用下，胚芽鞘向光侧的生长抑制物质6甲氧基2苯并唑啉酮含量比背光侧多1.5倍。2。

In normal group and sham lesion group, BDA positive neurons were distributed symmetrically in the pyramid cells of sensorimotor cortex, and BDA positive fibers of pyramid cells passed through the cerebral cortex, internal capsule, cerebral peduncle of midbrain, basilar portion of pons to the pyramid of medulla oblongata. At the lower part of the medulla oblongata, most of the BDA positive fibers passed through the pyramidal decussation to the contralateral side, continously descended at the ventral part of posterior funiculus just dorsal to the posterior gray commissure and ended at sacral spinal segments.

正常组和假损伤组大鼠BDA示踪显示BDA标记阳性细胞定位于双侧感觉运动皮层的锥体细胞，锥体细胞发出的BDA阳性纤维束对称分布于双侧皮层、内囊、大脑脚、脑桥基底部、延髓锥体中的皮质脊髓束内，继而经锥体交叉到脊髓后索，在双侧后索最深层、灰质后连合背侧下行至脊髓骶段。

From 136 to 138, the expres- sion retrieved ventrally and expressed at the ventral half of the central tube (137) and the ventral horn especially in motor neurons (E7 and E8). Thus, the dorsal terminating axons relating to nociception and thermore?

到民至 Es麻Sema 3A的mRN的表达向腹侧撤退，主要在脊髓中央管周围的腹侧和前角运动神经元，这样使背侧投射性的痛温觉神经元轴突仅进入脊髓后角第 I、11层而不进一步向腹侧投射。

The CGRP-positive fibers in the MrD of the striatum connected dorsally with the bed nucleus of the stria terminals through the stria terminals, ventrally with the amygdaloid nucleus, and caudally with the CGRP-positive cell bodies in the lateral part of the substantia nigra and its dorsolateral area.(4) The CGRP-positive fibers connected mainly with the central amygdaloid nucleus, and less with the medial amygdaloid nucleus; the CGRP-positive fibers in the lateral border of the caudate putamen connected mainly with the central amygdaloid nucleus as well.

并与边缘区的CGRP阳性纤维带之间存在较多的横向联系纤维；（3）纹状体边缘区的CGRP阳性纤维向背侧通过终纹与吻侧的终纹床核联系，向腹侧与杏仁核的CGRP阳性纤维相连，向尾侧和中脑黑质外侧部及其背外侧区的CGRP阳性胞体相连；（4）边缘区的CGRP阳性纤维主要与杏仁中央核相联系，少量与杏仁内侧核相联系；尾壳核外侧缘的CGRP阳性纤维也主要与杏仁中央核相联系。

As the deep fascia is incised, laterally retract the medial branch of the first dorsal metatarsal artery and the medial branch of the dorsomedial nere (a branch of the superficial peroneal nere), which supplies the medial side of the great toe.

切开深筋膜，将第一跖背动脉内侧支和背内侧神经的内侧支牵向外侧，从背侧分离筋膜至跖骨头内侧滑囊。

The descending one is the continuing of dorsal branch, it crosses the ulnar edge of the fifth metecarpal bone and anastomizes with the digital artery of little finger or hypothenar branch of deep palmar (accounted for 70%).

降支为腕背支的延续，经第5掌骨尺侧缘直达掌骨头颈处与小指动脉尺侧支或掌深弓小鱼际支相吻合占70%；降支至豌豆骨附近变为纤细，由小指动脉尺侧支或掌深弓小鱼际支上行与之吻合占30%；吻合外径(0.5±0.1) mm。

RESULTSThe branches of aortic arch are the left and right innominate artery in pate of mini-pig.

结果小型猪主动脉弓部向头颈部分支为左、右无名动脉；双侧颈内动脉均来自右无名动脉，故右无名动脉对脑底供血十分重要；双侧有沿脊柱向尾侧走行的折返动脉；胸主动脉背侧由胸6至胸14平面共发出8条肋间动脉，为胸腰脊髓的主要供血动脉；无腰大动脉。

Results: The thickness of intertransverse ligament was about 0.60~1.39mm.

结果：横突间韧带厚度0.60~1.39mm；L(下标 3-5)节段动脉前支及伴行静脉90%以上位于相邻横突间韧带腹侧上1/2处，横突间韧带背侧中1/3处有一恒定节段动脉分支；腰神经前支与矢状面夹角18.90°~39.20°，下位横突的副突处距前方走行腰神经前支距离为5.63~8.05mm，椎弓峡部侧缘至腰神经前支的距离为1.73~3.64mm。

In case of a total en bloc resection of one or more high thoracic vertebrae, we start with a dorsal approach by exposing the affected spinal segments, cut and remove rib ends bilaterally, perform one or multilevel laminectomies and bilateral foraminectomies and facetectomies, followed by an incision and reaming of the intervertebral discs at the appropriate levels.

假设要做一个或多个高位胸椎椎体的整块切除，我们采用背侧入路显露病变节段，切除双侧肋骨末端，行一节或多节段椎板切除，双侧椎间孔及小关节切除，继以相应节段椎间盘切除和刮除。

Methods We designed the dorsal reverse carpal and metacarpal island flaps with nerve by using the adjacent two dorsal metacarpal arteries as bloodsupply and applied the stand of bone and tendon in waste finger or the free iliac transplantation to reconstruct the every sensory finger.

设计两条相邻掌背动脉及带掌背神经的腕掌背侧逆行岛状皮瓣，利用废弃手指的骨肌腱支架，或游离骨骼移植，再造有感觉的手指。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