组合分析

The results are as follows:Defatted wheat germ was micronized useing both hammer mill and colloid mill to increase the extraction rate of protein, followed by alkali extraction and ultrafiltration, respectively. A quadratic mathematical model was statistically constructed by using of Box-Behnken central composite design and response surface methodology. Under the optimized processing parameters of 23μm particle sizes, pH 9.5 and 51℃, a maximum extraction rate, 68.6%, was achieved, which is 30.63% higher than that of non- micronized wheat germ (passing through 80 mesh sieve).

首先采用锤式粉碎与胶体粉碎相结合的方法对脱脂麦胚进行微细化处理，然后利用碱提、超滤浓缩法提取制备麦胚蛋白，并通过Box-Behnken中心组合设计及响应面分析建立预测麦胚蛋白提取率的二次多项数学模型，优化蛋白质的提取工艺，在麦胚粒度为23μm、pH值9.5、提取温度51℃的条件下，经微细化处理的蛋白提取率为68.6％，比未经微细化处理的(过80目筛)提高30.63％。2。

The scaling test showed that additive effect was accepted for the inheritance of haustorium in MX×AQ. The heritability was about 68%, which was higher than others. However, based on analysis of scaling test, there was no additive and dominance model adequate for LB×XN and AQ×XN, and their heritability were lower.

尺度模型检验结果表明MX×AQ组合中条锈菌吸器的遗传符合加性模型，遗传力较高为68%，而LB×XN和AQ×XN经尺度检验分析不符合加性—显性模型，遗传力较低。

In this dissertation, we optimized the thinkness of each layer of TFEL devices using the layered optimization method to obtain ZnS: Ce〓 TFEL devices. Accoding to the energy level structure of Ce〓, two criteria for distinguishing the EL of Ce〓 were found out, from which it was conduded that the TFEL of ZnS: Ce〓 comes from 5d→4f transition of Ce〓. The measurement of brightness waveform showed that the TFEL of ZnS: Ce〓 was the luminescence from independent centers. and there were the field induced-delocalization in this process anf it〓s the cause of low TFEL efficiency of ZnS: Ce〓. In this dissertation, different influence factors on TFEL of ZnS: Ce〓 were sdudied. The influence of different host lattice is different: The blue/green ratio of ZnS: Ce〓 in hexagonal system of ZnS is larger than that in cubic system of ZnS, and the TFEL peaks in hexagonal system of ZnS moves toward longer wavelength compared with that in cubic system of ZnS. The adding buffer layer was used in this stage. The solubility of Ce〓 in ZnS was small and it was another limit to TFEL brightness of ZnS: Ce〓 device. The solubility of Ce〓 increased ten times when using Li ions as flux, so that the TFEL brightness of ZnS: Ce〓 was enhanced. It was found that the appearing of ZnO in active layer improves the TFEL of ZnS: Ce〓: the brightness and the wave range of ZnS: Ce〓TFEL were enhanced.

本文采用TFEL的分层优化方案，优化组合了各膜层厚度，选择最佳制备条件，得到了ZnS：Ce〓的TFEL；根据Ce〓的能级结构，找到了判别Ce〓的EL的两个简单依据，并据此断定ZnS：Ce〓的TFEL的两个发射峰分别属于Ce〓的〓和〓跃迁；亮度波形测量表明ZnS：Ce〓的TFEL属于分立中心发光，分析认为在此过程中存在着较严重的场致离化，这也是ZnS：Ce〓的TFEL效率较低的一个原因；本文考查了影响ZnS：Ce〓的TFEL的各种因素，发现：基质的晶体结构对ZnS：Ce〓的TFEL有所影响，在六角相ZnS中Ce〓的TFEL优于立方相ZnS中Ce〓的TFEL：发射峰的蓝-绿比相对较大，且光谱向短波方向移动，在此项研究中本文采用了在发光层前增镀过渡层的办法，过渡层为六角晶相的ZnO；限制ZnS：Ce〓的TFEL器件亮度的一个原因是Ce〓在ZnS中的溶解度低，本文用Li离子作助溶剂增大了Ce〓的溶解度，增大幅度为一个量级，并且ZnS：Ce〓的TFEL亮度明显提高；从ZnS：Ce〓的TFEL光谱来看ZnS：Ce〓的TFEL波长覆盖范围较小，亮度也不高，达不到做为白色TFEL材料的要求，需要寻找新的白色TFEL材料；在研究ZnS：Ce〓的TFEL中还发现：发光层中ZnO的出现有利于ZnS：Ce〓的TFEL：发射峰变宽、亮度增大。

