结果

The antibodies in plasma were also detected by indirect antiglobulin test. The result showed that levels of WBC,TB,DB,Glu and reticulocyte in six patients treated with β-lactam antibiotics were raised remarkably. DAT was strongly positive,but no RBC antibodies were detected in the plasma by IAT. The binding of red cells by monocytes or lymphocytes was great,and the hemolysis of red cells by alexin not appeared. After stopping above-mentioned β-lactam antibiotic administration,patient's WBC,TB,DB,and Glu levels returned to normal values.

结果发现：6例患者的临床治疗的药物都属于β内酰胺类；住院期间患者的WBC、TB、DB、Glu的检测结果出现异常，红细胞的DAT试验结果均为阳性，IAT试验结果均为阴性；将DAT阳性的红细胞进行补体结合实验时，结果为阴性；细胞涂片见部分红细胞表面有颗粒状物质附着，细胞培养见部分红细胞被白细胞识别、黏附；改用其它抗生素后，患者的上述化验指标恢复到正常值范围内，DAT试验结果转为阴性。

The result showed that levels of WBC,TB,DB,Glu and reticulocyte in six patients treated with β-lactam antibiotics were raised remarkably. DAT was strongly positive,but no RBC antibodies were detected in the plasma by IAT. The binding of red cells by monocytes or lymphocytes was great,and the hemolysis of red cells by alexin not appeared. After stopping above-mentioned β-lactam antibiotic administration,patient's WBC,TB,DB,and Glu levels returned to normal values.

结果发现：6例患者的临床治疗的药物都属于β内酰胺类；住院期间患者的WBC、TB、DB、Glu的检测结果出现异常，红细胞的DAT试验结果均为阳性，IAT试验结果均为阴性；将DAT阳性的红细胞进行补体结合实验时，结果为阴性；细胞涂片见部分红细胞表面有颗粒状物质附着，细胞培养见部分红细胞被白细胞识别、黏附；改用其它抗生素后，患者的上述化验指标恢复到正常值范围内，DAT试验结果转为阴性。

In the third chapter, the finite element inverse approach has been applied to an L-shaped cup drawing simulation. Compared with the experimental result and incremental FEM result, the numerical results of inverse approach validate the efficiency and accuracy of inverse approach. In the fourth chapter, a rear fender has been chosen to be an example of 3D complicated auto panel.

采用有限元逆算法数值模拟了L-形方盒件的冲压成形过程，计算结果与试验结果及增量有限元结果进行了比较分析，结果表明：有限元逆算法结果与试验结果基本吻合，而且有较高的精度，在产品初期设计阶段具有较大的应用价值。

These results show that:(1) the results retrieved from the Abel integral and absolute TEC inversion are consistent on the whole at higher orbits altitude (~800 km), and in good agreement with those measured by ionosondes; the results retrieved from absolute TEC inversion are in better agreement with those obtained from ionosondes than that by the Abel integral inversion at lower orbits attitude (~500 km);(2) the maximal electron density N m from absolute TEC inversion is closer to N mF2 from ionosondes than that from Abel integral inversion, and the method of the former is more rigorous and effective than that of the latter;(3) absolute TEC is more sensitive to cycle slip than Abel integral, but for the two ways significant loss of inversion precision due to cycle slip always exists.

结果表明：（1）在较高轨道高度（约800 km），Abel积分与绝对TEC方法的反演结果基本一致，都与电离层测高仪反演结果符合良好；在较低轨道高度（约500 km），绝对TEC反演精度优于Abel积分反演精度；（2）绝对TEC反演的最大电子密度 N m较Abel积分法获得的结果更接近于电离层测高获得的峰值电子密度 N mF2，绝对TEC反演法更加严密和有效；（3）周跳对绝对TEC反演结果的影响较Abel积分反演结果的影响更为敏感，但无论哪种方法，周跳对反演精度都造成严重损失。

Based on investigating the short and intermittent structural plane, surrounding rockmass of the huge underground powerhouse in Three Gorge has been divided into five statistical similar areas according to its characteristic of rockmass structure by applying structure plane network simulation. Distributed characteristic of structural plane has been studied and based on it mechanics macrocharacteristic has been studied:(1) It is the first time that based on the result of structural plane network simulation rockmass quality of every structure area has been studied with applying blurred information optimum seeking technique and be compared with and RQD method. The result indicated that it has better effect to evaluate rock quality with blurred information optimum seeking technique.(2) It is the first time that the interrelated relationship of the result of in-suit rockmass deformation test and fractal characteristic of structure on test point has been applied to determine rockmass deformation parameter. The question of evaluating deformation parameters of engineering rockmass has been solved.(3) Anisotropy strength parameters have been determined by applying shear zones simulating method. The result indicated that there are different strength parameters in every structural area, after comparing the result of Fast Lagranian Analysis in continua number simulation method with that of method of weighted mean according to continuity. The result indicated that when a suitable reduction coefficient is been considered rockmass strength parameters can be simply and fast determined with method of weighted mean according to continuity where there is not enough test result.(4) Damage characteristic has been studied based on analysis fractal characteristic of structural plane network by applying fractal-damage coupling method. It is the first time that the concept of damage degree has been set up to evaluate rockmass quality according to the biggest principal damage.

