线槽

In this paper,a cutting method of machining straight slot-parts is mainly researched by using the principle of cycloid .

本文主要研究利用摆线原理加工直槽的方法，从理论方面证明利用摆线原理加工直槽的可行性，并且基于VER ICUT仿真平台实现了直槽类零件的连续切削的动态加工仿真

Results revealed that the large side insulation of the stator bar in slot is available for ultrasonic pulse-echo testing; Coupling transducer on the surface of a practical stator bar could minimize the influence on the measurements of velocity, contributing no destructivity of the ultrasonic testing for stator insulation; The simultaneity of same velocity and higher attenuation can be used to detect insulation delamination from conductors; Compared with the wide sides of the bars in slot, the short sides of the bars near the exit from slot and the end bars had a same velocity and a higher attenuation; The velocity might be exactly measured on the shot sides of the bars near the exit from slot and the end bars, while the attenuation might not, which were examined though filed tests; V min decreased greatly and V av decreased slightly with the service time of the bars.

在实验室对线棒多种结构处的主绝缘和不同运行年数(未老化、16、18 和23年)线棒的主绝缘进行了低频超声反射法检测试验，并进行了现场试验，发现(参见 Hao et al， IEEE DEI， to be published)，槽部线棒的宽面绝缘不受换位绝缘的影响，比窄面绝缘更适合超声测量；线棒表面平滑的半导体层减小了耦合剂对超声测量的影响，实现了无损性；波速不变而声衰减减小可以检测线棒出现绝缘与导体脱壳缺陷；出槽口和端部线棒的窄面绝缘与槽部线棒的宽面绝缘相比，声衰减大而波速一致；现场试验验证了波速不受绝缘结构和现场测试条件的影响，而声衰减受以上因素影响很大(参见 Hao et al，中国电机工程学报， Vol.23 No.4)； V min 随运行年数明显减小， V av 随运行年数慢慢越小。

Disclosed is a leaky-wave dual polarized slot type antenna, including: first and second feeding circuit sections comprised of N-first strip lines and N-second strip lines with a loop every first period along the X-axis on the first dielectric layer and a second period along the Y-axis, in which the N-first strip lines and the N-second strip lines are parallel to each other being alternate, and each length of Ls1 and Ls2 for the first period satisfies the equation of , first and second multi-channel dividers formed at once and the other sides of the first dielectric layer, to connect the N-first strip lines and the N-second strip lines parallel with each other; and first and second central ports formed in the opposite direction of the cavity, each of the feeding circuit sections being connected to the first and second multi-channel dividers; and first and second slot sections being formed by patterning the second shielding layer, in which M-first and M-second slots are arrayed along the direction of the X-axis and each of the first and second slots forms N-row first and N-row second slot arrays, respectively, which cross the first and second strip lines for each, the first slot and the second slot being orthogonal to each other.

公开了一种漏泄波双偏振槽型天线，包括：第一和第二馈电回路部分，其具有沿着X轴在第一介电层每第一周期以及沿着Y轴的第二周期形成具有环路的N第一带状线和N第二带状线，其中N第一带状线和N第二带状线彼此平行并交替，并且对第一周期的各Ls1和Ls2的长度满足等式，第一和第二多通道分配器寻形成在第一介电层的一侧和另外一侧上，以连接彼此平行的N第一带状线和N第二带状线；以及形成在腔的相对方向中的第一和第二中心端口，每个馈电回路部分连接到第一和第二多通道分配器；以及第一和第二槽部分，所述第一和第二槽部分通过对第二屏蔽层形成模式而形成，其中M第一和M第二槽沿着X轴的方向安置，各第一和第二槽分别形成N行第一和N行第二槽阵列，其对每个横过第一和第二带状线，第一槽和第二槽彼此正交。

The Jiangsu HaiXin electrical equipment Limited company found in 2001,which is specialized in producting high and low pressure switch compiete set of equipment,the high and low pressure bus bar rabbet,the electric cable bridge, the box-type transformer substation,the ground metal raceway.

镇江市海鑫电气设备有限公司创建于2001年，是专业生产高低压开关成套设备、高低压母线槽、电缆桥架、箱式变电站、地面金属线槽的专业厂家。

Usage rate of the raceway less than 60%.

分线槽使用率在 60%左右。

The pass-through slots have little rubber grommets to keep moisture out.

这些线槽上一些索环来防止潮气进行。

In order to improve the quality of "Xintongda" brand hot-galvanize series products and guarantee to carry out the latest national standard of GB3640-88 and GB/T2518-88, in Beijing and Guangzhou, we have invested large quantity of funds to introduce American Sendzimir hot-galvanize production line to manufacture "Xintongda" brand hot-galvanize series, including hot-galvanize braiding pipe, square pipe, rectangle pipe, circular pipe, wire pipe, electric cable bridge truss, C-steel and strip steel, etc. The products have enjoyed a good reputation for their best quality, various varieties and considerate after-service.

为提高&新通达&牌热镀锌系列的品质，保证产品严格执行GB3640-88和GB/T2518-88最新国家标准，在北京，广州等科研单位的协助下，我们又投入了大量资金，引进了美国森吉米尔热镀锌生产线，从而使热镀锌穿线管，方型管，矩形管，圆形管，线槽，电缆桥架，C型钢及带钢等&新通达&牌热镀锌系列的质量更保证，品质更超群，品种更繁多。

CABLE TIES,CABLE DUCTS,NYLON CABLE GLANDS,; TIE MOUNTS,STRAIN RELIEF BUSHINGS,; HEAT SHRINKABLE TUBINGS,MOVABLE BUSHING,; CONDUIT FITTING...

配线槽类/束带固定座类/结束带类/电线固定夹类/绝缘套类；*电线固定保护类/电线标志类/扣具/基。。。

Since I founded the company has experienced over 20 set, now has 22 million yuan in fixed assets, staff of 256 people, 63 technical personnel, the Company to develop and produce the fire-retardant glass pipe box, also known as cable bridge, such as trunking With corrosion-resistant, anti-aging, high strength, fire-retardant properties, and insulation, light weight, long life, easy to install and simple advantages of the current highway, railway, municipal bridges, post and telecommunications, Flight Operations, electricity, communications bridge a Of the ideal replacement products.

我公司自创办至今已经历二十多载，现拥有固定资产2200万元，职员256人，技术人员63人，本公司研制生产的阻燃型玻璃钢管箱，又名电缆桥架、线槽等具有耐腐蚀、抗老化、强度高、阻燃性能好、绝缘、重量轻、使用寿命长、安装方便简单等优点，是目前公路、铁路、市政桥梁、邮电、航务、电力、通信桥架的一种更新换代的理想产品。

Our company has set up a factory in Shenzhen city, which specializes in manufacturing XQJ series of electric cable bridge truss, galvanized wire slot and low-voltage distribution plant with best quality.

我司已在深圳设置分厂，专门生产XQJ系列电缆桥架，镀锌线槽及低压配电设备，产品质量可靠，受到广大用户和同行业好评。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了