聚酰胺

The melt extrusion mixtures do not include certain additives such as polyoxy- alkylene compounds, alkylmonoethonolamide compounds, alkyldiethanolamine compounds and polyetheramide compounds.

熔体挤出混合物不包括某些添加剂如聚氧化烯化合物、烷基单乙醇酰胺化合物、烷基二乙醇胺化合物和聚醚酰胺化合物。

Ingredients: Rose oil, rose fruit Oil, clove flower oil, deionized water, isopropyl myristate, glycerol, propylene glycol, polyethylene glycol -400, central PDMS, poly dimethyl siloxane, PDMS alcohol, polyacrylamide, C13-14 iso-paraffin, octoic acid / capric Acid Triglyceride, lauryl alcohol -7, hydroxyethyl acrylate, acryloyldimethyltaurate copolymer, squalane, poly sorbate esters -60, PEG-20 sorbitan laurate, panthenol, allantoin, methyl p-hydroxybenzoate, diazolidiny1 urea, 3-iodo-2-propynyl-butyl-carbamate, essence.

产品成分：玫瑰精油、玫瑰果油、丁香花油、去离子水、肉豆蔻酸异丙酯、甘油、丙二醇、聚乙二醇-400、环聚二甲基硅氧烷、聚二甲基硅氧烷、聚二甲基硅氧烷醇、聚丙烯酰胺、C13-14 异链烷烃、辛酸/癸酸甘油三酯、月桂醇醚-7、羟乙基丙烯酸酯、丙烯酰二甲基牛磺酸钠聚物、角鲨烷、聚山梨酸酯类-60、PEG-20 失水山梨醇月桂酸酯、泛醇、尿囊素、对羟基苯甲酸甲酯、双咪唑烷基脲、碘代丙炔基丁基甲氨酸酯、香精。

LIN Hailin,CUI Yingde,DU Lin,CHEN JianpingInstitute of Applied Chemistry,Zhongkai University of Agriculture and TechnologySuper water absorbent resins P,SA/NaAA,SA/NaAA/PVA and SA/NaAA/AM were synthesized from sodium alginate,acrylic acid,polyvinyl alcoholand acrylamide,with N,N–methylenebisacrylamide as crosslinking agent,(NH4)2S2O8 - NaHSO3 as initiator,by means of aqueous solution polymerization.

以醚化海藻酸钠、聚乙烯醇、丙烯酰胺、丙烯酸为单体，N， N–亚甲基双丙烯酰胺为交联剂，过硫酸铵-亚硫酸氢钠为引发剂，采用水溶液法制备聚丙烯酸钠p吸水树脂和海藻酸钠/丙烯酸钠、海藻酸钠/丙烯酸钠/聚乙烯醇（SA/NaAA/PVA）及海藻酸钠/丙烯酸钠/丙烯酰胺吸水性复合树脂。

In this paper the emulsion of polyacrylamide was synthesized in the polyglycol solutions, acryl amide and acrylic acid sodium was used as the monomer. In more detail, we investigated the effect of the concentration of the monomers, the ratio of monomer and PEG, the ratio of monomers, temperature, and emulsifier on the stability of the HPAM emulsion and the molecular weight of the HPAM.

为了提高聚丙烯酰胺相对分子质量，以丙烯酰胺与丙烯酸钠为原料，在聚乙二醇水溶液中合成了聚丙烯酰胺水包水乳液，考察了初始单体质量分数、共聚单体与聚乙二醇摩尔比、共聚单体摩尔比、聚合反应温度、乳化剂种类及其浓度对HPAM水包水乳液稳定性及相对分子质量的影响，所得共聚产物相对分子质量可达1.5×10^7。

After centrifugation, the extracts were separated on HILIC column by using acetonitrile-water as mobile phase. The analytes were identified and quantitated by LC-tandem MS under the positive/negative electrospray ionization and multiple reaction monitormode. The calibration curves showed good linearity in the range of 25-5000 μg/kg for melamine and cyanuric acid, and 50-10000 μg/kg for ammeline and ammelide. The limits of detection and limits of quantification were in the range of 5-20 μg/kg and 50-100 μg/kg, respectively.

牛奶样品直接用乙腈超声波提取；奶粉样品先用水溶解后再加乙腈超声波提取，高速离心后以乙腈－水为流动相，采用亲水作用色谱柱分离这4种化合物，在电喷雾正、负电离切换多反应监测模式下进行定性与定量分析，三聚氰酸一酰胺与三聚氰酸二酰胺含量在50~10000μg/kg之间、三聚氰胺与三聚氰酸在25~5000μg/kg之间，均获得良好的线性。

Result of thermogravity analysis showed that the thermal stability of polyvinylamine chloride lowers with increasing in amination degree. Moreover, properties of dilute aqueous solutions of three types of poly chloride with different amination degree were compared by use of viscosimetric, conductometric, and potentiometric measurements. Results showed that both the electrostatic interaction of neighboring groups on the chain and the reduced viscosity of poly chloride are increased with increasing the degree of amination of poly . The equivalent conductivity is decreased with the increasing the concentration of poly chloride and increased with the increasing the amination degree of poly .