通过对短小、断续性结构面统计特征的研究，将地下厂房区划分为五个岩体结构统计均质区，应用结构面网络模拟技术研究了各个岩体结构均质区结构面的发育分布特征，并以此为基础对岩体宏观力学特性进行了深入研究：(1)首次通过在结构面网络模拟计算结果的基础上，应用模糊信息优化技术研究了厂房区各个岩体结构分区的岩体质量并与岩体基本质量指标研究法、岩体质量指标RQD值研究法作了对比，结果表明以结构面网络模拟结果为基础，应用模糊信息优化技术进行岩体质量评价能够取得很好的效果，解决了工程岩体质量的定量评价问题；(2)首次通过对已有的现场大型岩体变形试验结果的分析及相应试验点岩体结构分形特征的研究，建立了结构面分布的分形维数和岩体变形指标间的相关关系，并首次应用这种相关关系根据结构面网络模拟及分形维数计算结果确定了缺少试验结果的地下厂房各工程部位的岩体变形指标而且应用于围岩稳定性计算，解决了工程岩体宏观变形参数的评价问题；(3)应用在结构面模拟网络图上模拟岩体剪切破坏带的方法，得出了岩体在不同方向上的强度参数，结果表明岩体的强度特性与结构面的发育方向和程度有着明显的关系，各个岩体结构均质区具有不同的强度参数；同时还通过应用拉格朗日差分法对岩体强度指标的数值分析并与按连通率加权平均计算法对比表明，按连通率加权平均计算法在考虑合理的折减系数情况下，可以简单快速地对缺少现场大型试验结果的具体工程部位实现岩体强度指标的估计，通过以上研究解决了工程岩体抗剪强度参数的评价问题；(4)通过结构面网络分形维数的研究，应用分形损伤耦合分析方法，研究了厂房区岩体的损伤特征，并首次引入"损伤度"的概念，建立了应用最大主损伤评价岩体质量的指标体系。

The combination of the above code with the Dawson method produces and effective software package for the wave resistance computation. This package was applied to series 60 shps and portliness merchantman. The computational results of series 60 ships are close to the corresponding experimental results but those of portliness merchantman only show similar trends to the experimental results.

采用该软件，分别计算了系列60船舶和一艘肥大型商船，得到了稳定有效的兴波阻力结果，其中系列60船的计算结果与实验结果吻合良好，而肥大型商船的计算结果与实验结果相差较远，但两种船型的计算结果和实验结果的兴波阻力曲线具有相近的变化趋势。

Examples have been calculated by use of parameter optimization inverse program.

根据田间实测数据采用开发的参数优化反求程序进行了实例计算，分析比较了采用不同目标函数的结果，结果表明，采用第三种目标函数进行计算，优化结果最理想；并用这些结果与设置相同目标函数的离散变量算法和试算法的结果进行了对比，结果显示，三种算法所得结果没有明显差异。

Results: Relative diagnostic accordance rate of the clinical exploration and four kinds of image processing setup was the highest（P＞0.01）in the first premolars. Relative diagnostic accordance rate of the clinical exploration and the pseudocolor image setup and negative image setup was the highest（P＞0.01）, and that of the clinical exploration and the pseudo3D image setup and positive image setup was the lowest（P＜ 0.01）, showing statistical differences in the second premolars.

结果：①第一前磨牙：4种图像处理格局下邻面龋的检出结果与临床诊断结果的符合率高，差异无统计学意义（P＞0.01）；②第二前磨牙：负片和伪彩图像格局下邻面龋的检出结果与临床诊断结果的符合率高，差异无统计学意义（P＞0.01）；③正片和伪3D图像格局检出结果和临床诊断结果的符合率低（P＜0.01）。

At last the result of a RIE process at a certain condition is compared with the results of simulation, the result of Lag effect is compared with result of simulation, the results of multiple processes are compared with the results of simulation, respectively, and they fit well.

最后比较了一定条件下的刻蚀结果和模拟结果，比较了Lag效应的实验结果和模拟结果，比较了多道加工工艺结合的实验结果和模拟结果，两者吻合的较好。

To turn out well in the end:结果很好: Don't worry: this project will come out in the wash.

不要着急：这项工程会有好结果的

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。