耐热的

The sagger has small expansion coefficient, high thermal stability, good thermal shock resistance, suitable for the calcination of rare earth materials, battery materials and other materials.

堇青石结合锂辉石砂锅采用人工堇青石材料为主要原料，加入少量锂辉石作为熔剂性材料生产的日用耐热砂锅，膨胀系数小，抗热震性能好，使用寿命长，可生产高档次砂锅。

To ascertain heat tolerance of solanaceous vegetable plug seedling with vermieompost-based substrate, we determined chlorophyll content, antioxidant enzyme activities, permeation rate of electrolyte and malondialdehyde content in leaves of tomato, eggplant, pepper plug seedling.

为深入了解蚯蚓粪基质茄果类蔬菜穴盘苗的耐热性，以常规草炭系基质为对照，测定了番茄、茄子、辣椒穴盘苗叶片叶绿素含量、抗氧化酶(SOD、POD、CAT)活性、电解质渗出率和丙二醛含量等指标。

Sulfuric acid was sulphonation reagent, add the sulfuric acidquantity was 8%, reaction temperature was 60~65℃.The reaction occursbetween the feed oil and sulfuric acid,then add 30% of sodium hydroxidesolution conducted neutralization in the Pyrex standard react kettle,when the reactionfinished ,draw out the products by funnel,then the products react with 8%clay to refine received the sulphonation refining oil so as to review property andreceive rate of the shallow sulphonation refining oil .By the using the sulphonationrefining oil to blend lubricant,its quality is on-specification .

为验证其可行性，首先在实验室进行浅度磺化小试，原料油采用新疆原油经常压蒸馏、减压蒸馏、溶剂精制、溶剂脱蜡后的减压二、三线脱蜡油，发烟硫酸作为磺化剂，发烟硫酸加入量8%，反应温度60～65℃，用三口圆底耐热玻璃标准反应釜对原料进行发烟硫酸磺化，加入量30%氢氧化钠中和，分液漏斗抽提，在烧杯内加入量8%白土进行精制得到磺化抽余油，考察浅度磺化抽余油性质和收率，用磺化抽余油调合润滑油质量合格。

PYM is another mutagen we used and 1.5 h soak with 40 g/ ml PYM was proper for pre-cultured of thalami.

经6至9次高温定向筛选后，获得了多个S5、F25、F32的耐热初选变异系。

The results showed that 0.4mg/ml HYP was the proper dosage for thalami and shoots in vitro and 0.6mg/ml was appropriate for 25 d precultured thalami.

华南师范大学硕士学位论文非洲菊耐热变异的离体筛选与初步鉴定 4。

It's a good material for gene engineering to construct highly active and thermophilic enzymatic gene.

该工程菌可作为材料构建耐热性好和酶活高的杂合基因工程菌。

A series of modified polyurethane elastomer materials with different amino siloxane content were synthesized,which were based on polyoxypropylene glycol,aminoethyl aminopropyl poly,toluene diisocyanate and the curing agent dimethylsulfide toluylenediamine.

以聚氧化丙烯二醇或聚氧化丙烯三醇、氨乙基氨丙基聚二甲基硅氧烷、甲苯二异氰酸酯为原料在无溶剂条件下制备预聚体，利用二甲基硫甲苯二胺为固化剂合成一系列氨基硅油改性聚氨酯弹性体材料，并对材料的力学性能、耐热性、表面水接触角等性能进行了测试。

A strain KX6, producing thermotolerant endoglucanase, was isolated from compost. The morpholo-gical identification and 16S rRNA sequence analysis showed it belongs to Streptomyces xylophagus.

从堆肥中筛选到一株产耐热内切葡聚糖酶的放线菌菌株，通过形态观察和16S rRNA序列分析，鉴定为蚀木链霉菌。

These alloys are at the highest end of the range of temperature and strength.

这些合金在强度和耐热性方面都是最高的。

High temperature Oxidization and hot-corrosion tests showed that the anti-oxidization properties of aluminized Q235 steel and 1Cr18Ni9Ti...

高温氧化和热腐蚀试验结果表明，渗铝Q2 35钢的抗高温氧化性能和 1Cr18Ni9Ti奥氏体不锈钢相当，而耐热腐蚀性能明显优于后者

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。