This was done to keep anyone else from picking up a discarded ticket and claiming it was his own (a train ticket did not lose all value when it was punched because the same ticket was used for each leg of a trip). Hollerith realized how useful it would be to punch new cards based upon an analysis of some other set of cards.

因为相同的票作为一次旅行的每只腿，所以当它被以拳重击的时候，一张火车票不失去所有的价值Hollerith 了它会是多么的有用以拳重击基于卡片的一些其他的组合一项分析的新卡片。

After simplification of the Jou model,a diffusion dynamic equation, which was characterized with hyperbolic type, was obtained, then simulative analysis for three combined dimensionless parameters was done to research various diffusion behavior resulted from the change of model parameters.

经过对Jou模型的简化处理，得到了双曲型的扩散动力学方程，通过对模型中3个组合参数的仿真分析，研究了参数的变化可能导致的不同的扩散行为。

During the course of the short-cycle correlation, This paper assembleds the descending cycle of early cycle and the ascending cycle of late cycle, which are conjointed together , begin to correlate and draw the ichnography . By this method , writer can consider the two connected sandbodies as one unit to analyse , and can contact the sand units of exploitatition in the oilfield. Then analyse the distributing and the continuity of the sandbodies in the medium-cycle, the distributing and the continuity of oil and gas in the short-cycle.

每个中期旋回包括 3-4 个短期旋回，在短期旋回的对比中，将垂向上相邻的早期短期旋回的下降半旋回和晚期短期旋回的上升半旋回组合到一起进行对比划分和平面成图，这使得相邻两套的粉砂岩作为一个单元进行分析，与油田开发中的小层紧密的结合到一起。

So the method of Ichnology can't use in environmental analysis correctly. A detailed study has been conducted to investigate ichnology of Jialingjiang Formation and sedimentary environment by analysized trace fossil assemblage and ichnofacies.

本人在总结前人研究成果的基础上，对该地区遗迹化石的系统古生物学做了详细研究，并利用遗迹组合、遗迹相分析等方法对沉积环境做了进一步探讨。

It detailedly analysis the computer operation process: picture import and export, module design, datda handle, result output and board automatic number and verticall guide load; displacements and interal force analyses of all kinds of loads; combination of internal force.

在此基础上本文进行了LC复合墙结构的计算机程序设计，详细论述了图形输入输出设计、模块化设计、数据处理、结果处理、楼板的自动编号及竖向导荷，各种荷载作用下的内力及位移分析，然后进行了内力组合。

Based on the quality of linear operation about indefinite integral, the article puts forward an indefinite integral principle of making linear combination and reducing power of integrand.

从不定积分的线性运算性质出发，给出了计算不定积分的被积函数线性组合化、降幂的积分原则，并结合实例分析了这一原则在不定积分计算中的指导作用

It was identified that male sterility of Tagetes erecta was Nucleo-Cytoplasmic interaction type with the characteristics of environment insensitiveness and stable inheritance, and was qualitatively controlled by a recessive gene in nucleus.

对雄性不育遗传规律进行了研究，对不同杂交组合亲本和子代的性状进行了分析，找到了一个重要的育性形态标记，即无花瓣型不育类型。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