粘结的

It is shown that the hydrolysis or alcoholysis of nylon 66 is restrained and the compatibility on interface between nylon 66 and glass fiber is improved on certain extent by the addition of compound hydrolyzing modifier.

结果表明，复合耐水解改性剂的加入抑制了PA66的水解作用，并在一定程度上改善了PA66基体与玻纤相界面的粘结程度。

The bond behavior between FRP sheet with FRP shear key and concrete was studied by experiment on a single shear test setup. Test invariables including the height, the width and the length of shear key, appending coarse-sand-coating and concrete compressive strength were considered.

采用FRP板－混凝土块搭接接头的单剪试验方法，考虑剪力键高度、宽度和长度、附加砂粒增强以及混凝土强度等因素，对带剪力键的FRP板与混凝土间粘结性能进行了深入研究。

The equipment and technology of the high-power twice atomizing arc spray in steel bridge anti-corrosion is investigated,owing to the shorter service life-span,the more frequency maintenance and the higher maintenance expense for steel bridge tar-paved layer.

设计拉法尔一次和扁平扇形二次喷嘴的二次电弧喷涂设备，采用无尘自动喷砂、电弧喷锌和喷涂粘结型封闭剂工艺的防腐蚀工艺技术，制造自动喷涂施工工装对钢桥面进行长效防腐蚀施工，为提高路面铺装层使用寿命提供保障

Moreover, a detailed analysis of their differences is carried out, compared to the bond-slip relationship between concrete and steel bar.

同时对比钢筋与普通混凝土之间的粘结滑移关系，较详细地分析了它们之间的差异。

Silicate cotton in injection process to join the international universal binder, after curing room hot air through stereotypes, computer controlled cut-type silicate sheet.

概要说明：硅酸铝棉在喷吹过程中加入国际通用的粘结剂，经固化室热风穿透定型，电子计算机控制切割成型的硅酸铝板材。

The key of prime coat is penetration. The key of seal coat is binding.

透层的关键是透，封层的关键是粘结。

Distributed water pressure can restrain the deformation of cement surface, helpful to increase the adhesion between bolt and cement and decrease the influence depth of axial stress of bolt, also helpful to strengthen the safety of bolt.

5分布水压力能约束混凝土表面的变形，从而有助于增加锚杆与混凝土的粘结强度，减小锚杆传力深度，增加工程安全性。

Far from a dyed-in-the-wool binder, Helline's business experience lay, to that point, outside the graphic arts industry.

远东从一个彻头彻尾的羊毛粘结剂， Helline的商业经验，奠定基础，这一点，国外印刷业。

A company in Carson City, Nevada specializes in mechanical fasteners such as studs, nut plates, and cable ties that are adhered to surfaces that cannot be drilled through using two part acrylic adhesives.

在美国内华达州的卡逊城有一家公司，专业从事机械部件的固定连接，比如灯饰，钢化玻璃，电缆，这些部件要固定，不能通过钻孔固定的方式，而是通过双组分丙烯酸胶水粘结固定。

Further considering the characteristic of microcosmic mechanics around the press area, the reason of 'gnawing solder' causing the jam is studied based on the model of Kulun friction.

从库仑摩擦模型入手，考虑粘结点的微观力学特性，进一步研究了可能引起机构卡死的&咬焊&原因。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。