研究了聚乙烯胺盐酸盐的热稳定性和水溶液性质，发现：随着胺化度的提高，聚乙烯胺盐酸盐的对热稳定性逐步降低；聚乙烯胺盐酸盐是一种典型的聚电解质，其水溶液的pH值随平均分子量的变化并不明显，而随着聚乙烯胺胺化度的升高，pH值降低；随着聚乙烯胺盐酸盐的平均聚合度由82.3增加到201.8，它的m值（用于表征聚电解质侧链基团之间相互作用大小的常数）从5.13升高到5.58，而当聚乙烯胺盐酸盐的平均聚合度增加到311.4时，它的m值反而降低到了5.48；随着胺化度由55.65%升高到82.36%，m值由3.65提高到5.50；随着聚乙烯胺盐酸盐的平均聚合度的提高，聚乙烯胺盐酸盐的平均解离常数由7.48降低到7.26，同时随着胺化度的提高，聚乙烯胺盐酸盐的平均解离常数也由8.33降低到7.37；随着聚乙烯胺盐酸盐浓度的提高，溶液的摩尔电导率逐步降低，随着聚乙烯胺胺化度和聚合度的提高，溶液的摩尔电导率有所升高；在pH值为4左右时，聚乙烯胺盐酸盐的比浓粘度分别达到极值，而与聚合度的大小关系不大；聚乙烯胺盐酸盐的特性粘数明显高于其原料聚丙烯酰胺的特性粘数，分子量对特性粘数的影响十分明显，胺化度对特性粘数的影响并不显著。

Water, Sodium Laureth Sulfate, Cocamidopropyl Betaine, Cocamide MEA, Disodium Cocamphodiacetate, Sodium Lauryl Sulfate, PEG 40 Hydrogenated Castor Oil, Perfume, Sodium Chloride, Propylene Glycol, Quaternium 80, Methylparaben, Polyquaternium 10, Hydroxypropyl Guar Hydroxpropyltrimonium Chloride, Citric Acid, Diazolidinyl Urea, Tetrasodium EDTA, Polyquaternium 7, Propylparaben, Sodium Hydroxide, Panthenol, Persea Gratissima Oil, Penta Sodium Pentetate, Hedera Helix Extract, Bambusa Vulgaris Extract

水，月桂醇聚醚硫酸酯钠，椰油酰胺丙基甜菜碱，椰油酰胺MEA，椰油酰两性基二乙酸二钠，月桂醇硫酸酯钠，PEG 40 氢化篦麻油，香料，氯化钠，丙二醇，季铵盐-80，苯甲酸甲脂，聚季铵盐-10，羟丙基瓜尔胶羟丙基三甲基氯化铵，柠檬酸，重氮烷基咪唑脲，乙二氨四醋酸四钠，聚季铵盐-7，对羟基苯甲酸丙酯，氢氧化钠，泛酰醇，酪梨油，喷替酸五钠，常春藤萃取物，银竹萃取物。

In addition, the method for producing an amide-based polymer of the present invention is characterized by homopolymerizing the amide compound or by copolymerizing the amide compound and at least unsaturated monomer copolymerizable with the amide compound.

本发明的制备酰胺类聚合物的方法的特征在于均聚所述酰胺化合物、或共聚所述酰胺化合物和能与酰胺类化合物共聚的至少一种不饱和单体。

Further, the method for producing acrylamide of the present invention is characterized by hydrating acrylonitrile having a concentration of acrolein of 1 ppm or less by a microbial cell containing a nitrile hydratase or a processed product of the microbial cell in an aqueous medium.; Furthermore, the method for producing an acrylamide-based polymer of the present invention is characterized by homopolymerizing the acrylamide or by copolymerizing the acrylamide and at least one unsaturated monomer copolymerizable with the acrylamide.

本发明的制备丙烯酰胺的方法的特征在于，用含有腈水合酶的微生物的菌体或该菌体处理物使丙烯醛浓度为1ppm以下的丙烯腈在水性介质中进行水合反应。本发明的制备丙烯酰胺类聚合物的方法的特征在于均聚所述丙烯酰胺，或共聚所述丙烯酰胺和能与丙烯酰胺共聚的至少一种不饱和单体。

With the key product of acrylamide,it mainly produces varieties of polyacrylamide and its derivatives,polyacrylic acid and its multipolymer,water soluble polymer products such as polyamine and poly quaternary ammonium compound,super strong suction resin and fortified rubber,etc.

企业以丙烯酰胺系列为龙头，主要生产各种规格型号的聚丙烯酰胺及其衍生物、聚丙烯酸及其共聚物、聚胺和聚季铵化合物等水溶性高分子产品和超强吸水树脂、高苯乙烯橡胶等。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。