结构稳定性

The heat of formation is calculated and the stability of the novel structures is discussed and compared with that of the zeolite mordenite.

然后通过能量最小化，确定它们稳定构象的全部晶体结构设计细节以及相应的生成热；进而讨论了这些结构的稳定性。

In particular, compared with conventional fluorophores, the long-lasting phosphorescence nanotubes have a broad and continuous excitaion spectrum and are photochemically stable, which can be used as fluorescent probes in biological staining and diagnostics.

对于纳米结构的长余辉材料来说，它们在纳米器件的标记和显示上具有较大的应用前景。特别是对于纳米管状结构的长余辉来说，它们具有宽的连续发射带和光化学稳定性，使得它们在生物着色和诊断上可以用做荧光探针。

Secondly, according to the construction and characteristic of the N-isopropylacrylamide and the temperature-sensitivity of PNIPA hydrogel, Pdualistic hydrogel was synthesized by microwave low temperature plasma. The effects of the factors on the swelling characteristic of P dualistic hydrogel, such as treatment time and power of plasma, concentrations of crosslinking agent and total monomers, proportion of AMPS, polymerizing temperature etc, was discussed in detail. The three dimensions structure , thermostability , reversional volume , swelling/deswelling kinetics, temperature-sensitivity and pH-sensitivity of the hydrogel were also investigated. The optimal synthesizing technics of P dualistic hydrogel initiated by microwave low temperature plasma was confirmed.

在此基础上，结合NIPA的结构特征和PNIPA的温敏性，用微波低温等离子体引发聚合了P二元智能凝胶，详细探讨了微波低温等离子体处理功率、处理时间、总单体浓度、AMPS单体浓度、交联剂浓度及聚合反应溫度等因素对P二元凝胶溶胀性能的影响；并对其三维交联结构、热稳定性、失水-吸水动力学、温度敏感性、pH敏感性、体积复原性等进行了研究；确定了适合微波低温等离子体引发聚合P二元智能凝胶的最佳工艺。

Due to the key challenge for complicated techniques and preparation, there were few reports about ternary systems. A series of polyimide/SiO_2-TiO_2 hybrid films with different contents of inorganic particle were fabricated using tetraethoxyl silicane and tetrabutyl titanate as precursor in situ with sol-gel method and both phases in situ. Chemical structure and micro-morphology of hybrid films were studied by means of IR, SEM and XRD.

本文以正硅酸乙酯和钛酸四丁酯为前驱体，采用原位溶胶-凝胶法和两相原位同步法制备了一系列不同含量的聚酰亚胺/SiO_2-TiO_2杂化薄膜，利用红外光谱、扫描电镜和XRD观察了薄膜的化学结构和微观结构，并测试了薄膜的热稳定性、电击穿场强和耐电晕性。

A series of polyimide/SiO2-TiO2 hybrid films with different contents and weight ratio of inorganic particle were fabricated using tetraethoxyl silicane and tetrabutyl titanate as precursor by situ method. Chemical structure, micro-morphology and thermal stability of hybrid films was studied by means of SEM, IR and XRD, TGA was also tested.

以正硅酸乙酯和钛酸四丁酯为前驱体，采用两相原位同步法制备一系列不同含量及重量比的聚酰亚胺／SiO2-TiO2杂化薄膜，利用红外光谱、扫描电镜和XRD观察了薄膜的化学结构和微观结构，并测试了薄膜的热稳定性。

A series of polyimide/SiO2-TiO2 hybrid films with different contents and weight ratio of inorganic particle were fabricated using tetraethoxyl silicane and tetrabutyl titanate as precursor by situ method .

以正硅酸乙酯和钛酸四丁酯为前驱体，采用两相原位同步法制备一系列不同含量及重量比的聚酰亚胺/SiO2-TiO2杂化薄膜，利用红外光谱、扫描电镜和XRD观察了薄膜的化学结构和微观结构，并测试了薄膜的热稳定性。

The stability of such system depends on maintenance of tensional integrity inside the structure, or what has come to be termed "tensegrity".

这种结构的稳定性取决于结构内部张力的完整性的保持，因而被称为张力完整性。

The thermal property studies indicate that the mass loss of compound B was 54.39% at 242.2~750℃, and when the temperature was 1000℃, there was 25.11% char residue left, which showed that the title compound has a good thermal stability and char forming capability. Using acetonitrile as the solvent instead of trichloromethane or 1, 2-dichloethane gave higher yield. During the synthesis, the yield was very low when triethylamine was used as acid acceptor alone, and when a little amount of 4-dimethylaminopyridine was added at the same time, the yield could be 81%.

结果表明，所合成的化合物B的结构与预期的结构一致；热性能研究表明，化合物B在242.2~750℃质量损失为54.39%，1000℃时仍有25.11%的炭残渣，显示出优异的热稳定性和成炭性；在相同反应条件下，用乙腈作为溶剂的反应产率比使用氯仿和二氯乙烷为溶剂的高，并且在合成过程中，单独使用三乙胺作为缚酸剂时产率很低，而当同时加入少量4-二甲氨基吡啶时，产率可达81%。

Structural and unstructural uncertainties boundaries of stability are developed.

给出了稳定性分析的结构和非结构摄动边界，减少了保守性。

And the design method for U-steel yieldable support and combined structure of steel and concrete is discussed.

论文首先介绍了地下工程支护结构理论的发展及其研究现状；结合五轮山煤矿施工现场，论文采用超静定结构力学计算方法、有限元的分析方法，主要对浅埋强风化段支护结构进行了力学分析；在总结现有文献研究成果的基础上，分析了型钢与混凝土的粘结机理，介绍了U型钢可缩性支架缩动前后的内力计算方法，讨论了考虑U型钢可缩性支架稳定性的承载能力问题，阐述了U型钢可缩性支架参数选择的原理。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。