耐热性

Nine pairs of primer were designed according to the HSP70-1 gene sequence of NCBI with AY149618 (19 526 bp) accession number.

研究中国荷斯坦牛HSP70-1基因与奶牛耐热性之间的关系。

This combination of nanoparticles in the coating advantageously results in a resistance to high temperatures of the coloring of the surface of up to 1000 DEG C.

这种在覆层中的纳米颗粒的组合有利地使得外表面着色的耐热性达到迄今未知的1000℃。

Low melting point, low viscosity of the mixtures with alicyclic epoxy resins, long applicable period, high heat-resistance of the cured material and excellent electrical properties at high temperature, MHHPA is widely used for impregnating electrical coils, casting electricity components and sealing semiconductors, e.g.

MHHPA是炮炼凝固型酸酐类凝固剂，关键用于电气及电子方面，它拥有熔点低、与脂环族环氧松脂合成的默契物粘度低、适用期长、凝固物的耐热性高、高温电机能好等长处，可用于电气设备线圈的浸渍及电气元件的浇铸和半导体的密封，如户外绝缘子、电容器、反光二极管等、数码管等。

Borosilicate is also a material of choice for evacuated tube solar thermal technology, because of its high strength and heat resistance.

硼硅酸盐也是材料的选择真空管太阳能热技术，由于其高强度和耐热性。

The graphite-reinforced BPI composite laminateswere made by autoclave techniques with the optimal cure processes and its properties were tested.

研究了碳纤维/BPI结构复合材料的耐热性、力学性能以及热物理性能。

By choosing suitable initiator, cure temperature and postcure temperature of 4, 4'-bimaleimidodiphenylmethane /3, 3'-diallyl-bisphenol A , Ciba-Geigy XU292-like BMI system, are greatly decreased to 160℃ and 180℃, and the heat resistance property of cured resins is not decreased.

针对BMI树脂固化温度高的缺点，选择了有效的引发剂，首次大幅度地降低BMI/DP树脂的固化温度和后处理温度（分别降至160℃和180℃，且不降低树脂的耐热性。

In general, these microorganisms have less thermal resistance than Clostridium botulinum and require less-severe thermal processes.

一般来说，这些微生物与肉毒杆菌相比有更小的耐热性，因而只需要相对低的热处理条件。

Basenps columna agents innovativeink, for example, on thermotolerance and pigments analysis and discussion of selections.

本文将以红色有机颜料油墨为例，对油墨的耐热性和颜料的选择进行分析探讨。

Its heat-resistant and flame-resistant properties were analyzed using TGA and Oxygen Index respectively.

树脂具有明显的高邻位树脂的特点，体系粘度低，合成易于控制；树脂具有良好的耐热性和阻燃性，80 0℃热失重低于 30 %，氧指数大于 4 7%。

The results indicates that 1,3-PBO and oleic acid play a role in diluting to BMI at lower temperatures.

BMI，1，3-PBO和油酸的三元共聚能提高BMI聚合物的工艺性和韧性，并且保持一定的耐热性。

I will endeavour to find you some assistance.

我尽力帮你找人帮忙。

At first I only know bruck is the idol of American younglings, afterwards I returned back to Taiwan ,even in Beijing last year ,I saw her poster everywhere, I was so surprised at her charm.

起初我只晓得布鲁克雷德丝是美国少男少女崇拜的偶像，后来回台湾，甚至去年在北京，居然也四处看见她的海报，才惊讶她的魅力之大。