结果相同

Consensus is found by comparing the simulation result and test results in deformations and acceleration curve. Energy absorption behavior of each part is compared.

以ECE R33法规对该轿车进行了碰撞过程仿真计算，仿真计算的变形结果和实验结果吻合度达到80％，车身典型位置的加速度曲线也有相同的规律。

Results also vary, so it is important to have a frank discussion with the acupuncturist regarding expected results and their time frame.

结果也不尽相同，因此它是重要的是要有坦诚的讨论与针灸师就预期的结果和他们的时间框架。

First, the S-CDMA-HFC system with integrated traffic is introduced and the method of traffic integration is given. Second, the upstream channel capacity of the S-CDMA-HFC system with integrated traffic that has the same rate is analyzed. The chronoff limit and Gaussian approximate equation of the upstream channel cutoff probability are derived. Third, the impact of the selection of the line transmission rate on the upstream channel capacity of the S-CDMA-HFC system with integrated traffic is discussed in detail. The cutoff probability and throughout equations of the upstream channel with different integrated traffic are derived. Fourth, the impact of the power control error on the capacity is discussed. Results show that the power control error will degrade the upstream channel capacity and have different influence on the different traffic. Finally, the capacity requirement of the initialization process is raised. Analytical results show that the initialization process will impact on the capacity slightly.

首先，简单介绍了综合业务S-CDMA-HFC系统，给出了业务综合的方法；然后，分析了具有相同码率的综合业务条件下的S-CDMA-HFC系统上行信道容量，导出上行信道中断概率的切尔诺夫上限和高斯近似公式；然后，详细讨论了基本传输速率的选择对综合业务S-CDMA-HFC系统上行信道容量的影响，导出了不同业务综合条件下上行信道的中断概率和吞吐量公式；然后，讨论了功率控制误差对综合业务S-CDMA-HFC系统上行信道容量的影响，结果表明功率控制误差会使上行信道容量下降，且对不同业务的影响程度是不同的；最后给出了初始接入的容量要求，分析结果表明初始接入将对综合业务S-CDMA-HFC系统上行容量带来影响，但不明显。

To some extent, the FIFO method approximate s the results that would be obtained by specific identification of costs.

从某种程度上说，采用先进先出法计算的结果与采用个别辨认法计算的结果大体相同。

In this paper, the dynamic compressing experiments for the matrix material of the tungsten alloys which have been three different deforming(0%、 32.6%、 44.6%) processed have been performed by the experimental technology of separated Hopkinson pressure bar and many accurate datum have been obtained. Also the three materials have been compared with each other and analyzed. The results show that the optimized values are in a certain range to optimize the materials by changing their deforming technology. The parameters of constitutive model of Johnson-Cook have been fitted based on the datum. Then proceed to the next step, adiabatic shear band of these three matrix materials has been analyzed with finite element method. The result shows that the relations between stress and strain are different because of the differences of technical process of the three materials, but they are in great commonness in the material experiment and in great coherence in the distribution of time and space, which can been seen from the space distributing figures of plastic strain.

利用分离式Hopkinson压杆实验技术对三种不同变形量(0%、32.6%、44.6%)钨合金基体材料进行动态压缩实验，取得大量精确的数据，对比分析三种材料，结果表明通过改变变形量对材料进行优化，其变形量的优化值是有一定范围的；本论文拟合、确定了钨合金基体材料Johnson-Cook本构模型参数并对三种基体材料绝热剪切带进行有限元分析，结果表明三种材料由于工艺流程的不同，应力应变关系也不尽相同，但从塑性应变的空间分布图上体现了材料很大的共性和时间以及空间分布的一致性。

Experimental outcomes validate that improved methods reasults are better than original algorithms under the same anneal ratio and can attain perfect matching reasults all the same when anneal ration is reduced befittingly.

实验也验证了在相同退火率的情况下能够得到比改进前算法好的匹配结果，并且适当提高退火率时仍然能够得到比较理想的匹配结果。

Employing the bidimensional regression along with standard deviational ellipse, the authors compared the local and global distortions between two kinds of cognitive maps.

在此基础上，通过二维回归与误差椭圆的方法分别对两种外部化方法获得的结果进行全局与局部的比较，研究发现手绘草图的方法的结果更加符合实际地图；然而两个方法在变形的趋势上却大致相同。

This paper experimentally studied smash characteristic of com straw, including mainly performance parameter of pulverizer such as consumption of electricity per ton, hour productivity and hammer patch thick under the condition of different moisture rates and sieve pore diameter .

本文主要对不同含水率、筛孔直径下粉碎机的吨料电耗、小时生产率及锤片厚度等性能参数进行了玉米秸秆粉碎特性试验研究，结果表明：对于相同筛孔直径，随着含水率的增大，负荷输入功率基本不变，吨料电耗增加，生产率降低；对于相同含水率的玉米秸秆，随着筛孔直径的增大，吨料电耗、负荷输入功率降低，小时生产率增加；度电产量和粉碎效率随着锤片厚度的减薄而增加，当锤片厚度为4mm时，既能够保持较高的粉碎效率，又保证了一定的耐用度。

The physical character of the super-critical hydrogen in the regenerative cooling channel is studied : started with the physical character of the super-critical hydrogen , using the method of least square , figuring out the state equation which is applicable to the state from liquid to the super-critical in the super-critical pressure , the constrained convection and the heat transfer in the super-critical channel are simulated using the equation , the results of the simulation are identical with the experiment in the same condition .

对再生冷却通道内的超临界氢的物性进行了研究：从超临界氢物性的实验结果入手，用最小二乘法拟合出适用于超临界压力下氢由液态过渡到超临界态的状态方程，并利用该方程对超临界氢管内强迫对流换热进行了数值仿真，仿真结果与相同条件下实验结果相一致。

The expression of space-charge field is given out in the paper with two time constants τpa and τpb. When considering and not considering the photovoltaic effect, the diagrams of the two time constants as a function of irradiance in units of 1/ are the same.

理论研究表明，空间电荷场的形成和擦除与两个时间参数有关，在考虑或者不考虑光生伏打效应两种情况下，这两个参数随擦除光强的变化有基本相同的变化规律，光栅的写入和擦除有相同的结果。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。