耐高温

Good effect: anti-oxidation at high temperature, anti-corrosion against sulphide and naphthene acid and anti- erosion.

效果好：抗高温氧化、耐硫化物、环烷酸腐蚀、耐冲刷性能稳定，传热性能好

This article studied migration,dispersing and achromatic property of salt-resistance levelling agent TF-212B on polyes- ter pongee under the existence of sodium sulphate.

选用春亚纺面料，在电解质元明粉存在的条件下，研究了耐盐高温匀染剂TF-212B对分散染料的高温分散性、移染性和消色性等染色性能的影响。

Because of this technology does not need the process of acid pickling and high temperature, there is no hydrogen embrittlement took place in the spare parts, and it possess a great deal of merits such as self-healing function after scotch, meanwhile it has hyper heat-resistance, hyper tonicity, hyper stickability, hyper anti-friction, hyper weatherability, hyper corrosion resistance, and when used outside, it can maintain its color for a long-period without change.

由于该工艺不经过酸洗和高温，所以零件无氢脆发生，擦碰伤后还有自愈合功能，同时还具有高耐热性，高渗透性，高附着性，高减摩性，高耐候性，高耐化学品腐蚀性。用在室外可长期保持不变色等诸多优点。

Meanwhile, the coated surface was hydrophobic with a contact angle of 107.2°since the introduction of methyl groups and methylene groups. Static immersing corrosion test, potentiodynamically polarization curve and electrochemical impedance spectroscopy were conducted to evaluate the film corrosion performances. The results of potentiodynamically polarization curve and EIS in 55wt% LiBr solutions at room temperature in atmospherical pressure indicated that the corrosion current density of BMBSE film coated surface was 4 orders of magnitude smaller than that of bare SUS304 steel, and the impedance was increased by a factor of 10000. Static immersing corrosion test presented that the BMBSE film can significantly increase the corrosion resistance in 55wt%LiBr solution at 180°C compared with stainless steels.

同时由于有机组分甲基和亚甲基的引入，结构均匀致密，并具有一定的疏水性；电化学测试结果表明BMBSE膜的极化阻抗比不锈钢大4个数量级，自腐蚀电流密度也下降低了4个数量级左右，具有良好的耐腐蚀性能；成膜的影响因素优化结果表明BMBSE、EtOH、D.I.water摩尔比为1∶4∶3，热处理温度为200℃时，更有利于制备结构均匀、致密、耐腐蚀性能好的薄膜；静态浸泡腐蚀实验结果说明，在180℃、55%的高温溴化锂溶液中BMBSE膜能起到良好的腐蚀防护作用。

Finally heat the starch to 80℃dextrinize 2h,keep warm 0.5h,then cooled to 40℃,add 2.8%CAN initiator,7.5%MMA monomer,sealed and stir 3.3hours of the nitrogen atmosphere,using the screw rod center distance is 32mm,expects the tube diameter phi300mm major axis compared to L/D is 12.5 double screw rods extruding machines,controls the screw rod rotational speed 100rpm sample water content when 20%squeezes out,and the results indictated that the sample may bear 302℃within the high temperature,the water resistance is 14.7%,buried in the simple earth passes through about 180 day to be allowed to achieve the nearly 60%weightlessness rate, and can be basically completely degrades.

因此将淀粉80℃糊化2h，保温0.5h，40℃添加2.8%引发剂，7.5%MMA单体，通氮气密封搅拌反应3.3小时后的接枝产物，利用螺杆中心距为32mm，料筒直径f300mm长径比L/D为12.5的双螺杆挤出机，控制螺杆转速100rpm样品含水量20%时挤出，测定知道样品可以耐302℃以内的高温，耐水性为14.7%，在简单土埋的情况下，经过180天左右可以达到近60%的失重率，可以说基本上完全降解。

Besides, The nodulation with else host experiment told us that NWGX035 could nodulate with melilotus suaveolens Ledeb, sophora alopecuroides Linn, lotus corniculatus Linn, sophora viciifolia Hance, trifolium repens Linn. The property of powerful salt, alkali, high temperature endurance and wide nodulation could confirm this strain was a particular strain. The nodulation mechanism and endurance of salt, alkali and high temperature mechanism need to be studied further.

另外，回接其它寄主植物的试验表明， NWGX035能与草木樨、黄化苦豆子、百脉根、狼牙刺和白三叶共生结瘤，其广泛的共生结瘤范围和强的耐盐、碱和抗高温特性可以证明该菌株为一株性状优良的菌株，其共生结瘤机制和耐盐碱机制需进一步研究。

Besides, The nodulation with else host experiment told us that NWGX035 could nodulate with melilotus suaveolens Ledeb, sophora alopecuroides Linn, lotus corniculatus Linn, sophora viciifolia Hance, trifolium repens Linn. The property of powerful salt, alkali, high temperature endurance and wide nodulation could confirm this strain was a particular strain.

另外，回接其它寄主植物的试验表明， NWGX035能与草木樨、黄化苦豆子、百脉根、狼牙刺和白三叶共生结瘤，其广泛的共生结瘤范围和强的耐盐、碱和抗(来源：A9fBC论文网www.abclunwen.com)高温特性可以证明该菌株为一株性状优良的菌株，其共生结瘤机制和耐盐碱机制需进一步研究。

Co104 (Co-based Stellite 4) for wear-resistant high performance, excellent high temperature and strong corrosion resistance.

Co104（司太立钴基4号）用于较高耐磨损性能，极好的高温强及耐腐蚀性能。

Large scale CFB boiler baker is a key process to make anti-erosion refractory s intering, shaping and attain its performance of heat resistance, pressure resist ance, erosion resistance, torsibility and shock-proof.

大型循环流化床锅炉的烘炉是使耐火耐磨材料烧结成型并使之达到耐火、耐磨、耐压、抗折、热震稳定性、高温耐压性能的关键。

It can withstand high temperature of 280℃ and is resistant to acids and alkalis.

可耐260°C的高温，并且耐酸、耐碱性能极佳，即使是腐蚀性很强的酸性食物，也不会腐蚀水槽。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。