系数问题

Regarding the open chain plane multibar performing mechanism as the object, this paper analyzes its establishing problem of dynamics equation from new degree, and this paper gives the new general formula to the similar velocity, similar angular velocity, inertial coefficient by turns.

文章以开式链平面连杆机构为对象，从新的角度探索分析其动力学方程的建立问题，文中依次对类速度、类角速度、惯性系数、广义力给出新的求解通式。最后用拉格朗日方程建立相应的动力学方程

It has been discussed that the value of improvement factor of part compressive strength, design value of compressive strength in part compressive strength calculation of masonry structure and the antiknock bearing capacity proven of the reinforced brick masonry;and some corresponding suggestions are presented.

就砌体结构局部受压计算中局部抗压强度提高系数、抗压强度设计值的取值及配筋砖砌体构件的截面抗震承载力验算等问题进行了分析，并提出了相应的建议，可供设计时参考。

Firstly, the isotropic difference templates were introduced to approximate the differential in the ADI-FDTD method, and the weighting coefficients of difference terms were determined for implementing isotropic numerical dispersion; Then the permittivity and permeability were adjusted manually to reduce the numerical dispersion error in any directions. Therefore the simulation accuracy and efficiency can be improved effectively for time domain problems with some finite bandwidths.

该方法在ADI-FDTD方法的差分近似微分中引入各向同性差分模板，并通过确定各向同性差分的加权系数来近似实现各向同性，然后人为修正空间的介质参数来减少各个方向上的数值色散误差，因此在模拟一定带宽的时域问题时可有效提高计算精度和计算效率。

In some practical problems, regression coefficients of this model are not arbitrary value, possibly they have certain restraint.

在一些实际问题中，模型的回归系数不能任意取值，可能有一定的约束。

The correction factor of normal stress graph area to rationalize reinforcement design is also studied.

通过对桂江巴江口水电站溢流坝弹性有限元计算成果的分析，指出部分结构仅根据主拉应力图形面积进行配筋存在的问题，并给出正应力图形面积的修正系数，使配筋结果更加合理。

It includes stability analysis and control of gyroscopic system, analog controller optimization, stability analysis of an active magnetic bearing rotor system based on a full-order or a reduced-order observer, and identification of dynamic coefficients of asymmetric system.

本文主要研究了主动磁轴承转子系统的稳定性、控制器设计和系统动特性参数辨识问题，包括陀螺效应对系统稳定性的影响和抑制方法；模拟控制器的设计和带全阶观测器的系统性能分析；对非对称结构系统动特性系数辨识的研究。

This thesis consists of two parts. The first one was that boundary value problem was discrete with five point difference method. Three kinds of memory formats were studied, which were full matrix, half band width and row compress sparse. Full matrix memory format and half band width memory format first was contrasted. The results show that half band width has efficiency in space. Then the algebraic system of finite element method was solved by Gauss-Seidel iteration method to popular row compress sparse memory format.

本论文由两部分组成，第1部分针对边值问题，用5点差分格式进行离散，并对离散矩阵这类大型稀疏矩阵，研究了系数矩阵的3种存储格式的优劣，即：满矩阵存储格式、半带宽存储格式和按行压缩稀疏存储格式，首先我们将满矩阵存储方式和半带宽存储格式进行了对比，迭代法的数值实验表明：利用半带宽存储的矩阵在空间运算方面具有高效性；然后针对目前数值实验中流行的按行压缩稀疏存储格式，实现了有限元离散代数系统的迭代法的求解。

In order to solve this problem, the paper presents a so - called Bi - watermarking Algorithm Based on Wavelet Packet and DCT transform.

针对这一问题，该文在结合小波包变换和离散余弦变换的同时，在图像小波包分解后的低频和高频部分选取适当系数分别嵌入同一个水印。

Accordingly, on the hypothetical condition that the material coefficients are the linear functions of tem perature and according to the theory of functional analysis, the authors use the method of combing the inner product form with convolution bilinear form, which leads to the functional of the quasistatic coupled thermo—viscoelasticity including the boundary and initial c...

因此，著者在物性系数是温度的线性函数的假设条件下，根据泛函分析理论，采用内积式与卷积双线性式相结合的方法，导出了包含所有边界条件，初始条件及热传导方程的拟静态耦合热粘弹性问题的泛函，并证明了与之相应的变分原理。

Demand coefficient method and binomial method for calculating calculated load of power equipment was compared by using an example.

通过需要系数法和二项式法对用电设备组的计算负荷进行计算后，指出两种方法的应用条件和应注意的问题，给出了一种新的补充算法。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。