结合面

A series of twin composition plans can form the check-like morphologies on〓 and〓 faces of YYAB crystal.

孪晶结合面在〓及〓晶面的出露线形成了这些晶面上的格子状花纹形貌。

Under the control valves and flanges of different, have different matching flanges, for example, have flat flange, convex flange ring flange combination of such surfaces.

根据控制阀连接法兰的不同，有不同的配套法兰，例如，有平法兰、凸面法兰、环形结合面法兰等。

Use the ruler and the feeler to inspect whether the joint surface of the cylinder head is deformed.

利用直尺和塞尺检查气缸头的结合面是否有变形。

Then, how to determine the shear design values for different structural member and different strengthening location is given out, which could be the reference for design and computation of strengthening structural member by enlarging section method. Fifthly, Full-range shear experiment of two reinforcement concrete arch specimens with strengthening at soffit location by enlarging section method are designed and conducted.

第四，对于增大截面法加固构件，按照极限状态的计算原则，对外荷载作用下的新老混凝土结合面剪力设计值进行研究，提出了不同类型构件及不同的加固部位，新老混凝土结合面的剪力作用设计值的确定方法，可为采用增大截面法加固构件的设计计算提供依据。

The interface bond capability and the failure mode of soffit strengthening are studied, as well as the influence of strengthening concrete technique to the interface bond capability. The cracked load, the failure load, the tension stiffness, the stress of the steel bar and the cracks of the strengthening arch are compared with those of the contrast arch.

第五，考虑到实际工程应用，设计并制作了采用增大截面法在拱腹部位加固钢筋混凝土拱圈试件，研究拱腹加固新老混凝土结合面的粘结性能及破坏形式和补强混凝土的施工工艺对新老混凝土结合面粘结性能的影响。

In addition, there are bond areas between the new and the primary coverage because of the growing up of the plating coat, which may lead to the emergence of micro crack on the coating owing to such causes as too big or uneven impact during plating process, little distortion of global granular zinc dust inside the plating coat, less tight coalescence of the zinc dust flecks.

由于形成镀层的过程处在酸性环境，在镀层增厚过程中不可避免把酸性溶液包裹在镀层里面，酸性溶液会与金属基体和镀层反应，产生氢气，必然会寻找通道选出，形成微气孔；镀层是逐渐形成的，新生镀层与原有镀层之间存在结合面；镀覆过程由于撞击力过大或者不均匀，镀层内部球形颗粒状锌粉变形较小，球形颗粒与球形颗粒的结合不严密等，这些原因会导致镀层产生微裂纹。

However, various methods are used to suppress surface waves from shooting to receiving in the process of seismic survey, thus research should be carried out in the following aspects:① joint inversion with surface wave, refraction first break and microlog data;② offset range and the relation between group interval and surface resolution suitable for use in surface wave analysis;③ the influences of lateral relief of array on propagation of surface waves;④ method for Hi-Fi purification of surface wave signals;⑤ method for extracting dispersive curve through time-frequency analysis;⑥ forward modeling and in-version methods of surface wave in view of three-layer structure.

但石油勘探从激发到接收，都采取各种方式来压制面波，因而需要开展多方面的研究：①结合面波、折射初至波和微测井信息的联合反演；②地震记录中适合面波分析的炮检距范围、道间距与表层分辨率的关系；③排列横向地形起伏变化对面波传播规律的影响；④高保真提纯面波信号的方法；⑤运用时频分析提取频散曲线的方法；⑥针对三层结构的面波正反演方法。

The connecting rod main part processes a surface being that head hole and both ends big or small are weak, more important faying face and bolt hole locating surface being the connecting rod body and cover treating outside.

连杆的主要加工表面为大小头孔和两端面，较重要的加工表面为连杆体和盖的结合面及螺栓孔定位面。

The static and dynamic characteristics of the beam of a gantry-type machining center are analyzed by means of ADAMS and ANSYS. Considering effect of gravity and cutting forces, the static deformation of the beam is obtained after calculating the interacting forces between the guide and the slide block by ADAMS. Moreover, the contact parameters of the guide surface are acquired by dynamic tests and parameter identification, then they are applied to the simulation model of the beam-slide box system, whose natural frequencies and modal shapes are achieved by modal analysis. Furthermore, the effect of changes of the contact parameters on the dynamic behavior of the beam-slide box system is also investigated.

对一种国产龙门式加工中心的横梁关键部件，采用机械系统多刚体动力学仿真软件ADAMS和有限元分析软件ANSYS进行了静动态特性分析；在考虑重力和切削力作用下，由ADAMS计算出导轨与滑块间的作用力，从而计算出横梁部件的静态变形；通过动态测试和参数辨识方法获得导轨结合面特性参数并将其应用到横梁滑箱系统整体有限元模型中，经过模态分析得到系统固有频率和各阶振型图，并进一步分析了结合面参数变化对横梁滑箱系统整体动态特性的影响。

Cracks will appear during construction and operation period in the weak old-new concrete interfaces on heightened dams.

在大坝加高中，新老混凝土结合面作为一个结构薄弱面，施工运行中难免产生开裂现象。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。