细长度

In this article are introduced three raw materials in spinning wool on cotton spinning frame, analyzed the spinnable count、length limit and spinnability of thus spun wool yam as well as the spinning technology and described the main product and its properties of thus spun wool yarn on cotton spinning frame. The draft technology of the top is also discussed.

文中介绍了羊毛棉纺工艺常用的细羊毛、毛条和细化毛三种原料；分析了羊毛纺纱的可纺支数、长度限制及可纺性；分工艺研讨了羊毛在棉纺设备上的纺纱工艺，并对毛条牵切拉断工艺的特点和滑溜牵伸的应用作相应的讨论；叙述了当前棉纺设备上纺制的羊毛混纺纱主要产品及其特点。

The range of crack influence was illustrated according on the load-crack length curve under the equal Δδ/δ condition, where the parameter Δδ/δ is a ratio of the deflection change caused by crack to the deflection of uncracked column.

然后针对工字形、箱形两种双轴对称薄壁截面柱，具体地分析了在不同荷载、偏心距和长细比条件下裂纹长度对偏心柱挠度的影响规律和范围。

Research shows that temperature, slenderness ratio, section forms of rods, and covering layer thickness to members under fire conditions have a sizable effect on critical load and length of rods, but the effect of rod dead load may be overlooked.

研究表明，温度、长细比、杆件截面形式、保护层厚度对杆件稳定临界荷载和临界长度影响较大，构件自重的影响可忽略，在此基础上给出了不同约束条件下杆件的计算参数。

During the bleaching and dyeing process, cashmere fiber is damnified by chemical aid-agents and the workmanship used, which makes the fiber short, thick and rough, thus it affects the spinnability and weaving capability of the yarn and the handfeel of the finished products.

羊绒纤维在漂白和染色过程中，化学助剂及工艺本身对其都会造成损伤，使其长度变短，细度变粗，手感变涩，从而影响羊绒纱的可纺性、织造性能及成品手感。

Matlab tool was selected and simulation based on fibers was used to get the 3D appearance of a yarn produced by different fiber length and fiber finesses. It is explored that a new simulation method for different material yarns.

选用Matlab模拟工具和纤维级模拟方法实现不同长度和细度纤维构成纱线的三维外观模拟，为不同材质三维纱线模拟探索一种方法。

The length and the fineness of the fiber would not only influence the cost of the factory directly, but also have a great impact on the rate of pilling.

原料的长度与细度直接关系到企业的生产成本，同时也显著影响羊绒针织物的起球等级。

Its head and neck wrapped by the hard crust is totally over 20 cm in length and looks like the armor-piercing bullet.

剑鱼头部尖细，嘴长如箭，头颈部长度可达20公分以上，且由坚硬的甲壳组成，状似穿甲弹。

A combined massaging and brushing tool comprising a main body having a plurality of convexes neatly arranged on a surface thereof, a cutting line positioned suitably away from an end edge thereof and extending in both directions along said end edge wherein an opening is formed by removing said body along said cutting line, a plurality of cutting lines suitably spaced and disposed in the proximity of another end edge thereof and respectively extending downwardly from a location in the proximity of the center wherein a set of enclosures are formed by removing said body along said cutting lines.

一般而言，长纤维是指纤维之长度/厚度之比率大于10%者称之。而在化学纤维当中，所有可纺丝之原料，皆可制成长纤维。长纤维因其每束丝中各单纤维根数与细度又可分为复丝与单丝，通常用于衣着类长纤维大都为复丝，而单丝则大都在非衣着用途，如钓鱼线等，其单纤维直径为60μ以上，甚至可达5 mm。

With this relationship, CTA can be used to monitor the localized flow velocity on the feed side of plate-type membrane module. Good results of velocity measurement were achieved by fixing the Pt wire of 25.4μm in diameter and 9~10mm in length on the net grid supporter on the feed liquid side in plate type membrane module.

利用直径为25.4μm的细铂丝制成长度为9~10mm的热丝传感器，直接固定在板式膜组件料液侧网状支撑物的纵向网线上，取得很好的CTA测速效果。

The initial point of collateral ligament was drilled two holes, 2 to 3 mm in distance, and crossed by steel wire. Then the superficial flexor tendon of finger was crossed under the steel wire and sutured to the terminal point of superficial flexor tendon of finger by 5/0 to 7/0 nontraumatic suture thread to maintain suitable tension, and sutured to collateral ligament by 8/0 nontraumatic suture thread.

用细克氏针在侧副韧带起点处向健侧钻两个相距2～3 mm骨孔穿过钢丝，切开屈肌腱鞘，从指浅屈肌腱一侧近端切取所需长度肌腱束，此肌腱束穿过钢丝孔，保持肌腱束的合适张力，用5/0～7/0无创线缝合于浅腱止点，应用8/0针线将肌腱束缝合于韧带上。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失