线路

The mainly learnning is low-voltage apparatus、three phase asynchronous motor and electric control wiring of DC Motors、Principle and control of stepper motor and control wiring of typical electric machine、basic theory and basic methods of machine equipment electric control、 basic control circuit of electric control system、analysis of typical electric machine control System、basic principles and methods used of PLC、design and debug of machine tool control system、 design of electrical control gear etc.

主要学习常用低压电器、三相异步电动机和直流电动机的电气控制线路、步进电动机工作原理及控制以及典型机床电气控制线路、机床设备电气控制的基本理论和基本方法、电气控制系统的基本控制电路、典型机床电气控制系统分析、可编程序控制器的基本原理及使用方法、机床控制系统的设计和调试、电气控制装置设计等内容。

This article angle has analyzed the higher professional technical education from CBE/DACUM "the electrical control technology" the curriculum ability localization, according to the higher professional technical education "the electrical control technology" the curriculum ability localization, point out the insufficiency and flaw existed in commonly used control electric appliance choice, electrical pilot wire road map, electricity control system installment, wiring craft, electrical control line fault diagnosis system approach, new starting velocity modulation equipment and control circuit, control circuit and main circuit aspect and so on.

摘要本文从CBE/DACUM角度分析了高职&电气控制技术&课程的能力定位，根据高职&电气控制技术&课程的能力定位，指出了现行高职&电气控制技术&教材在常用控制电器选择、电气控制线路图、电气控制系统安装、接线工艺、电气控制线路故障诊断的系统方法、新型起动调速设备及控制电路、控制电路与主电路的连接等方面存在的不足和缺陷。

Microwave radio links or wire lines carry both voice and data between the cell site and the MTSO.

微波无线线路或有线线路在无线基地站和移动电话交换局之间传送音频信号和数据信号。

According to the learning of the Power l Supplying Projet, the primary design is about the 10kv switch-substation, according to the load and demand of the supply electric system of factory, the design of the gather reduction voltage substation and distribution system, and the checking of the main electric apparatus, the protection and adjusting and the lightning protection of the main voltage changer and line.

开闭所继电保护设计*。本文通过对供电工程的学习，主要是针对10kV 开闭所进行初步设计。根据所提供的负荷及对供配电系统的要求，对主要设备进行选型校验，对主变压器、线路进行保护整定计算，对主、变线路进行防雷保护等。

First, we introduce the principle of feeder protective apparatus and select adequate protective equipments in accordance with different types of distribution system, using the least square error method to simulate the time/current curve and applicate simulation formula to digital the curve data, Secondary, using augmented incidence matrix method to find the exact pairs of primary/backup protection relay and find the relay tripping sequence of distribution lines.

首先介绍线路之过电流保护设备动作原理，依不同之配电系统型态来选用适当之保护设备种类，并使用最小平方误差法模拟保护电驿之时间－电流特性曲线，应用模拟方程式将曲线之资料数位化，且藉由图形理论中之增广关联矩阵法求取正确之主保护与后卫保护电驿对，以找出系统中各配电线路保护电驿间之跳脱顺序关系。

Trip over the line cord, and the line cord cannot be damaged.

请将本产品安装在受保护的场所，以免有人踩到线路或被线路

Lightning flashover is the main reason that causes trip out in the transmission line,hence it is necessary to estimate the lightning performance of the transmission line which is in the designing.

雷击闪络是引起输电线路跳闸的主要原因，因此必须正确评估设计中的输电线路的防雷性能。

Principle of non-communication complete transmission line UHS protection is proposed according to the effect of line trap and transmission line frequency dependant property on travelling wave.

2在行波原理方面，考虑行波产生的机理特别是线路阻波器、输电线路频率相关特性等的影响，利用行波波头的故障特征，提出了新的单端行波保护原理——无通信全线速动行波保护原理。

By studying on the settlement observation data of three field test spots, the special settlement curve characteristics of transverse section and longitudinal section of roadbed are gained.

通过对三个试验工点沉降观测数据的分析研究，得到了过渡段路基在线路横断面和线路纵断面上特有的沉降曲线规律。

The conductor transposition principle and parameter calculation method of four-phase power transmission line with arbitrary conductor configuration are researched, and the compatibility between four-phase and three-phase power transmission systems is analyzed.

讨论了导线任意排列的四相输电线路的换位原则与参数计算方法和四相输电线路与现有三相系统的兼容问题。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。