纵

The main projects of strip-slitting factory: edge slitting, end slitting, butt weld, coil joint, etc. The scale of specification: thickness 0.6-3mm, width 50-520mm. The products are mainly exported to South Korea, Southeast Asian countries and middle-east area etc.

带钢纵剪加工项目主要包括：切边、切头尾、对焊、并盘等，纵剪加工后成品规格范围主要是：厚度0.6mm -3mm ，宽度50mm -520mm ，其纵剪加工产品以出口为主，销往韩国、东南亚国家和中东地区等。

This method makes the complicated space structure calculation decompound into a couple of related plane problem. The bottom structure is supported by longitudinal beams in cross calculation, and then the cross forces and elastic supporting forces are obtained.

横向计算中，底部弹性支承在各纵梁上，可求得结构的横向受力与弹性支承反力；然后将弹性反力作为荷载，反向作用于纵梁上，进行纵梁的受力计算。

The following is the main works of the paper.1 The weight and the center of weight of the whole hull, analysis by statics the weight of steel, the equipment, oil, water, crew and cargoes etc., conclude a method of calculating the weight and the center of weight of the whole hull,2 Work out the series of formula of distributing the water pressure of wave to the corresponding nodes on the plate, conclude a method of calculating the flotage and the center of the flotage,3 Analysis the method of adjusting the equilibrium of the hull, the finite element module of the hull, and the character of the linetype, by ship statics principle, work out a series of formula of adjusting longitudinal slant, preliminarily confirm the parameter and the range,4 Program in FORTRAN, and link into ANSYS, for auto-loading when analyzing the whole hull by the FEA,5 Make the finite element module of a real hull, calculate the weight and the center of the weight, the flotage and the center of the flotage, compare the result of manual calculation with the computed result, analysis the deviation of the program.

3通过分析船舶常用浮态调整方法、船体结构有限元模型和船体线型特征，运用船舶静力学原理，推导船舶浮态纵倾调整公式，分析了基于船舶结构有限元模型的纵倾浮态调整方法和初步探讨了纵倾浮态调整中的参数确定方法以及初步确定这些参数的取值范围。 4用本文推导的计算方法和公式开发FORTRAN程序，并编译连接到有限元软件ANSYS中，用于进行整船结构有限元分析时自动加载计算。

The motion decay tests in still water and in re gular head waves were carried out to analyze and verify the low frequency dampin g in surge motions.

在海洋环境的作用下，该系统具有小振幅的高频纵荡、垂荡、纵摇及大振幅低频纵荡运动。

Firstly, full factorial experiment method is implemented to achieve an optimization of longitudinal microstructure design in the incidence plane of a LGP for LED BLUs. There are three control factors involving in the optimization process: the pitch and depth of both V-cut and U-cut, and angle and radius for V-cut and U-cut, respectively. Each individual control factor has three levels. It leads to a total of 27 sets of experiments.

本实验先行讨论全因子实验求取发光二极体背光模组之导光板入光侧纵沟微结构最佳化设计，选定入光侧V-cut纵沟微结构控制因子：V-cut角、V-cut间距、V-cut深及入光侧U-cut纵沟微结构控制因子：U-cut半径、U-cut间距、U-cut深等项目，其中各一因子分别有三个水准变化，依控制因子及其水准的目各进行27组实验。

Plate and λ/2 plate were placed inside the Nd∶YVO4KTP green laser cavity with angle 90°between their fast axis.The composite plate composed of HWP,QWP and KTP has the function of QWP.The composite plate with Nd∶YVO4 can effectively suppress the coupling of polarized modes,and multi-longitudinal-mode lownoise green laser was obtained.Since the composite plate counteracted the phase shift induced by temperature sensitivity of quartz plate,the green laser operated with lownoise reliability in different output power and different operation temperature.The threelongitudinalmode, the noise of less than 0.5% and output power stability of less then 1% for 12 hour are obtained in the green laser.

