结果为

This paper studies the main geometrical parameter such as angle, height, width, stagger and the upper width in dentation and trapezoid flow path, firstly, uses the single-phase numerical simulation of the computational fluid dynamics technique to analyse the influence of different geometrical parameter on discharge coefficient and flow state exponent of drip emitter. Secondly, uses the two-phases numerical simulation of CFD (1% sand content ) to analyse the influence of the above mentioned geometrical parameter on the contribution regulation of sand and anti-clogging performance. Thirdly, uses the PIV （ particle Tracking Velocimetry ） technique which can see the small-scale flow path to observe and test the trajectories and velocities of solid particles in labyrinth flow path, and analyses the basic factors which can influence the movement characteristic of solid particles and the flow state in flow path.

本文以齿形流道、梯形流道为主要研究对象，以流道转角、流道高，流道宽、偏差量及梯形流道上底宽为主要结构参数，首先应用 CFD 单相流数值模拟技术对不同结构参数灌水器流道水力性能进行模拟，分析了不同结构参数对流态指数和流量系数的影响，其次，应用 CFD 两相流（含沙量为1%）数值模拟技术分析了结构参数对含沙量分布规律和抗堵塞性能的影响，然后，应用 PIV 可视化测试方法测试了固体颗粒在流道内运行轨迹及速度，分析了影响固体颗粒运动特性及流道内流体流态的基本因素，最后，对上述流道结构形式通过模具加工及滴灌带试制，进行了标准化测试（ GB/T 17187-1997 农业灌溉设备滴头技术规范和试验方法与 ISO 标准 ISO /TC23 /SC18 /WG5N4短周期堵塞测试程序），测试结果验证了 CFD 模拟结果，并提出了迷宫结构流道灌水器的抗堵塞设计方法。

It deriver the test methods based on the point estimations of the marginal proportions and the covariance matrix of the points estimations in 2×2 table.

这类问题可以归结为：设第一次观察的结果记为Y1 ；第二次观察的结果记为Y2 。其中，Y1 和Y2 都是随机变量，两者的可能取值都为 1和 2。

In addition, the study on ionic liquid being used as the electrolyte of EDLC was carried out extraneously, a good result of 310F/g was obtained. That the possibility of spherical active carbon used as the electrode materials was also investigated for the convenient preparation of electrode, the specific capacitance of spherical active carbon was 188F/g, having directive function for the preparation from powder SAC to spherical active carbon.

另外，本项目也额外进行了离子液体作为电解液性能的研究，获得了比电容高达310F/g好结果；考虑到电极制作，又研究了活性炭微球作为电极的可能性，得到了比电容为188F/g的结果，为下一步将粉状的超级活性炭制作为球状的活性炭提供了指导与借鉴作用。

In this article two functional modes of the Fly-back Converter (Continuous Conduct Mode and Discontinuous Conduct Mode) are particularly analyzed, which include their characteristics, applications, the critical pattern of two functional modes is argued, both the exact boundary from the angle of circuit parameters is crystallized, at the same time, basic principle of PFC under the DCM mode is introduced, which settle theoretical basis for the subsequent design; by establishing the mathematic model of the converter, a further investigation of the configuration is made, qualitatively and quantitatively, analyzed to settle exactly theoretical basis for the subsequent emulation and the experimental parameter; from the angle of steady-state analysis, the transfer function of the system is deduced to establish dynamic small-signal state equation, emulating the system with the help of matlab, then according to the simulation result and the theory of PFC revise the system, lastly, we adopt the project which add a zero-pole compensator to the voltage loop, by this way, a satisfied system performance is gained and the PFC scheme is ensured successfully; finally, based on the previously-done work, we combining with the situation of specific design requirement, acquired the numerical value of each unit devices in this converter

详细分析了反激式变换器的两种工作状态，连续模式(Continuous Conduct Mode ，简称CCM)和断续模式(Discontinuous Conduct Mode，简称DCM)以及各自的特点、应用场合，论证了两种工作状态的临界模式，从电路参数的角度明确了二者的界限，同时还介绍了DCM模式下PFC的基本原理，为后面的设计奠定理论基础；通过对整个变换器系统建立准确的数学模型，对此变换器的电路结构做了进一步的研究，定性、定量地分析了变换器各部分的工作状态，为仿真和实验参数的确定以及电路参数的优化提供理论依据；从稳态分析的角度，为系统建立了动态小信号状态方程并推导出系统的传递函数，利用matlab对系统进行仿真，进而根据仿真结果以及PFC的相关理论对系统进行校正，采用在电压环加入零点—极点补偿器的设计方案，得到了满意的系统特性并且保证了PFC的顺利实现；最后，在前面所做工作的基础上，结合设计要求计算出此变换器系统中每个元器件的数值，利用Pspice对其进行了仿真、优化，然后根据仿真结果搭建了硬件电路。

