粘结的

A simplified 1/8 model,considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes,was developed.

这里研究了简化的1/8模型，模型考虑了二氧化硅和氮化硅生成过程及堆阳极键合和胶粘结合过程。

By controlling FeO and quicklime content, and improving the permeability and oxidation atmosphere of the sinter bed, the sinters with calcium ferrite as main binding phase can be produced.

采用控制混合料中氧化亚铁含量进行配矿，保证生石灰用量，改善料层透气性和氧化性气氛等措施，可以获得以铁酸钙为主要粘结相的烧结矿。

During wear process, not only chemical and mechanical change such as oxidating and breaking etc. take place in debris, but also metallurgical course such as adhesing especially hot press sintering at small areas in debris because of hot extruding.

磨损过程中磨屑不仅存在氧化、碎化等化学、机械过程，还存在因相互挤压、粘结甚至微区热压烧结等冶金过程，两方面的共同作用，使氧化物磨屑成分均匀化。

The optimum conditions for preparing CMS from walnut shell are: carbonization temperature 700—900℃, holding time 30min, heating rate 10℃/min; heat treatment (2nd carbonization) temperature 700—800℃, holding time 30min, heating rate 10℃/min; coal tar binder ratio 27—35wt%.

由核桃壳制炭分子筛的主要工艺条件为：一次炭化温度700—900℃，加热速率10℃／min，恒温时间30min；二次炭化温度700—800℃，加热速率10℃／min，恒温时间30min；粘结剂煤焦油配比27—35wt％。

This product is a two-component reactive adhesives,This product has good high and low temperature properties, bonding strength and anti-aging properties.

本产品为双组份反应型粘合剂，本产品具有良好的高低温性能、粘结强度和耐老化性能。

We currently use a two-coat adhesive system for the brass inserts.

2|我们通常对黄铜螺母使用双涂层的粘结系统。

Test invariables including the height,the width and the length of shear key,appending coarse-sand-coating and concrete compressive strength were considered.

结果剪力键长度、附加砂粒增强和混凝土强度等因素对FRP板与混凝土间平均粘结强度有显著影响，而剪力键高度和宽度的变化影响较小。

An advise is proposed that the amount of shear steel bars can be less when steel fiber is mixed in such joints in order to make construction easy.

因此，在设计中，当在无粘结部分预应力扁梁柱节点中掺入钢纤维时，可以减少节点核心区剪力筋的配量，以方便施工。

It is conceivable that such as so thick small books is made into a wireless set is perfect-bound, as a result, you cannot go back and read a; b, anterior, and quite out of the round-bellied become down grilled; c, a-z of look and feel of the anamorphotic; d, and fell off the page folded edge book block fracture; E, knot cannot shorten the book bridgeis havemany life, unable to retain.

笔者不否认无线胶粘订有许多好处，如出书快、周期短，适合现代节奏，且省工省料成本低等；但这种加工方法也有许多不足之处，如①树脂胶枯剂易老化、不易长期保存；②厚书不易翻阅且变型：③粘结不牢，易掉页、断裂等，成为书籍装订质量问题最多的一种装法。

The process for preparing the electrode nipple pin with high binding property, low specific resistance was introduced.

研制了高粘结强度、低电阻率、高渗透性能接头栓，并说明了改进的目标和方向。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。