絮状物

The results indicate that the most of the tourmaline samples have the filling phenomenon, where the fillings are yellow and white flocculus, with the characteristics of the blue flash and flow structure. Meanwhile, the organics and Pb also could be found by the IR and XRF in the samples which have unnoticeable filling phenomenon.

结果表明，绝大多数碧玺样品都存在充填处理的现象，其内部充填物为黄色与白色絮状物，并具有蓝色闪光、流动构造等特征；其中，充填现象不明显的碧玺样品在红外吸收光谱仪和荧光能谱仪下也可检测到有机物及Pb。

with the hydroisomerization dewaxing process of shell company, apiⅱgroup and apiⅲgroup lube base oils were produced by taking vgo no.4 and dao from xinjiang karamay paraffin crude oil as raw materials after a series of lab tests and commercial trial production. the developed oils can meet the quality requirements of hviwh300 and vhvih90bs respectively. but all the haze points of the two products are about 16 ℃, and the floccus will appear in these oils with the time going by. the problem of haze point in high viscosity lube oil will still need to study continually.

采用壳牌公司以异构脱蜡催化剂为核心的全加氢工艺，对新疆克拉玛依石蜡基原油减四馏分油、轻脱油进行了实验室工艺研究，并经工业试生产，可以生产出apiⅱ、ⅲ类润滑油基础油，其主要产品性质可以分别满足中国石油hviwh300、vhvih90bs的质量要求，但这两种大粘度产品浊点达到16 ℃左右，室温下长期存储会出现絮状物，需要进一步研究解决。

SEM result showed that the sample had uniform phase distribution and smooth surface at dried state as well as interpenetrate network structure at hydrogel state. It was seen from the swell ing behavior curves that groups T1, T2 and T3 swelled rapidly within 10-30 minutes, and formed elastic composite hydrogel pipes. In addition, the expanding ratio of inner and outer diameter of the tube was 20%-30% and 100%-120% with swell ing, respectively. The equil ibrium water content of the hydrogel pipes increased with increase of collagen composition. Three groups of samples were immerged in PBS solution contained 2 mg/mL lysozyme at 37 for 1 month, their nozzle cracked, their wall became thin and more transparent. And also, there was small floc deposited on the tube surface.

扫描电镜观察到液氮脆断的人工泪小管内部成分分布均匀，内外壁表面平整，冷冻干燥的人工泪小管断口呈凝胶态的互穿网络结构。3 组不同成分的人工泪小管在PBS 溶液中浸泡30 min 后均快速吸水溶胀，外径扩大100%～ 120%，内径扩大20%～ 30%，并且随胶原含量增高，溶胀速度增快，平衡溶胀率增大。3 组人工泪小管在37℃含2 mg/mL 溶菌酶的PBS 液中浸泡1 个月后，表面有部分细小絮状物，管口开裂，管壁变薄，透明度增加。

Results: Arthroscopic examination showed that there were synovitis, debris and fibrillation in the joints of ADD with reduction; synovitis, synovial hyperplasia, debris, fibrillation, chondromalacia,fibrocartilage rupture and adhision in the joints of ADD without reduction.

76例84侧临床诊断为颞下颌关节盘前移位以及关节盘穿孔的病例进行颞下颌关节内窥镜检查。结果：可复性关节盘前移位的病例出现滑膜炎，关节腔内有絮状物，关节结节表面有纤维形成。

Results: Arthroscopic examination showed that there were synovitis, debris and fibrillation in the joints of ADD with reduction; synovitis, synovial hyperplasia, debris, fibrillation, chondromalacia,fibrocartilage rupture and adhision in the joints of ADD without reduction.

结果：可复性关节盘前移位的病例出现滑膜炎，关节腔内有絮状物，关节结节表面有纤维形成。不可复性关节结节表面纤维形成，关节软骨软化，软骨剥脱，同时伴有纤维粘连。

Depositing cells were incubated in high-sugar DMEM culture medium containing 15% fetal bovine serum, 100 U/mL penicillin, and 100 U/mL Streptomycin, then cells were seeded in a 25 T culture bottle after cell density was adjusted to 1×109 L-1, and incubated at 37 ℃, 0.05 volume fraction CO2 with saturated humidity. After 72 hours, the culture medium was replaced, and red blood cells and other nonadherent cells were removed. Cells began to passage at 70%-80% confluence.

实验方法：穿刺抽取15 mL脐带血，密度梯度法分离吸取分层界面的白色环形絮状物，其中富含单个核细胞，离心后沉积细胞用含15％胎牛血清、100 U/mL青霉素、100 U/mL链霉素的DMEM高糖培养基悬浮，调整细胞密度为1×109 L-1接种于25 T培养瓶内，放置在37 ℃、体积分数为0.05的CO2饱和湿度培养箱中培养，72 h后更换培养基，去除红细胞及其他未贴壁细胞，至70％~80％融合时传代。

Base upon the floccules formation in hydrotreated base oil (KH150BS) at low temperatures of Karamay Petrochemical Company,the carbon number distribution and composition of n-paraffins in the floc- cules were analyzed,their relative molecular weights were also measured,and the impact of floccules on the properties of hydrotreated base oil was investigated.

针对中国石油克拉玛依石化分公司150BS光亮油在低温下产生絮状物的情况，分析了絮状物中正构烷烃的碳数分布和组成，测定了絮状物的相对分子质量，考察了絮状物对150BS光亮油性能的影响。

Electron microscope observation showed that in group A the filter meshes and their fringes were clear and fragments of floccules could be seen occasionally. In group B the floccules scattered at fringes of the filter meshes and some meshes were obstructed by the floccules.

电子显微镜示A组网眼清晰，边缘清楚，偶见有块状过滤物，B组滤网有絮状物，散在分布于网眼边缘，模糊不清，堵塞网眼，表明有纤维蛋白聚集，血小板粘附，脱落形成血小板碎片。

Because of the effects of particle posterities and gas distributor, there is another particular axial distribution of cross-sectional averaged solids holdups, in which the averaged holdups increase first and then decreases along the riser height.

采用间隙指数定量描述了气固混合程度，结果表明整个提升管内没有形成很明显的絮状物，局部流动比较稳定；在相同Gs1.2/Gg2.0条件下，间隙指数在确定的提升管截面上有较为一致的径向分布规律。

Homogenisation with glass beads generated shear stresses due to the movement of both the glass beads and liquid relative to the floc.

单一化与玻璃珠产生的剪切讲由于运动都玻璃珠和液体相对向絮状物。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