纤维

This paper introduced the swirl spinning process and the main components of machine,including combing roller,drafting device,fibers′ funneled transporting device,closed fibers-converging device and swirl twisting device.

介绍闭合式旋流纺的工艺流程及其主要机构，包括梳辊牵伸机构、渐缩式纤维输送机构、闭合式纤维集聚机构和旋流加捻器，并分析旋流纺关键机构——闭合式纤维集聚机构的设计。

As a result of a single copper paper products for it both coating is different: positive posive 20 grams (referred to as the coated surface), and reverse-engineered, posive only 1 gram (commonly known as uncoated surface) can be described as one side of a single copper-coated paper, the other side of the paper fibers, and fiber and coatings for water expansion coefficient of uniformity: fiber expands, and Coatings expands small.

由于单铜纸品的特殊要求，它两面的涂布量是不同的：正面涂20克左右，而反面只涂1克，可以说单铜纸的一面是涂料，另一面是纸纤维，而纤维和涂料对于水的膨胀系数不同：纤维的膨胀率大，而涂料的膨胀率小。

The adhesion properties of kevlar are studied with H pull method and bending fatigue rest of Kevlar reinforced rubber.The influences of synthesis,RFL ingredient,reaction time,and dipping process of the Kevlar fiber on static and dynamic adhesion properties the fiber reinforced rubber of are investigated.

采用H抽出法和橡胶弯曲疲劳试验法，考察了RF树脂的合成、RFL组成以及芳纶纤维浸渍工艺，研究了RFL组成及芳纶纤维浸渍工艺对纤维与橡胶的静态和动态粘合性能的影响。

A dipping-type hollow fiber membrane module (2) comprising a large number of hollow fiber membranes which have been bundled, is disposed within the dipping tank (1) so that the longitudinal direction of the hollow fiber membrane is a vertical direction.

在浸没容器(1)中布置有包括捆束起来的多个中空纤维膜的浸没式中空纤维膜组件(2)，使得中空纤维膜的纵向为竖直方向。

A fiber plastic tube with infiltration resistance membrane is dipped with composite resin to form a composite flexible tube, than the tube is turned inside out by hydraulic pressure and, as a lining, adhibited on inner wall of an old pipeline.

该技术采用有防渗透薄膜的纤维塑料软管，并经复合树脂充分浸渍形成纤维塑料复合软管，再通过水压将软管翻转并内衬在需修复的旧管道内壁，固化后形成一条坚固光滑的纤维塑料复合新管。

Complex surface structures stripes or bandings were found in those of A. dichotoma, but less in P. inclinatus. The trabeculae consisted of three parts the surface part, the cylindrical layer and the central part. The surface and the central part were mainly protein substances which could be dissolved by KOH.

其中心部主要是溶解于KOH溶液的物质蛋白一类的物质，环状纤维层中的几丁质纤维，在层和层之间相互不同的方向排列着，并各自与前翅的上下层中的几丁质纤维连续地连接着2独角仙前翅小柱的表面有复杂的纹样，而锹形虫的小柱表面只有非常简单的几乎没有纹样。

Curcumine could improve experimental hepatic fibrosis and down-regulated the expression of leptin and leptin receptor in liver, which probably contributed to one of the mechanisms about anti-fibrosis.

姜黄素能明显改善实验性大鼠肝纤维化，同时下调肝纤维化大鼠肝脏中瘦素以及瘦素受体的水平，这可能是姜黄素抗肝纤维化作用的机制之一。

Compared with the control, the lungs of 3-day-hyperxia-exposure group developed into edema, hemorrhage and inflammatory infiltration and this condition aggravated at the 7th day. The pulmonary septum was significantly widened at the 14th day, the interstitial fibrocytes as well as alveolar epithelial cells proliferated obviously, and the tendency of lung fibrosis was also presented. The results mentioned above showed that the modle of hyperoxia lung injury was successfully established, and the acute inflamationm was its early symptom while the fibrosis was its late manifistation. There was no positive cytes of IFN-γ in the lung of nomal rats, The positive cytes of the groups under hyperxia-exposure for 3, 7, 14 day, which climbed to the climax at the 7th day and began to decline from the 14th day, were found in alveolus epithlia,pulmonary interstitial, bronchoepithlia and macrophage.

高氧14天（5.46±0.30）虽有所下降，但同空气组比，差异仍然具有显著性（P.05）；BALF中蛋白含量高氧3天（0.45±0.10）、7天（0.66±0.08）、14天（0.79±0.14）显著高于空气组（0.18±0.08，P值均。05）；肺通透系数高氧3天（6.61±2.05）、7天（10.88±1.54）、14天（12.75±2.20）均明显高于空气组（2.99±1.27，P值均。05）；同时病理组织学改变也表明与空气组比较，高氧3天时肺组织水肿、出血、炎性细胞浸润，7天时进一步加重，14天时肺间隔明显增宽，间质纤维细胞和肺泡上皮细胞明显增生，出现肺纤维化倾向；以上结果均表明我们成功地建立了高氧肺损伤动物模型，且急性炎症反应是其早期表现，纤维化改变是其晚期表现。

Based on the Darcys law, the theoretical model of permeability measurement was established. And the influence of different testing methods and major process parameters such as fabric structure, fiber volume fraction, injection pressure, flow rate and resin viscosity on preform permeability were investigated in details. It was found that the permeability of fibrous reinforcement mainly lied on the preform architecture.

文中首先根据达西定律建立了渗透率测量的理论模型，深入研究了不同的测试方法及主要工艺参数(纤维织物织构、纤维体积含量、充模压力、流动速度、树脂粘度)对渗透特性的影响规律，发现多孔介质增强材料的渗透率主要取决于纤维织物的结构形式，预成型体孔隙分布及其体积分数、压实性对渗透率有较大的影响，提高充模压力和流动速度可以缩短充模时间，在一定程度上可以提高渗透率。

Secondly, we find pivotal factors of influence on fiber quality and the relation between different dentations' refining plates and fiber quality by experiment analysis and compare on fiber quality of same refining plate to different tree kinds and different refining plates to same tree kind.

其次，通过对同一磨片、不同树种和同一树种、不同磨片所加工出的纤维质量进行实验分析和比较，找到了影响纤维质量的关键因素和不同磨片齿型与纤维质量的关系。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。