精度

This method can largely improve the accuracy of alignment and repeatability.

这种方法很大程度上提高了拉伸试样的轴向对准精度和重复对准精度。

Based on the ARMAX model, a simple way of accuracy test is given with the residual errors and its zeros and poles.

采用ARMAX模型进行火控系统动态精度的简易测试，动态建模后经过残差检验、零极点分析等，为精度试验分析提供了一种简单方法

The 3D-curves were shown for different factors,root mean square errors of cross validation,and prediction residual sum of squares.Analysis results ...

实验结果表明：校正模型的预测精度在5 452~12 285 cm-1波段范围内，最佳主因子数为7时，雪青梨总酸的预测精度最好，其预测集的相关系数达到了0.79，预测标准偏差为

The measurement system error model analysis is introduced into power system real time network state analysis as an important part for the first time, which can improve on the state estimation quality and provide the capability to monitor the operation of the measurement system; 2. The theory and algorithm of the on-line estimation and update of measurement noise variance based on the relation between the residual variance and noise variance. The statistic properties of the sample variance are discussed and the relation between the estimation precision and sample size under given confidence level is derived; 3. The theory and algorithm of detection and identification of measurement bias are presented, which is based on the relation between residual mean and noise mean. The statistic properties of sample mean are discussed and the relation between estimation precision and sample size is derived; 4. The Givens orthogonal transformation algorithm is selected to be the essential algorithm of state estimation, the fast orthogonal transformation algorithm with damp factor and the algorithm which can handle the zero injection measurements efficiently are presented; 5. The quantity analysis theory of bad data detectivity and identifibility are presented, which describes the relation between the elements in matrix W〓 and bad data amplitude and can provide the theory base for measurement system design and valuation.

一、首次将量测系统误差模型分析做为一个环节引入电力系统实时网络状态分析中，为EMS系统增加了实时监视系统运行、修正量测系统误差模型的新功能，进一步发挥了实时网络状态分析应用软件的潜力；二、首次提出了应用样本方差在线估计与修正量测系统误差方差的基本理论，讨论了样本方差的统计性质和概率分布，推导出了样本容量、估计精度和置信度之间的关系，给出了在线估计与修正量测系统误差方差的算法；三、首次提出了应用样本均值在线检测与辨识量测偏差的基本理论，讨论了样本均值的统计性质，推导了样本容量、估计精度和置信度之间的基本关系，给出了在线检测与辨识量测偏差的算法；四、在状态估计算法设计中，以Givens变换算法做为基本算法，提出了快速正交变换阻尼因子法和可以有效地处理零注入量测的混合法，并对实时应用中的一些问题进行了讨论；五、提出了不良数据可检测性与可辨识性的定量分析理论，揭示了描述量测系统配置、网络结构与参数的残差灵敏度矩阵中的元素与不良数据的幅值在可检测、可辨识能力上的定量关系，为量测系统配置设计与评价提供了理论基础；六、综合国内外最新研究成果，采用自适应自回归预测技术和稀疏矢量技术，构造了较完善的不良数据检测与辨识算法。

Through the interferencing light intensity under a sine-wave modulation signal analysis, the output signal of fiber-optic gyroscope is demodulated. And then the change of the output signal of gyro is gotten. Through the analysis of the change we know that the effect of residuary intensity modulation on the performance of Interferometric Fiber Optic Gyroscope is related with the precision and accuracy requirements of IFOG. The higher precision, the more obvious effect.

本文首先通过正弦波调制下干涉信号光强分析解调出光纤陀螺的输出信号，进而得出残余强度调制存在的情况下陀螺输出信号的变化情况，同时，通过分析陀螺信号的变化说明残余强度调制对光纤陀螺性能的影响与陀螺精度要求有关，精度越高，其影响越明显。

It have high accuracy and precision of retention.

有很高的精度和精度保持性。

So it can be avoided that the computation accuracy is lowered and the calculation result is hard to be convergent for the odd state of transformation matrix.The computation accuracy of wavelet Ritz method and wavelet Galerkin method has been improved so the special'microscopic'property could be fully expressed. An effective method is offered also to solve the problem of high stress gradient and some other odd state problems in engineering.

从而避免了由于转换矩阵奇异而造成精度下降且计算结果不易收敛的问题，提升了小波Ritz法和小波Galerkin法的求解精度，使小波分析的"显微"特性得以充分发挥，并为应力大梯度问题和工程奇异问题的有效求解提供了强有力的计算手段。

To obtain the relationship between rotary dynamic target axis shake and its precision,rotating vector and coordinate transfer are used to analyze axis shake′s influence to target′s high and low angle and azimuth angle,and then to analyze its error.

旋转动态靶标是用来检测大型光电经纬仪跟踪精度和动态精度的设备。

The result shows that for scintillator TOF detector, its intrinsic time resolution is about 80ps, but the influence of all other factors is only 50～60ps.

在第一章中，我们分析了飞行时间测量精度的影响因素，结果表明，TOF探测器的本征时间分辨率是影响TOF测量精度的主要因素。

Accurate measurements of an intense high-energy proton beam are generally disturbed by high energy proton induced secondary electron emission.

高能质子入射到金属接收体表面诱发的二次电子直接影响束流强度的测量精度，如何消除二次电子影响是实现束流高精度测量的关键。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。