耐热性

Leishmania promastigotes antigens have good stability and heat-resistant nature. The sensitivity of 901 and 801 antigen were better, so we thought it could be used for serologic epidemiology investigation in XinJiang.

利什曼原虫前鞭毛体抗原有较好的稳定性，耐热性极好；901株、801株抗原的敏感性、特异性较好，可做为新疆血清流行病学调查所用的抗原株；801株的特异性更好，可用于黑热病的特异性抗体的检测及研究。

Content of indigenous lipase in milk is low, and it's heat stability is bad.

乳脂酶中，内源酶的含量低、耐热性差、对乳制品品质的影响较小。

Listeria monocytogenes and Staphylococcus aureus are, among vegetative forms of bacteria of importance in food safety

在对食品安全影响较大的各类细菌中，李斯特单胞菌、金黄色葡萄球菌的耐热性最强。

In the period of radish to grow leaf the fresh weight unit area was menstruate; and then in the period of radish to grow root the leaf heat injury index and death rate of plant in summer were menstruate, also the electric conductivity percentage or high temperature cause death time; Finally radish yield and effective root rate were menstruated in the harvests and accomplish to synthesize evaluation heat tolerance of radish.

由此形成在萝卜长叶期进行苗期单位面积叶鲜重测定；长根期测定叶片热害指数和越夏死株率，或进行电导百分率和高温致死时间测定；萝卜收获期测定有效根率，最后综合评价萝卜耐热性。

The thermal properties of polymers are determined by the molecular chain structure.

聚合物的耐热性是由其结构决定的。

Cure behavior of F-51 epoxy resin and DAIP was studied by DSC. The influence of the different compositions on the co-cure resins morphosis and the heat resistance were researched.

研究了F-51环氧树脂和DAIP共固化的固化行为、不同配比对共固化物形态结构的影响；并研究了不同配比对固化物耐热性的影响。

The conclusions were as follows: theνO-H andνC=O IR absorption maxima shifted towards higher wave numbers after imprinting 17β-estradiol on TFMAA-co-TRIM copolymer with the red shift of theνO-H groups being apparent after precipitation polymerization for 16h while that forνC=O groups being observed after polymerization for 24h. A strong interaction between TFMAA and 17β-estradiol was confirmed by the high selectivity for 17β-estradiol, as indicted by the values of the separation factor of isomers of 17β-estradiol/17α-estradiol (2.28) and the imprinted factor (3.01). Particle diameter of TFMAA-co-TRIM polymer was between 300 nm and 1.5μm, which suited well for solid phase sorbent throughout at low column pressure. The recognition of imprinting TFMAA-co-TRIM polymer for sterol molecules was driven by enthalpy eluted with acetronitile, and low temperature was in favor of the separation of sterol structure analogues on imprinting column. TFMAA-co-TRIM polymer possessed of determinate anti-heat stability, with melting point beginning at 255.84℃, Tp=257.40℃, control TFMAA-co-TRIM polymer and imprinting TFMAA-co-TRIM polymer were respectively decompounded at 267.79℃and 343.11℃, and solid micro-extraction noddle prepared by the special polymerization also showed definite recognition for 17β-estradiol by GC/MS detecting at 270℃. By selection of various washing and elution solvents, elution reagents of close polymerization system were of more advantage in template molecules retention and recognition on molecularly imprinted solid phase extraction column. At a certain extent, progesterone, 17α-estradiol, 17β-estradiol and 4-androstene-3, 17-dione could be intercepted on the MISPE column. Especially, MISPE had high selectivity for progesterone, and imprinting TFMAA-co-TRIM polymer could achieve adsorption balance within 50 min by absorption kinetics test for 17β-estradiol. However, MISPE column showed better selectivity and enrichment property for 17β-estradiol than C18 and CSPE columns according to the data from HPLC and GC/MS analyses. Recovery of 17β-estradiol on MISPE column was up to 85.5% while when prime extracting solution of milk powder was sampled, the recovery of CSPE and C18 columns were 43.7% and 30.7%, respectively.

通过研究阐明：紫外聚合产物TFMAA-co-TRIM中的νO-H振动吸收峰在聚合16h后红移，νC=O振动吸收峰在聚合24h后红移；TFMAA-co-TRIM对雌二醇异构体的印迹因子达到了3.01，α为2.28，优于其它功能单体参与得到的聚合物识别特性；TFMAA-co-TRIM聚合物粒径介于300 nm至1.5μm之间，作为色谱固定相具有良好的通量和低的柱压；在乙腈流动相中，TFMAA-co-TRIM分子印迹固定相的分离过程主要被焓驱动，低温有利于分子印迹固定相分离甾醇结构类似物；TFMAA-co-TRIM分子印迹聚合物在255.84℃时开始熔融，Tp=257.40℃，聚合物CP的降解温度在267.79℃，MIP降解温度在343.11℃，制备的固相微萃取头初步经GC/MS 270℃的耐热性测定；不同的洗提溶剂筛选证明了选择接近聚合溶剂的洗脱体系更有利于MISPE发挥识别效应；分子印迹固相萃取柱对孕酮、17α-雌二醇、17β-雌二醇和雄烯二酮都具有不同程度的保留特性，可作为此类化合物的吸附材料，特别对孕酮强保留的富集特性，可作为孕酮的选择性识别吸附剂，其分子印迹聚合物对17β-雌二醇的吸附动力学测定显示在50 min内基本达到吸附平衡，具有作为传感器核心敏感材料的潜力；对比萃取奶粉中17β-雌二醇性能，MISPE柱比非分子印迹固相萃取柱和C18柱具有更高的保留，回收率依次为85.5%，43.7%和30.7%。

The 1, 3-disubstituted phenylene structure led to bend in the molecular chains of LCP-111 and LCP-116, so that their melting points are lower than that of Xydar, resulting in lower processing temperature and heat resistance.

由于LCP-111和LCP-116的分子链中均引入了间位取代的苯环结构，其分子链发生了弯折，因此它们的熔点均低于全对位结构的Xydar的熔点，但同时也降低了耐热性。

Heat tolerance of the polymer is also part of the picture.

聚合物的耐热性也是与黑点有关的一部分。

Organic- glass is widely used due to its excellent optical propery.

有机玻璃具有优异的光学性能，但在耐热性和韧性等方面存在不足，使其应用范围受到限制。

I will endeavour to find you some assistance.

我尽力帮你找人帮忙。

At first I only know bruck is the idol of American younglings, afterwards I returned back to Taiwan ,even in Beijing last year ,I saw her poster everywhere, I was so surprised at her charm.

起初我只晓得布鲁克雷德丝是美国少男少女崇拜的偶像，后来回台湾，甚至去年在北京，居然也四处看见她的海报，才惊讶她的魅力之大。