纤维

Results The anterior bundle of ulnar collateral ligament originates from the inferior aspect of the medial epicondyle and inserts immediately adjacent to the joint surface on the ulna near the sublimis tubercle. The posterior bundle originates from the medial epicondyle slightly posterior to its most inferior portion and inserts broadly on the olecranon process. The lateral collateral ligament arises from the inferior aspect of the lateral epicondyle. Two types of conjoined lateral collateral and annular ligamentous insertions on the ulna were observed. Type Ⅰ(61.2％) was bilobate and type Ⅱ(38.8％) was a single broad conjoined type with insertion on the ulna. The anterior band of anterior bundle was more tighten than the posterior band as the elbow flexed less than 60°. When the elbow flexed over 60°, the two parts of anterior bundle were equally tightened. The posterior bundle was tightened as the elbow was flexed more than 90°. The lateral collateral ligament was tightened gradually as the elbow moved in flexion.

结果(1)尺侧副韧带前束起于肱骨内上髁的前下方，止于尺骨冠突内侧的小结节；后束起于肱骨内上髁的内下方，止于尺骨鹰嘴内侧的骨面；(2)桡侧副韧带起于肱骨外上髁的外下方，其纤维部分止于环状韧带，部分止于尺骨冠突的外下方；桡侧副韧带和桡骨环状韧带在尺骨上的止点有两种类型：Ⅰ型占61.2％，桡侧副韧带的部分纤维汇于环状韧带的尺骨止点，另一部分纤维单独止于稍远的尺骨上；Ⅱ型占38.8％，桡侧副韧带和环状韧带形成一宽的纤维止于尺骨上；(3)在肘关节屈曲60°以前，尺侧副韧带前束的外侧部紧张而内侧部较松弛，肘关节屈曲超过60°后，前束内外侧处于同程度的紧张状态；尺侧副韧带的后束在肘关节屈曲超过90°后才被拉紧；(4)桡侧副韧带在肘关节不同屈曲状态时其紧张度逐渐增加，当肘关节屈曲超过90°时，桡侧副韧带被明显拉长。

The object list is bright:( 1 ) Breakingfruit Chinkapin fibre's pH is lower , and it haw big Buffer capacity;( 2 ) Breakingfruit Chinkapin fibre has good permeability, When making MDF our should suitably enlarge Resin content;( 3 ) Along with compound than reducing of (Breakingfruit Chinkapin fiber / other wood fiber ), internal bond strength modulus of rupture, modulus of elasticity has trend that at first down than upward.

结果表明：（1）黎蒴栲材热磨纤维的pH值低，缓冲容量大；（2）黎蒴栲材纤维的渗透性良好，制造MDF时应适当加大施胶量；（3）随着复合比（黎蒴栲纤维/其他树种纤维）的减少，MDF的内结合强度、静曲强度、静曲弹性模量成先下降后上升的趋势。

The static and dynamic characteristics is better than the traditional cast- iron lathe bed. From the steel fiber polymer concrete's experiment material and the method of preparation the strengthen mechanism of steel fiber was studied with the mechanics principle in brief. This article uses the finite element method to simulate the lathe bed of machine tool, getting the natural f...

从钢纤维聚合物混凝土的实验材料和制备方法入手，利用力学原理简单研究了钢纤维的增强机理，并且利用有限元的方法，对机床的床身进行模拟，得到了不同截面尺寸的固有频率，通过同结构的钢纤维聚合物混凝土和铸铁床身进行谐响应分析，证明了钢纤维聚合物混凝土床身良好的动态性能。

The length distribution of sliver fiber under conditions of different feed plate gauge was tested by USTER AFIS and fiber length distribution in taker-in droppings and card strips was tested by cotton fiber length analyzer.

用USTER AFIS单纤维测试系统，对不同给棉板与刺辊隔距条件下的生条纤维长度分布进行检测，用罗拉式纤维长度测量仪对不同给棉板与刺辊隔距的刺辊落棉、盖板花中的纤维长度分布进行了检测。

Study on fiber length distribution of taker-in droppings and card strips;2. The length distribution of sliver fiber under conditions of different feed plate gauge was tested by USTER AFIS and fiber length distribution in taker-in droppings and card strips was tested by cotton fiber length analyzer.

用USTER AFIS单纤维测试系统，对不同给棉板与刺辊隔距条件下的生条纤维长度分布进行检测，用罗拉式纤维长度测量仪对不同给棉板与刺辊隔距的刺辊落棉、盖板花中的纤维长度分布进行了检测。

Biodegradable composites reinforced with bagasse fibre were prepared by a press forming,and the thermal properties of fibre and the flexural modulus of composites were investigated in view of the fibre content and length.

利用压制成型制备了甘蔗渣纤维增强可降解复合材料，分析了纤维的热分解性能，研究了纤维含有量和纤维长度对材料弯曲模量的影响，利用Cox剪滞法和材料的结构特点，探讨了一种新的修正模型对弯曲模量的预测。

The result showed that the strength of UHMWPE fibers decreased rapidly with the increase of the twist and increased largely after the adhesive-treatment of the UHMWPE fibers surface.

UHMWPE纤维的断裂强力随着纤维捻度的增加而下降；纤维表面漫胶处理后断裂强力提高，当UHMWPE纤维中改性氯丁胶或聚氨酯粘结剂的含量为6％时，其断裂强力增加17.2％或13.9％。

On the ground of comprehending the mechanism of fiber filtering and the characteristic of other fiber-filters,the characteristic and the function of long-fiber filtering was studied by the comparison between long-fiber filtering and sand filtering in this article.

在深入了解纤维束过滤机理和总结现有各种纤维束过滤器优缺点的基础上，通过长纤维过滤与传统石英砂过滤的对比试验，详细论述了长纤维过滤较之石英砂过滤的技术特点与性能优势。

This study was conducted to examiune the fibrotic effect of Ni-Ti and 317L al loys in esophagus.The extract fluid from Ni-Ti,317L alloys was made according t o the ASTM standards of U.S.A. The Fb of esophageal scar was cultured primarily ,then incubated with alloy abstract fluid. The proliferating activity of Fb was measured by MTT at 4, 24, 48, 72 hours in the course of culturing. The esophagu s embedding test of Ni-Ti,317L alloys was made according to ASTM standards of U .S.A.The tissue around the alloys was taken at weeks 2 and 12,and the pathologi c changes were analysed.

为探讨新型支架材料Ni-Ti、317L合金在食管局部的致纤维化作用，按美国ASTM标准制备NiTi、317L合金的金属浸提液；&组织块培养法&原代培养食管壁疤痕的成纤维细胞，传代后以金属浸提液进行培养，分组后分别培养4、24、48、72 h，MTT法检测不同培养时间后Fb增殖功能的变化；按美国ASTM标准进行NiTi、317L合金试件的食管壁内包埋实验，即将金属试件经表面处理后直接置入食管壁粘膜层与肌层之间，术后2、12周取出包埋组织，分析试件周围组织的病理变化，并进行胶原纤维染色，观察纤维形成状况。

On the basis of numeric results, the laws of how the mechanics of fiber and matrix, the volume fraction, aspect ratio and the orientation state of fiber react to the Yangs modulus, shear modulus, poisson modulus of short fiber reinforced composites are been investigated.

从数值上研究了纤维和基体的力学性能、纤维在复合材料中的体积百分数及其长径比、纤维取向状态对短纤维增强复合材料的杨氏模量、剪切模量、泊松比等力学性能的影响规律。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。