组合部件

In the remanufacturing process, used equipment is disassembled and cleaned and worn parts are replaced before the unit is refinished and reassembled.

在再制造过程，使用的设备拆卸，清洗和更换磨损的部件是在单位是抛光和重新组合。

The elements are also used to get the section polygons of such composite surfaces as the whole aircraft at a given body station, then a section area is approximated with the sum of trapezoidal areas between such sides of polygons that are not covered by any other component and a reference axis.

离散出的面元还被用于求取全机这样的组合曲面在某一站位处的横剖面多边形，而横截面积则用累积多边形不被其他任意部件遮挡的各边与参考轴间的梯形面积予以近似。

And productivity and calculate the card bore and make the lathe up to design including processing the process picture of the part, processed sketch map, lathe to contact size picture and and the calculated card of productivity, named " three pictures and one calorie " that usually spoken are designed; Many axle case part is it include many axle case design primitive drawing, main shaft choice and power calculate, design of transmission and calculate, etc., structure of form that basis pursue mainly to design.

粗镗组合机床总体设计包括被加工零件工序图、加工示意图、机床联系尺寸图和生产率计算卡，即通常所说的&三图一卡&设计；主轴箱部件设计主要包括主轴箱设计原始依据图的绘制、主轴结构形式的选择及动力计算、传动系统的设计与计算等。

And productivityand calculate the card bore and make the lathe up to designincluding processing the process picture of the part, processedsketch map, lathe to contact size picture and and the calculatedcard of productivity, named " three pictures and one calorie " thatusually spoken are designed; Many axle case part is it include manyaxle case design primitive drawing, main shaft choice and powercalculate, design of transmission and calculate, etc., structure ofform that basis pursue mainly to design.

粗镗组合机床总体设计包括被加工零件工序图、加工示意图、机床联系尺寸图和生产率计算卡，即通常所说的&三图一卡&设计；主轴箱部件设计主要包括主轴箱设计原始依据图的绘制、主轴结构形式的选择及动力计算、传动系统的设计与计算等。

The battery pack include Li-ion cells, pack shell, control-protect circuit board and binding interface etc., which has high capacity, low weight, small volume, long cycle life, safety, friendly environment and conveniently replacement.

蓄电池组主要包括锂离子电池组合电芯、外壳、控制保护电路板、接口等部件，具有容量高、重量轻、体积小、使用寿命长、安全、绿色环保、替换方便等突出优点，可直接与现用客车蓄电池进行互换。

After reading the relevant references, the author of this paper has discovered that as one of the most important parts in the crank press, a few optimized designing has been included in this field.

作者查阅了大量相关资料后确发现，对于曲柄压力机的关键部件———组合摩擦离合器制动器的优化设计研究相对较少。

The company is capable to design and manufacture all alone all kinds of containers and flow office con|ainers, and as request make structurally special enntainers and flow office containers, such products with large capacity and extra height and lcngth as steel containers, ventilators, open top containers, open side containers, eqnipment containers for special purpose, office maintenance containers, living containers, rush bin, toilet case, watch house-ease, containers for dining hall, 2 in 1 or 3 in l office compound meeting room, collapsible containers, and other containers and flow office containcrs of distinct sizes.

佛山市南海平洲友利集装箱有限公司能自行设计制造各类集装箱及流动办公室箱，也能按客户要求制造特殊构造的集装箱及办公箱，如大容积超高超长的钢质集装箱、通风箱、开顶箱，侧开门箱、设备专用箱、办公装修箱、住宿箱、垃圾箱、厕所箱、值班室箱、饭堂用箱、二合一或三合一组合办公会议室箱、装拆箱及其他不同尺寸的货箱及办公箱和集装箱专用部件、八字板、顶板、侧板、低横梁、角柱头等。

This paper presents the present development of rape combine home and abroad and the running principle of typical threshing and separating system. And comparative experimental investigations are done between different threshing and separating systems, such as rasp-bar-plate-tooth drum with grid concave, axial-flow -short-rasp-bar drum with grid concave and spike-tooth drum with grid concave.

本文详细介绍了国内、外油菜联合收割机研究现状及典型的物料脱粒分离系统的工作原理，对油菜联合收割机不同的脱粒分离部件组合的脱粒分离系统——纹杆—板齿-栅格凹板、短纹杆—栅格凹板、钉齿—栅格凹板脱粒分离系统进行了对比试验与研究。

The paper introduced the general scheme,the process plan and some key technics of NC trnsfer line for several kinds of cylinder head cam shaft cover s manufacture of car engine,some important parts were discussed in detail.

介绍了轿车发动机缸盖凸轮轴轴承盖多品种加工数控组合机床自动线的总体布局、工艺方案以及线上采用的关键技术，并对部分重要部件作了较详细的叙述。

Project areas may include waveguide components and subassemblies used in the RF path between a microwave transceiver and the antenna, such as diplexers, filters and couplers

项目范围可能包括用在微波收发器和天线间通道的波导管组合件和部件，比如双工器、滤波器和耦合器

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新