粘结的

In the calculation of inclination anchor rod, the bond strength between soil formation and anchor rod given in the specifications is the once normal pressure data.

在土层倾斜锚杆计算时，规范中给出的土层与锚杆间的粘结强度采用的是一次常压灌浆测定的数据，当采用二次劈裂注浆施工工艺时，理论计算与实测数据会存在较大的差异。

The critical heating rate for different body radius was predicted by comparing the gas pressure when the peak degradation rate occurred with the threshold body strength which was determined by the diametric compression test of the green body during thermal debindering.

摘 要：以聚乙烯醇和NiFe2O4/Ni型金属陶瓷压坯为对象，采用热重分析研究PVA在N2气氛中的热脱脂行为，建立PVA热脱脂速率的数学模型，在此基础上，模拟并计算PVA分解产物气体在多孔粉末压坯内的压力构建情况；结合粉末压坯脱脂强度测试结果，分析粉末压坯在脱脂过程中压坯尺寸、粘结剂含量等因素对升温速率和脱脂时间的影响，获得不同半径尺寸压坯的极限升温速率。

The technological processes for preparing the electrode nipple pin including the selection of the raw materials, formulation ratio, additive and foamer were determined. The results showed that the electrode nipple pin prepared exhibits high binding effect,which reached the object.

确定了电极接头栓的原料选择、原料配比、添加剂和发泡剂的选取；确定了电极接头栓的生产技术要求和生产工艺流程；试验证明了研制的高性能接头栓具有高粘结、强固结、有效补强的作用。

The glassiness barrier layer mixes glass dust and mill addition into slip glaze, 50-180 um barrier layer is prepared by painting slip glaze on the surface of stainless steel, components of the glass dust according to the percent by weight comprises SiO2 37-40, B2O3 11-14, one or two kinds of Na2O and K2O18-20, one or two kinds of BaO and SrO 3.5-6.5, one or two kinds of Al2O3 and Cr2O3 2.5-10.5, one or two kinds of residues such as CaO, CaF and Na3AlF6, and the mill addition comprises agglomerants such as kaolin, borax, sodium nitrite and the like, adhesive agents such as CMC, PVA and the like and water.

该玻璃质壁垒层是将玻璃粉和磨加物混合成釉浆，涂在不锈钢表面制备50-180μm涂层，玻璃粉的成分按重量百分比：37-40 SiO 2 ，11-14 B 2 O 3 ，18-20 Na 2 O、K 2 O中的一种或两种，3.5-6.5 BaO、SrO中的一种或两种，2.5-10.5 Al 2 O 3 、Cr 2 O 3 中的一种或两种，余量CaO、CaF、Na 3 AlF 6 中的一种或多种；磨加物包括高岭土、硼砂、亚硝酸钠等粘结剂、CMC、PVA等密着剂和水。

The surface on the steel bridge is easy to damage early than estimate years.The distress types in steel bridge surfacings include permanent deformation,cracking,formation of mounds and disintegration.The text analyses the vertical section strain under tire location by use of the finite element method and calculates the influence of stiffness variance of translate bonding layer on the surfacings of steel bridges.

中文摘要：钢桥面沥青铺装层在使用一段时间后容易出现开裂、脱层以及车辙等早期破坏现象，采用空间有限元分析方法对车轮荷载位置处的截面竖向应变进行分析，计算了过渡粘结层刚度变化时对钢桥面铺装层受力变化的影响，计算结果说明对传统的弹性层状计算理论的假定与实际受力情况存在较大差异。

A layer of strip steel was found abrasion-welded to the surface of the spalled fragment and a 0.06mm thin layer of untempered martensitic structure was observed on the surface of the roll just beneath the welded strip.

在剥落块的表面上粘结着带钢，在带钢下的轧辊表面上观察到一层厚度约0.06mm未经回火的马氏体组织，此层下面还有一个具有低硬度的回火马氏体区域，晶间显微裂纹就从此两区域之间发生，然后垂直地向里向外扩展。

When new concrete with higher strength grade is cast, the higher the roughness of old concrete fracture surface is, the higher the interfacial bond strength of old-new concrete is.

结果发现：用分数维来表征老混凝土表面的粗糙度，其预测结果精度较高；在粗糙度较高的老混凝土表面上浇注较高强度的新混凝土，获得的新－老混凝土界面粘结强度较高。

The results of phase composition and electron probe microscope analysis show that the WMo composite can be treated as ...

对样品的相组成分析及电子探针分析的结果表明，W Mo系复合材料主要是以W、Mo机械混合的形式通过粘结相获得致密化的。

M is, the higher the strength will be, as well as more even particle distribution. The mechanism of additives as discussed revealed that on the surface of Al_3 particles the oleophilic group of surface active agent will form oil films to bind together fine Al_3 particles closely so as to increase both the particle size and strength.

结果表明，氢氧化铝颗粒在 45～105μm的个数百分数越大，氢氧化铝颗粒分布越均匀，强度就越好；探讨了添加剂的作用机理，即表面活性剂分子的亲油基在氢氧化铝粒子表面形成油层，将氢氧化铝细粒子紧密粘结在一起，使氢氧化铝的粒度与强度增大。

Three composites of the different fibers with epoxy resin matrix are prepared and the corresponding unilateral fiber reinforced winding ring specimens are fabricated. The mechanical poperties of the composites including tensile strength, modulus and three point interlaminar shear strength are te...

对由PBO纤维与环氧树脂基体复合成型的单向纤维增强环形试样，测试了其拉伸强度、弹性模量和层间剪切强度，结果表明：PBO纤维股纱的拉伸强度比F - 12和Kevlar - 4 9分别高 2 4 4 %和 5 2 8%以上，单向纤维复合材料的拉伸强度分别高约 37 2 %和 92 8%，耐热性也高约 166℃，但PBO纤维与环氧树脂基体的界面粘结性很差，层间剪切强度仅为 2 3～ 2 7MPa 。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