结构体

However, more and more studiespresent that the local pressure fluctuations in the separated and reattached region of bluff body are found tobe non-Gaussian. The Gaussian assumption will underestimate the wind load of cladding and cause thecladding to unsafety. It is a general way to estimate peak pressure by a fixed peak factor.

然而，有越来越多的研究表明，钝体绕流的分离和流动再附着区域的风压呈现出强烈的非高斯分布的特性，按照高斯分布进行峰值风压的估计将可能低估作用于围护结构上的风荷载而造成结构的不安全性。

Insulin superfamily includes insulin, insulin-like growth factor 1 and 2, relaxin, and some other small molecules containing a common primary structural motif and similar tertiary structure.

胰岛素，类胰岛素生长因子1和2（IGF-1和IGF-2），耻骨松弛素等均属于胰岛素超家族，它们都具有共同的一级结构模体和相似的三级结构。

NiRs are divided into two different types based on their prosthetic groups, namely heme-containing nitrite reductases (cd1-NiRs) and Copper-containing nitrite reductases.

Cu-NiRs呈三聚体结构，每个单体都含有两种类型的铜原子，它们在酶催化过程中起着传递电子的重要作用。在催化过程中，Cu-NiRs中部分残基的结构变化有利于催化反应的进行。

The thesis presents a practical die structure with angle pin and gear shaft and rack for secondary combined inclined down loosing core of die casting hopper bodies.

本文给出了浮子室体铸件斜销-齿轴-齿条二级联合斜下抽芯压铸模实用结构，论述了模具结构特点和工作过程。

But when Fe/D113 precursor is pyrolysed in the range of 400-700℃, the crystal structure of the iron particle is different. The products are mainly iron oxides andα-Fe as Fe/D113 precursor pyrolysed at 500℃, and as the pyrolytic temperature increases to the range of 600-700℃,α-Fe and Fe_3C are observed. Meanwhile, Al_2O_3、MgO、MgAl_2O_4 were observed in Al/C, Mg/C, Al-Mg/C which were prepared from D113 resin at 1000-1300℃.

而在同样的条件下热解载铁树脂(Fe／D113)，热解产物中铁的晶体结构与热解温度有关，400℃热解产物为铁的氧化物；500℃热解产物为体心立方结构的单质铁；600-700℃的热解产物为bcc单质铁和铁的碳化物(Fe_3C)。1000-1300℃热解含Al、Mg及Al-Mg的D113树脂制得的Al／C、Mg／C、Al-Mg／C材料中Al、Mg主要以Al_2O_3、MgO、MgAl_2O_4形式存在。

Finally this paper discussed the appropriate range of the new element.2. The new element is introduced into the problem of composite structures in which the girder, plate and block exists at the same time. Then this paper discussed the advantages of the elements when dealing with the connect problem.

将本文所建立的单元用于梁、板、块体同时存在的复杂组合结构体系问题当中，讨论了该单元在处理联结问题的优势，通过若干考例验证了该单元在计算组合结构时的合理性。

A great number of viruses' capsid proteins are efficient assembly into icosahedral symmetry structures. The capsid structures obey the quasi-equivalence theory of Caspar-Klug, and they are directly composed of pentagons and hexagons.

摘 要 绝大多数病毒的衣壳蛋白装配成二十面体对称的结构，其衣壳结构遵从 Caspar-Klug 的准等价原理，即是由五边形和六边形直接拼接而成的几何构型。

In general, the subject on the optimal place and the amount of outriggers is more investigated than structure stability.

总的来说，对带伸臂的框架—筒体结构的研究主要集中在伸臂层最优数量和最优位置的问题上，对结构稳定性方面的研究涉及较少。

It should be noted that not only in the complex perovskite like BaO3,(X=Mg, Zn, Co, Ni, Mn: Y=Nb, Ta) but also in the compounds with tungsten bronze structure such as Ba6-3xLn8+2XTi18O54, they are consisted of corner-sharing oxygen octahedra and the ratios of ion in B site to ion in A site are usually larger than one.

值得注意的是业已开发出来的材料不论是复合钙钛矿BaO_3，(X=Mg，Zn，Co，Ni，Mn；Y=Nb，Ta)还是钨青铜结构，它们都是由氧八面体共顶连接，而且氧八面体内、外阳离子比例都等于或略大于1，因此，我们推测在B位与A位阳离子比例略小于1的类钙钛矿结构中极有可能存在具有优良介电性能的新材料。

The structure of La3ScBi5 belongs to the "anti" Hf5Sn3Cu type, and features 1D linear Bi chains and {ScBi3} chains composed of face-sharing ScBi6 octahedra.

La3ScBi5属反式Hf5Sn3Cu结构类型，其结构特征为Bi的一维直线链和由ScBi6八面体之间通过共面形成的｛ScBi3｝链。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。