绝缘电阻

Check whether the insulation resistance and the dielectric strength of the electric devices attached to the panel and equipment body are sufficient.

检查附着在控制面板和设备主体上面的绝缘电阻和绝缘性是否足够大。

First should measure all parts of insulated electric resistance before install it, and the motor insulated electric resistance should not less than 0.5 megohm.

3.5.3.3 安装前应首先摇测各部分对地绝缘电阻，电动机的绝缘电阻值不能低于 0.5 兆欧。

M. Insulation test of secondary circuit:use megohmmeter of 500V～ 1000V for measuring insulation resistance to earth of all DC circuits, signal circuits,the values should not be less than 1 M.

3.10.1.2 二次回路绝缘试验：采用 500V～1000V 兆欧表测量各直流回路，信号回路对地绝缘电阻，其值不低于

Measure the insulation resistance of coil.

测量绕组的绝缘电阻，在常温下电机的绝缘电阻值不应低于0.5兆欧。

The results show that the polymer determines the electricity conducting of coal filled polymer composites. The coal filled PP composites is an insulating material, and be independent of coal type, its direct current resistivity is above 10〓Ω·cm. The resistivity drops with the content of coal when using anthracite, but it is also above 10〓Ω·cm, and the surface modification of coal, especially alkylated, resumes the insulance of composites.

X射线衍射测试表明即使在高变质程度下煤中的石墨晶区含量仍较低，煤填充聚合物复合材料电性能主要由基体材料性能决定，通过动电容静电计对煤填充聚丙烯复合材料直流电导性研究表明，煤填充聚丙烯复合材料是绝缘材料，其绝缘电阻在10〓Ω·cm以上，在高含量情况下，仍能保持良好的绝缘性，而与煤种无关。

All conductors shall be connected firmly and wrapped closely as well as insulated well without damaging wire core.

1.1.6 所有导线应连接牢固，包扎严密，绝缘良好，不伤线芯，导线间和导线对地间绝缘电阻必须大于0.5兆欧。

The insulation resistance is dependent on both the surface and volume resistance of the material.

绝缘电阻是由材料的表面电阻和体积电阻决定的。

In chapter three the performance and structure of components of oxygen probe were especially investigated. The Cr-Cr〓O〓 powder was overcome by treatments. The reason of occurrence of thermal peaks on the EMF curves was explained. A water glass based cement which high temperature insulation was around 10MΩ within 10 seconds at 1600℃ was developed for the use of oxygen probe. The effects of tip end thickness of ZrO〓 tube and amount of reference electrode on response time and thermal equilibrium in oxygen probe were investigated. The optimum tip end thickness of ZrO〓 tube and amount of reference electrode addition were determined. It is found that the heat transfer in oxygen galvanic cell is the rate limiting-step in the response process. The national oxygen probe WOS Ⅱ type was designed and manufactured. By three batches of industrial tests its specification reached the level of American Celox Ⅱ type oxygen probe.

在第三章中分别从参比电极、高温绝缘水泥、插接件等组元入手，着重分析了其性能和结构，开发出了适合于钢液定氧用的Cr-Cr〓O〓参比电极，解决了Cr-Cr〓O〓参比电极高温产生收缩问题，解释了电动势曲线产生峰值的原因；开发了适合于定氧测头使用的水玻璃基耐火水泥，其高温绝缘电阻在1600℃，10秒以内为10MΩ左右；同时对ZrO〓管头部厚度、参比电极量对响应时间的影响以及定氧测头中的热平衡进行了研究，得出了合适的ZrO〓管头部厚度和参比电极加入量，确定了氧浓差电池中的传热是响应过程的限速步骤；设计制造了国产WOSⅡ型定氧测头，进行了三次现场定氧测试，其技术指标达到了美国Celox型定氧测头的水平。

SB2015-3 Precision Decade DC Resistance Box adopts high voltage glass glaze resistors and special high voltage seal switch.Its electric performance is very stable and insulation intension is very high.The resistance value can be adjusted under the condition of ceaselessly opening voltage(Note:The using switch should not be at the point of 0.)It is easy to operate and suitable to be used to calibrate insulation resistance meter,and suitable to be used as high resistance standard.

SB2015-3型精密十进位直流电阻箱采用高压玻璃釉电阻器及独特的高压密封开关，电性能稳定可靠、绝缘强度高、可在不断开测试电压的条件下调节电阻值（正在使用的那只开关不处在&0&位置时）、操作方便，适用于检定/校准绝缘电阻表，也可作为高阻标准。

The ohmic resistance of insulation.

绝缘电阻绝缘的欧姆电阻。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。