结果相同

The results of simulating multi-stage H〓O〓 displacement bleaching showed that the brightness of bleached pulp increased along with the increase of H〓O〓 concentration in fresh bleach liquor.

多段H〓O〓置换漂白的模拟试验结果表明，漂后浆白度随新鲜漂液H〓O〓浓度的提高而提高，但在相同的新鲜漂液H〓O〓浓度下，不同漂液量时的漂后浆白度基本相同。H〓O〓消耗量随新鲜漂液H〓O〓浓度和漂液量的下降而下降，漂白效率的变化恰与H〓O〓消耗量的变化相反。

The results indicate that the cooling rate of melt droplet that can not break further depends not only on its diameter, but also on its position in atomizing chamber. As a result, the same sized particles in different positions show different cooling rates and two different kinds of microstructures. The cooling rates of melt droplets range from 104 to 108 K/s, and the critical cooling rate for glass formation of Al-Ni-Y is about 105 K/s. Moreover, the corresponding maximum diameter of amorphous particles is 25 μm, which accords well to the theoretical analysis results. The new approach, reflecting the complexity of close-coupled gas atomization objectively, is available and effective to evaluate the cooling behaviors of close-coupled gas atomization.

结果表明：在一定的工艺条件下，紧耦合气雾化存在多种破碎模式，熔滴的冷却速率因直径、雾化位置的差异，相同直径熔滴经历结晶和非晶化2种不同冷却行为；依据Al基合金粉末的粒度分布和微观结构，结合熔体的雾化过程及冷却模式，确定熔滴冷却速率的上、下限；实验得出熔滴的冷却速率为104~108 K/s，Al-Ni-Y合金的非晶化临界冷却速率为105 K/s，能形成非晶态的熔滴最大直径为25 μm左右，实验结果与理论分析结果较吻合，比较客观地反映紧耦合气雾化的复杂过程。

The classification efficiency and resisting force expenses have been compaired with cyclone dust extractor by rltv empirical study.

与普通旋风除尘器进行了对比实验研究，比较了分级效率和阻力损失情况，结果表明在相同风量下，无筒体旋风除尘器的分级效率高于有筒体旋风除尘器；在相同风量下，无筒体旋风除尘器的阻力损失较有筒体旋风除尘器的阻力损失有所增加。

It is showed that the propping fracture conductivity of gas log is 1.5 to 2.5 times higher than that of liquid log under the same testing conditions (such as haydite type, sanding concentration, temperature and pressure). A lower average sanding concentration in gas well fracturing should be adopted than that in oil well fracturing so as to obtain the same propping fracture conductivity.

结果显示，在相同实验条件下（陶粒类型、铺砂浓度、实验温度和压力），气测导流能力值比液测值高1.5~2.5倍，表明要获得相同的支撑裂缝导流能力，气井压裂中的铺砂浓度应比油藏低。

The experimental results show that the reactivity of calcined kaolines from the same origin is different after they are calcined at different temperatures,their reactivity reach the biggest value after the kaoline is calcined at 800℃ for 6h;the reactivity of calcined kaolines from different origins are much different after they are calcined at different temperature...

试验结果表明：产地相同的高岭土经不同温度活化，其活性大小不同，在800℃煅烧6h后，其活性达到最大值；产地不同的高岭土经相同温度活化，其活性大小相差很大；用该方法所测定的偏高岭土的活性Al2O3和SiO2总量的大小与其地质聚合物硬化体的抗压强度和NH4+交换容量有相关性。

In addition, the leakage coefficient decreases with the decrease of gap width at the same rotational speed.

研究结果表明：用相对流量系数（转动时的流量系数与静止时的流量系数的比值）与速比（周向速度与轴向通流速度的比值）的函数关系表征泄漏量随转速变化的规律时，存在一个临界速比约等于1.0；低于这个临界速比时，转速对泄漏量的影响不明显；高于这个临界速比时，泄漏量随转速的增大而减小，在很高的转速下（6000r/min以上），泄漏量至少减小了5.1%；相同间隙下，泄漏系数随着压比的提高而近似线性增加；相同转速下，随着密封间隙的减小，相对泄漏量逐渐降低。

SODT can not only handle datasets with similar or different distribution between global and local data, but also can make full use of the structure information of the labelled and unlabelled data and produce the same classification results no matter how the observations are arranged.

SODT 算法既能够处理整体数据与局部数据分布相同或不同的数据集，又可以充分利用有标签和无标签数据的结构信息，分类结果不受样本随机重排的影响，而且时间复杂度还与单变量决策树算法相同。

Results showed that, the specific refining energy consumption is decreased with increment of rotation speed of the primary refiner. At freeness level of about 670 mL CSF, for example, the specific refining energy consumptions is 363 kWh/t o.d. at 3000 r/min, and 305 kWh/t o.d. at 3500 r/min, which is equivalent to 16% energy saving, furthermore the specific energy consumption is only 265 kWh/t o.d. at 4000 r/min, which means 27% less refining energy required. At the same time, pulps produced at higher refiner speed have higher strength properties and lower shives contents. There is little change of optical properties of the pulps.

结果表明：小叶桉物料在相同条件下进行汽蒸、挤压和化学预浸渍后，分别采用3500 r/min和4000 r/min的盘磨转速进行第一段磨浆，浆料磨至游离度670 mL时所需磨浆电耗与3000 r/min时的相比，分别下降16%和27%；浆料中纤维束含量分别降低20%和35%；第一段磨后浆料再分别经相同盘磨转速（3000 r/min）的后续磨浆后，与相近游离度的浆料性能比较可知，随第一段磨浆盘磨转速的提高，浆料的细小组分含量略有增加，纤维束含量显著降低，强度性能有不同程度的改善，但光学性能变化不显著。

Karyotypes of root tip chromosome showed that the arm volume ratio, the mean relative volume and idiogram were identical before and after improving seed vigor, so the pattern of chromosome did not change. But we couldnt confirm whether the pattern of other separation dates and the inner structure varied in this experiment, such as gene mutation.

根尖染色体核型分析结果，甘蓝种子在活力提高前后染色体的臂比值相同，相对长度相同，表明活力提高后染色体在形态及核型上无明显变化，而对于除中期外的其它分裂期染色体的形态特征以及染色体内部结构有无明显变异在本试验条件下尚不能确定。

The C-V profiles display two well-separated sharp peaks that are originated from the ground and excited states of the QDs, respectively , suggesting an improved uniformity and decreased dot density. The addition of Sb can retard the 3D growth mode and expand the critical thickness of the growth mode from 2D to 3D.

G。比值从0.6937提升至1.2102与光性分析有相同趋势，半高宽有下降趋势显示随Sb增加量子点有较均匀的现象；在Sb含量最多的样品发现，随著量测频率下降基态的浓度有明显增加的趋势(2×1017增加至2.15×1019)，使的基态峰值显得更陡峭，由於可以在电性明显的量测出基态的变化，是因为量子点密度低与均匀度好的原因，这个结果与之前的分析有相同趋势。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。