介绍了一种LD泵浦腔内倍频全固体Nd∶YVO4KTP多纵模、低噪音、高功率稳定绿激光器在Nd∶YVO4KTP绿激光器组成的谐振腔内放置厚度约相等的石英晶体λ2波片和λ4波片，使两波片快轴夹角互呈90°，HWP、QWP与KTP构成复合波片，其作用相当于QWP，此复合波法与各相异性Nd∶YVO4共同作用有效抑制了腔内偏振模耦合，获得多纵模低噪音绿光输出此复合波片相互作用由于抵消了石英晶体波片温度敏感引起的相位延迟量漂移，所以此激光器在不同功率、不同工作温度下，均能稳定可靠地运转于低噪音状态实验结果为，绿光输出纵模数为3个，噪音小于0.5%，12 h功率稳定性优小于1

This paper expatiates the physiological mechanism and the factor influenced of the strength of vertical jump from physiological angle.

从生理学角度阐述了纵跳力的生理机制和影响因素，提出纵跳力量训练应遵循的原则，介绍了几种重要而常见的纵跳力训练的方法和注意事项，并指出训练中的一些不科学不合理的力量训练方法，为科学训练提供有益参考。

Results: 24 cases of SAHLC produced the following CT manifestations: widening of anterior longitudinal cistern, sometime SAH visible in callosal sulcus or/and cingulate sulcus, so-called "callosal sulcus sign"; feather's configuration of longtitudinal cistern, partial disappearance of contiguous sulcus; widening of posterior longitudinal cistern with a coarse borderline.

结果：24例少量蛛网膜下腔出血表现为前纵裂池高密度影长度增加，8例伴有胼胝体沟征；纵裂池呈局限性羽毛状高密度影，邻近脑沟消失；后纵裂池密度增高增粗，边缘毛糙；复查显示上述征象均消失。

In rat esophagus, the positive varicosities and fibres could be observed in the circular muscle layer and the muscularis mucosae layer at 21st day before birth. With the development of rat digestive tract, neurokinin A-immunoreactivity positive nerves could be observed gradually in the epithelium, submucosa, longitudinal muscle layer, myenteric plexus and submucosal plexes, while mature nerve fibres could be seen at one month after birth. 2. In rat stomach, the positive reaction of NKA initially happened in the myenteric plexus at the 14th day of embryo, and then appeared on circular muscles, longitudinal muscles, submucosal, muscularis mucosae, lamina propria and epithelium. 30 days after birth, expression of NKA is same as seen in adaulthood. 3. In rat small intestinal, the NKA-IR could first be found in the myenteric plexus of the duodenum, jejunum and ileum at 14th , 15th and 17th day before birth respectively. Then the NKA-IR occurred in the longitudinal muscle layer, circular muscle layer, intestinal villus, intestinal gland, muscularis mucosae, submucosa, submucosal plexes, mucosa plexus and deep muscular plexus.

结果 1、在食管，于胚胎21天的粘膜肌层和环肌层内观察到神经激肽A免疫阳性膨体纤维，出生后，随幼鼠的生长发育，相继在上皮，粘膜下层，纵肌层、肌间丛、粘膜下丛有NKA-IR表达，30天时已和成年鼠相似；2、在胃，首先于胚胎14天的肌间丛出现NKA-IR的表达，随发育相继在环肌、纵肌，粘膜下层、粘膜肌、固有膜及上皮内出现NKA-IR的表达，30天时具备成年鼠的分布特征；3、在小肠，分别于胚胎14、15、17天的十二指肠、空肠和回肠的肌间丛处出现NKA-IR的表达，随发育相继出现在纵肌、环肌、绒毛、小肠腺周、粘膜肌、粘膜下层、粘膜下丛、粘膜丛、深肌丛。

The elastic supporting forces are regarded as loads and act reversely on longitudinal beams, then the forces acting on longitudinal beams are calculated. Through structure selection, the large rectangular aqueduct bridge with high side beams should be adopted firstly. Because the side beams may reduce the middle beam loads, the span of aqueduct bridge can be increased.

通过结构形式的比较，指出具有大边梁的多纵梁矩形渡槽其侧墙兼做纵梁用，充分利用侧墙刚度大的特点，使横向挡水和纵向承重结合在一起，可以有效地减小水荷载对中纵梁的作用，从而增加渡槽的跨越能力，在大型渡槽的设计中应优先采用。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了