Result It was found in the results that the better pretreatment time for onion root-tip was 3.0 h and its better dyeing solution was basic fuchsin dyeing solution. On this basis, it was found that the chromosome number of tested onion was 2n=2x=16 through chromosome karyotype analysis on the root-tip cells of onion.

结果］结果发现，洋葱根尖的较好的预处理时间为3.0 h，较好的染液为碱性品红染液；在此基础上，通过洋葱根尖细胞染色体核型分析，发现试验所用洋葱的染色体数为2n=2x=16。

In § 1, we give main definitions and basic results that are needed in the paper. In § 2, we determine the structures of somegroups by using s-normality of Sylow subgroups and the maximal subgroups of Sylow subgroups. There are the main theorems that 1 Let G be a finite group and P be a Sylow p-subgroup of G where p is a prime divisor of |G|.

我们在§1中将给出本文所需的主要概念和基本结果，在§2中讨论Sylow子群、Sylow子群的极大子群的s-正规性对群的结构的影响，主要结果是1设G为有限群，p为|G|的素因子，P为G的Sylow p-子群。

The optimization result shows that the maximal attack area is an ellipse of 17 km half long axis and 10 km half short axis, and it is better than the conclusion of a lot of simulation researches aiming at this warhead, and it can offer reference for further design of reentry trajectory.

优化结果表明，最大可攻击区范围是一个长半轴为17 km，短半轴为10 km的椭圆区域，此结果优于针对该弹头进行的大量弹道仿真所得的结论，可为进一步弹道设计提供参考依据。

Methods and results We assume the carotid arterial wall is the elastic material so we can use the Hooke's law to analyze it. The experiment is based on the use of ultrasound B-mode imaging technique and the off-line image analysis. Elastic tube phantom experiments demonstrated the validity of the technique, providing the size of the tube within 3% of the actual values. The system was also tested in the common carotid arteries of 10 healthy males (age 23.6 y). According to the experimental result, it shows that our index is less variant than Peterson's elastic modulus. The results of and are and respectively.

根据橡皮管的体外实验结果，利用超音波以及影像分析所得到的橡皮管尺寸，与实际尺寸间的误差只有3%，而使用超音波 B-mode 量测颈动脉的实验结果显示，在把颈动脉当作完全弹性体的假设下，所得到的 CIMT 硬度指标，於十位平均年龄为23.6岁的年轻健康男性中，结果与过去文献中常使用的 Peterson's elastic modulus 相比较，结果显示容易受到不同受试者间，不同的生理状态之影响，而在考虑受试者的 IMT 变化情况下，比能够反映更多的受试者颈动脉材料性质，因此得到了较为稳定的实验结果。

The results show that the electrochemical window is 3.40V, the crystal grain of new deposit aluminum is ideal, and the boundary of crystal grain is perfect. The main element is aluminum and trace element is oxygen on the surface of cathode.

研究结果表明：铝基离子液体Br-AlCl3的电化学窗口为3.40V；扫描电镜分析表明，阴极新生态的铝晶粒生长完整、晶界完善；X射线能谱分析阴极表面新生态铝的结果显示主元素为铝，微量元素为氧。

Based on the investigation data from a telecom enterprise, the formative model and reflective model have been compared to see whether the same advice could be provided to the enterprise according to how to improve the customer satisfaction level. It showed that the formative model provided more stable advice than the inflective model.

利用该电信企业的数据，比较分析了构成型模型（顾客期望和质量感知潜变量调整为构成型关系）和反映型模型（所有潜变量均为反映型关系）的实证结果，研究表明在为企业提供改善顾客满意水平的信息上两种模型具有较好的相似性，但是构成型模型能够提供更加稳定的结果，从而验证了顾客满意模型中引入构成型模型的可行性。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。