英语人>网络例句>紧压 相关的搜索结果
网络例句

紧压

与 紧压 相关的网络例句 [注:此内容来源于网络,仅供参考]

In the assembly of freight train wheels, bolts are assembled onto the axletree in-group with the bolt lid.

1引言铁路货车轮对的轴承采用的是组合螺栓端盖压紧结构,即采用三个紧固螺栓通过前端盖压紧轴承的内圈来紧固轴承。

If the small flats on the gauge do not fit over the crimped ring, the ring is undercrimped.

如果内卡规上轻微的平面无法适配压紧环,则这个环没有实现正确压紧。

Using LaGrange theorem on base of analyzing the elastic prop model tension system of band saw machine, the dynamics model of elastic prop tension system of band saw machine has been established and converted to mathematics model applying the modern control theory.

本文以MJ317型木工杠杆压砣张紧系统的带锯机改造成弹性挺杆张紧系统的带锯机为研究对象,通过对带锯机弹性挺杆式张紧系统的弹性动力学分析,运用拉格朗日定理建立了张紧系统的动力学模型,并应用现代控制理论将模型转换成数学模型。

This paper put forward and studied the technique of magnetic levitation based impacting and upending which can impact efficiently with the advantages of non-touch,non-concussion,high-reliability and low-cost.

研究了自动化检测设备辅机中的磁悬浮压紧扶正技术,实现非接触、无冲击、高可靠性、低成本的有效压紧,给出了3种可行原理和结构形式。

A motor vehicle gear-type transmission has an input shaft clutch, multiple gear pairs, multiple mesh units, and an input shaft clutch actuator which adjusts the position or pressure load of the pressure member of the input shaft clutch.

车辆用齿轮式变速机(50)是由输入轴离合器(7)、多个齿轮对(1、2、3、4、5、11、12、13、14、15)、多个啮合机构(21、22、23)和调整输入轴离合器(7)的压紧部件的位置或压紧负载的输入轴致动器(61)所构成。

The invention makes use of the wedged pressing mechanism above the fixed cutting tool to press tightly the flat steel of the steel grid plate to the blade along the direction of the tilted groove so as to eliminate the gap of the flat steel in the combined tool.

本发明在固定刀具上方用楔形压紧机构,沿斜槽方向将钢格板的扁钢往刀口方向压紧,从而消除了扁钢在组合刀具中的空隙。

After tightening up the limit screw,turn back for a half circle and tighten the nut.

长期使用填料若有磨损,只需将填料压盖的压紧螺母均匀紧至不漏即可。

In order to compose a containment system with two interfaces, it adopts measures such as adding piston rings, packing washers, subordinate hold-down bolts,'O' pattern rubber packing rings, fastener and subordinate terminal boxes.

主要采取了在传统密封装置结构上依次增加涨圈?压紧垫圈?次级压紧螺栓?O形橡胶密封圈?紧固件和次级接线盒等措施,共同组成二道面与面接触的密封系统?

In the joint of LG PEX-A Pipe ,male xocket is pressed to a convex on the inserting part and the fastening ring will contract to fasten up the heating pipe by the fastening of outer nut,and there is also a convex on the ring to offer close coupling by mechanical re-press effect to prevent water from leaking in case of heat expansion.

在LG地热管中的连接部位不仅阀门管套插入部分的凸起部位被机械作用压密,而且随着外部螺母被拧紧,使紧固环收缩,从而带紧热炕暖气管,另外由于存在凸起部位,可通过机械作用进行再次压密,因此可防止由于热膨胀而引起漏水。

Combined with water and then covered with fire stew, and pour out of steam, with a kitchen knife into filaments, bit by bit into the cage, and then pickled lumps of pressed wood, put it step by step, after the full release Sorghum followed by pole size of the cut-off into the mouth urn-shaped section, I urn on the top, coupled with a "pebble" pressed, the urn will be placed in the shade, add water daily, so that the leaves ferment inside the urn after the juice is leaking "Red Water" spillover.

然后再加水上盖用火焖,蒸熟后倒出来,用菜刀切成细丝,一点一点地放进笼中,再用木制的腌菜疙瘩压紧,一层一层放置,放足后用高粱杆跟着瓮口大小截成段状,放在瓮口,上面再加一块&鹅卵石&压紧,将瓮置于阴凉处,逐日加清水,使瓮内菜叶发酵后渗出原汁即&红水&外溢。

第5/25页 首页 < 1 2 3 4 5 6 7 8 9 ... > 尾页
推荐网络例句

I didn't watch TV last night, because it .

昨晚我没有看电视,因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。

I'm running my simile to an extreme.

我比喻得过头了。