线性

Analyses factors which affect apparatus dew point by theory and experience. Points out that to a given surface air cooler, the relation between apparatus dew point temperature and entering air dry bulb temperature or entering cooling water temperature is linear under dry cooling conditions, and the relation between apparatus dew point enthalpy and entering air enthalpy or ...

指出结构特性一定的表冷器，干工况下冷盘管表面平均热状态温度和进风干球温度、冷水初温成线性关系；湿工况下在空调常用范围内，冷盘管表面平均热状态焓值和进风焓值、冷水初温成线性关系，且两种工况下冷盘管表面平均热状态温度都随迎面风速增大而增大，随水流速增大而减小。

The tree diameter at breast height and crown length can be used to predict the size and location of mean knot diameter in a whorl.A linear mixed model expressed as function of tree and knot variables such as HK、RKD、KD and DBH was used to predict sound knot length,and a log-linear mixed model using RKD and DBH as variables was used to describe loose knot length.4.A knot has four development phases:from the birth of a branch to its growth cessation,from growth cessation to death,form death to occlusion and form birth to occlusion.The numbers of annual rings in four periods,as well as the stem width of respective zones were used as dependent variables predicted by models expressed as function of tree variables and knot attributes.5.Using the data of diameter out side bark of 15 relative heights along the step,the best taper equation for Larix olgensis was established.

节子平均直径可以用以胸径，冠幅和节子高度为参数的舒马克生长方程来预测，用树木胸径和冠长可对每轮节子平均直径的最大值及位置进行预测；健全节长度可用以节子着生高度、相对直径、节子直径以及树木胸径为参数的线性混合模型来预测，疏松节长度采用节子相对直径和胸径为自变量的可转化为线性模型的自然对数模型来预测；4、节子有四个生长发育时期：从枝条形成到生长停止BC从生长停止到死亡(CD从死亡到包藏DO从形成到包藏

The company's main products include Ball Screw, Support Unit, Shaft Supporter, Slide Bush, Slide Unit, Self-Lubricating Linear Guideway, Dual Shaft of...

公司主要产品：滚珠螺杆、螺杆支持座、轴心支持座、线性轴承、直线轴承座、自润式线性滑轨、。。。

The linear slide rail and aluminum alloy beam, along with linear bearing and high-rigidity bearing steel, are employed so as to meet the requirements of high-speed take-out, high

下手臂均采用进口的线性滑轨和铝合金挤型梁配合线性轴承及高刚性轴承钢，能达到取出速度快、高效能、高精度、使用寿命长的要求。

Influence of specimen size and curing temperature on volume expansion of steel slag sand mortar ;2. This research deals with the mechanical mechanism of expansion of steel slag sand mortar through the measurement of strength and expansion rate.

通过力学性能和80℃水热加速养护条件下砂浆棒自由线性膨胀率实验，结合SEM等微观测试技术，分析探讨了不同基体强度对钢渣砂砂浆膨胀行为的影响及水热养护不同龄期的力学性能与自由线性膨胀率的关系，从力学角度阐述了SSM膨胀破坏的机理。

This research deals with the mechanical mechanism of expansion of steel slag sand mortar through the measurement of strength and expansion rate. The results indicate that the improvement of matrix strength could lower the expansion rate of steel slag sand mortar, extend the cracking age, reduce the degree of cracking but couldn't prevent the specimens made with steel slag from crack.

通过力学性能和80℃水热加速养护条件下砂浆棒自由线性膨胀率实验，结合SEM等微观测试技术，分析探讨了不同基体强度对钢渣砂砂膨胀行为的影响及水热养护不同龄期的力学性能与自由线性膨胀率的关系，从力学角度阐述了SSM膨胀破坏的机理。

With analysing the the fatigue mechanism, the general mode of interply fatigue damage propagation is denoted by delamination length and crack density. Based on the power-law, the relationship between number of cycles and delamination length and crack density are established. The specimen is modeled as an equivalent six-ply material system. Starting with the analysis of interply stress, the interply shear stress under cyclic loading is calculated by using nonlinear three-demension FEA. According to the stage regularity of fatigue damage propagation, such models as average strain, effective modulus, ratio of delamination length and crack density, experimental relationship between crack density and effective modulus, are proposed by introducing subsection coefficient.

通过对疲劳机理的分析，确定了以脱层长度和裂纹密度表示的层间疲劳损伤演化的一般模式，利用指数法则建立了脱层长度和裂纹密度随疲劳循环周次变化的关系；从层间应力分析入手，以等效六层的材料模型对循环载荷下的层间剪切应力进行了三维非线性有限元分析；根据疲劳损伤扩展的阶段性，引入分段系数，分别建立了平均应变与载荷循环周次的分段线性模拟模型、有效刚度随载荷循环周次的变化关系模型、裂纹密度变化和脱层长度变化关系随载荷循环周次变化的分段线性模型以及疲劳裂纹密度和有效刚度关系的经验模型。

According to the problems above, this paper analyzes how to design current filter under the situation of Linear Second-Side Power System and SSPS; how to use Amorphous Cores in the design of HVIT and the advantages it brings; why "series-wound problem" happens and the relationship with SSPS switching frequency; how to improve power losses of LSPS and how to use PCB for the thermal design of SSPS.

论文针对以上四个问题，详细分析在恒功率型线性以及开关二次侧情况下电流滤波网络的设计；功率等级提升情况下，非晶材料在高频高隔离变压器中的应用及优势；&串扰&问题的原因以及二次侧工作频率的影响；线性二次侧的损耗改善方法以及开关二次侧利用PCB散热的实现。

The peakpositions of the TPA spectra of this series of compounds are located at ～950 nm, and thecorresponding maximal TPA cross-section has been measured to be as large as〓.

双光子吸收谱的谱形与线性吸收谱相应波段内的谱形相似，与线性吸收的峰值波长的两倍相比较，双光子吸收峰值波长有微小蓝移。

Shaft Type Linear Guide,Linear Ball Bearing,Shaft ,Oilless Bearing ,Linear Guideway,Ball screw,Coupling,Support unit,Safety Bearing Nut,Luck Nut,Unive...

轴心式滑轨，线性轴承，特殊自润轴承，轴心，线性滑轨，滚珠螺杆，联轴器，螺杆支持座，防松螺帽，锁定螺帽。。。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。